American DJ S-150-DMX User Manual

SPECIFICATIONS: MODEL - S-150/DMX

Weight: 9lbs.

Size: 3.25” x 9.25” x 9.5”

Lamp: ZB-150 - (BT 200H)

Fuse: 10A Internal

Supply Voltage: 120V

Working Position: Any Safe position

Duty Cycle: 5 min. ON/ 5 min. OFF

S-150/DMX

™

American DJ

®

User Instructions

Affordable Quality Lighting Products from American DJ® Los Angeles, CA. 90058

CAUTION! Read instructions before installing or plugging unit in.

CONTROLS & FUNCTIONS (REAR):

1. POWER INPUT: AC 120V-60Hz, 10A

2. FUSE: F10A 250V

3. POWER SWITCH: Press down to turn the power on.

4. POWER INDICATOR: Indicates when power is on.

5. DMX DIP SWITCH: Assign dip switch 10 to ON, this

unit is in DMX pack mode. Follow DMX addressing
printed on the rear for desired speed and dimming
settings. Assign dip switch 10 to OFF, this unit is in
self-test mode, follow self-test settings to select desired chase.

6. DMX INDICATOR: Indicates when DMX is effective.

7. DMX SIGNAL INPUT: XLR male socket, use to receive DMX signals.

8. DMX SIGNAL OUTPUT: XLR female socket, use to connect another S-150/DMX.

OPERATING INSTRUCTIONS:

1. Please confirm power input is matched with that specified on this unit.

2. Plug in power cord and turn the power on.

3. This unit has two operating modesL self-test mode and DMX pack mode.

4. Switch dip switch 10 to OFF position, this unit is in self-test mode. There are two self-test modes: AUTO and MANUAL.
Set dip switch 9 to OFF, it performs AUTO self-test. When strobe flashes within the dimming range from 0 to 100% and
then from 100 to 0%, a slower or faster speed will be executed. This strobe will flash with the regular speed correspon­ding to the variety of the duration of dimmer. Set dip switch 9 to ON, it performs MANUAL self-test. Dip switch 1, 2, 3
and 4 are assigned to control speed, and dip switch 5, 6, 7,and 8 are assigned to adjust dimming level.

5. Switch dip switch 10 to ON position, this unit is in DMX pack mode. Follow DMX address settings printed on the rear
for desired flash speed and dimmer.

6. For safety, disconnect power cable when not in use.

150 WATT High Power Professional Strobe Light

Congratulations on your purchase of this high quality American DJ® product. For your
convenience the S-150/DMX has been lamped and is ready to be used. Please read the
following instructions before installing or using your new S-150/DMX. Thank you for pur­chasing the S-150/DMX by American DJ

®.

2

1

3 4 5 6 7 8

APPENDIX

1. In DMX pack mode, please refer to the following illustrations for desired
channel setting.

2. In self-test mode, please follow the below table for desired chase:

3. In MANUAL of self-test mode, speed and dimmer are classified as 16 levels

respectively, and are as follows: