Specifications and Main Features
- Model Number: AD-170SE
- Electrical Requirements: 208 to 460V volts, 3-Phase, 50/60 hertz
- Drive Motor: 1HP
- Maximum Steam Pressure: 125 PSI
- Temperature Control: Automatic Reset Thermostat, Hi-Limit Thermostat ( 290F for Electric Models and 330F For gas models).
- Fuel Options: Natural Gas and LPG
- Basket Assembly: Four ribs and perforated panels mounted on tie rods
- Control Types: Microprocessor Controls and Non Microprocessor Controls
- Safety Features: Main Door Switch, Lint Drawer Switch, and Sail Switch, available on Gas Models ONLY
- Maintenance: Inspect and clean lint systems, no lubrication needed on motor bearings
- Air Supply Requirement: 2.5 cfm @ 80 PSI
- Diagnostic Feature: LED display with operational codes
Frequently Asked Questions
- Q: What type of gas does the AD-170SE dryer require?
A: According to the dryer data label, it can work with LPG and Natural Gas, therefore it is ideal for this dryer.
- Q: The dryer does not start, what is to be done?
A: When this happens, there is a need to check all open circuits, door and lint drawer switches, even the circuit breakers and fuses might be faulty.
- Q: How frequently do I require to clean the lint drawer?
A: Lint drawers should be cleaned on every third or fourth load in order to increase performance efficiency.
- Q: Is it okay to dry the unsolvent washed fabrics in the dryer?
A: Not at all, any fabrics that have not been in contact with water should not be dried, while fabrics that are not water-washed should not be dried as that will be a fire load.
- Q: What is the maximum amount of steam pressure allowed for the dryer?
A: It is prohibited to use the dryer if the steam pressure is above 125 PSI.
- Q: How do I reset the automatic reset thermostat?
A: The air temperature cools off after a predetermined level which causes the thermostat to turn itself on, there is no need to manually reset it.
User Manual
Loading...