American DJ S-1500-DMX User Manual

™

1500W DMX Strobe Light

S-1500/DMX

American DJ

Instruction Manual

SPECIFICATIONS: MODEL -

S-1500/DMX™ Weight: 9 lbs. Size: 16.5" x 8.75" x 4.75" Lamp: ZB-1500 Voltage: 220V/50Hz Working Position: Any Safe position Fuse: 16A Circuit breaker Power Draw: 1500W Connection: XLR Flash Rate: 15 flashes per second flash Tube Life: 500,000 Flashes

Affordable Quality Lighting Products from American DJ ® Los Angeles, CA 90058 USA

CAUTION! Read instructions before installing or plugging unit in.

Thank you for purchasing the S-1500/DMX!

Here are a few tips before getting started.

General Functions (REAR):

A. POWER INPUT: AC 220V/50Hz, 16A B. CIRCUIT BREAKER: 16A C. POWER INDICATOR: Lights when power is ON D. DMX DIP SWITCH SETTINGS: By assigning dip

switch 10 to ON, unit goes to “DMX Pack Mode”. Follow DMX addressing printed on the rear of this Instruction Manual for desired speed and dimming settings. By assigning dip switch 10 to OFF,

unit goes to “DMX Self-test Mode”. Follow “Self-test” settings printed on rear to select desired chase. E. DMX INDICATOR: Indicates when DMX is effective. F. DMX SIGNAL OUTPUT: XLR female socket used to connect to next DMX fixture. G. DMX SIGNAL INPUT: XLR male socket used to receive DMX signals.

Operating Instructions:

1. Unit is ready to be hung or set on flat surface. We suggest the use of safety cable (not provided) when hanging

unit. The S-1500 /DMX plugs direct into 220V. Make sure power configuration is correct.

2. Plug in power cord to turn unit ON.

3. This unit has two operation modes: “DMX Self-test Mode” and “DMX Pack Mode”.

4. Switch dip switch 10 to the OFF position, the unit goes to “DMX Pack Mode”. There are 2 “Self-test” modes:

AUTO and MANUAL. Set dip switch 9 to OFF, it performs “AUTO Self-test”. When strobe flashes within the

dimming range from 0% to 100% and then from 100% to 0%, a slower or faster speed will be executed.

The strobe will flash at regular speed corresponding to the dimmer duration. Set dip switch 9 to ON, it will then

S-1500/DMX Instructions p.2

Operating Instructions (Cont.):

enter “MANUAL Self-test”. Dip switch 1, 2, 3, and 4 may assigned to control Speed (1 = slowest, 4 = fastest).

Dip switch 5, 6, 7 and 8 may be assigned to control dimming (5 = dimmest, 8 = brightest).

5. Switch dip switch 10 to the ON position, unit goes to “DMX Pack Mode”. Follow “DMX Pack Mode” address

settings below for desired speed and dimming.

6. For safety disconnect power cable when not in use.

WARNING:

• Avoid direct eye exposure.

• Disconnect from main power before replacing lamps or servicing unit.

• Always with same lamp and fuse.

• To prevent fire or shock hazard, do not expose unit to rain or moisture.

DIP SWITCH SETTINGS:

“DMX PACK MODE”

“SELF-TEST MODE”

“MANUAL SELF-TEST MODE”

Speed and dimming are classified as 16 levels respectively.

SPEED

DIMMING

DO NOT OPERATE CONTINUOUSLY ON

MAXIMUM SPEED FOR MORE THAN

15 MINUTES!

Maintenance:

Caution! Never open unit when in use. Always disconnect main power before serving or replacing lamp. Wait 30 minutes before changing the lamp. Remember always replace same lamp and fuses. There are no

serviceable parts!

Lamp replacement:

Disconnect power. Remove the front cover and replace lamp with model ZB-1500. Do not touch new lamp with bare hands. Use a clean cloth when handling lamp. This will ensure long life of lamp.

Service:

For service, please call your American DJ® dealer. Make sure you send in your warranty card!