Specifications and Main Features
- Serial numbers: AD-115 / AD-120.
- Control System: – Electronic unit of phase 5 microprocessor timer control.
- Weight: 3/4 Horsepower for drive motor.
- Voltage: The voltage range is from 208V to 460V at 50/60Hz and the system is three phase.
- Gas Input Ratings:
- Natural Gas: 3.5 to 4 Inches Water Column.
- L.P. Gas: 10.5 to 11 Inches Water Column.
- Safety Features:
- Main Door Switch.
- Lint Drawer Switch.
- Hi-Limit Thermostat – Set at 330F for gas, 290F for electricity.
- Automatic Reset Thermostat.
- Components Include:
- Drive Motor.
- Blower Motor – 3 HP.
- Gas burner assembly.
- DSI Module (gas models only).
- Sail Switch (gas and electric models).
- Lint drawer.
- Steam damper system.
- Maintenance:
- Daily cleaning of the lint drawer/screen by removing all lint accumulated.
- Weekly surfacing and checking accumulated lint in different locations.
- Monthly and semi annual to annual replacement are suggested.
Frequently Asked Questions
Q: Which fabrics can be dried in the AD-115 / AD-120 dryer?
A: The dryer should be used with only water washed fabrics. Items dry cleaned affection, flammable contaminated, altogether dry cleaning solvents or those contaminated with any combustible materials should not be dried.
Q: Can you talk to me about the steps I should take if I smell gas while using the dryer?
A: The local gas supplier must be contacted immediately and instructions on what to do next should be put in a conspicuous place.
Q: In your opinion, how many times should one clean the lint drawer?
A: It is advisable to wash the lint drawer or screen after every third or fourth cycle of doing the laundry.
Q: Could you tell me the details regarding the voltage requirements for the dryer?
A: The required voltage to operate the dryer is within the range of 208 and 460 with the frequency rate of 50 or 60 HZ and lastly it’s a 3 phase equipment.
Q: Please can you tell me what other safety features have been incorporated in the dryer?
A: A safety device that consists of a door main switch, lint drawer switch, hi-limit thermostat, and an automatic reset thermostat is built in to the appliance to avoid overheating and or accident during its use.
Q: What procedure should be followed to start the dryer?
A: To start the dryer, switch on the power source then press the ‘E’ touch pad that’s located on the microprocessor controlling device and the dryer will start and the screen will display ‘dr30.’
User Manual
Loading...