American DJ Rainbow 250 User Instructions
User Instructions
American DJ
4295 Charter Street
Los Angeles Ca. 90058
www.americandj.com
Introduction:
Thank you for purchasing the Rainbow 250™ color changer from American DJ® . To optimize the performance of this product, please read these operating instructions carefully and familiarize yourself with
the basic operations of this unit. The American DJ® Rainbow 250,™ is a dual channel, DMX, intelligent
color changer. This unit has been shipped with a lamp installed and tested at the factory before being
shipped to you. There is no assembly required.
The American DJ
® Rainbow 250™ has sound active capabilities so you can use this unit without a
controller. This unit can also be controlled via a standard DMX controller such as the American DJ Show
Designer,™ or the American DJ® DMX Operator,™ giving the user independent control over the color
wheel and dimmer.
Customer Support:
American DJ® provides a toll free customer support line, to provide set up and installation help and to
answer any question should you encounter problems during your set up or initial operation. You may
also visit us on the web at www.americandj.com for any comments or suggestions. Toll free customer
service hours are Monday through Friday 9:00 a.m. to 5:00 p.m. Pacifi c Standard Time.
Voice: (800) 322-6337
Fax: (323) 582-2610
E-mail: support@americandj.com
Set Up:
Power Supply:
Before plugging your unit in, be sure the source voltage in your area matches the required voltage for
your American DJ® Rainbow 250.™ The American DJ® Rainbow 250™ is available in a 120v and 220v
version. Because line voltage may vary from venue to venue, you should be sure to plug your power
supply into a matching wall outlet before attempting to operate you controller.
Data Cable (DMX Cable) Requirements:
Your fi xture and your controller require a standard 3-pin XLR connector for data
input and data output (Figure 1). If you are making your own cables, be sure to use
standard two conductor shielded cable (This cable may be purchased at almost all
pro sound and lighting stores). Your cables should be made with a male and female
XLR connector on either end of the cable. Also remember that DMX cable must be
daisy chained and can not be “Y”ed or split.
Notice: Be sure to follow fi gure three when making your own cables. Do not use the ground lug on
the XLR connector. Do not connect the cable’s shield conductor to the ground lug or allow the shield
conductor to come in contact with the XLR’s outer casing. Grounding the shield could cause a short
circuit and erratic behavior.
XLR Female Socket
2 Cold
1 Ground
3 Hot
XLR Pin Confi guration
Pin 1 = Ground
Pin 2 = Data Compliment (negative)
Pin 3 = Data True (positive)
Figure 2
XLR Male Socket
1 Ground
2 Cold
3 Hot
Figure 1
© American DJ Supply - Los Angeles Ca. 90058 - www.americandj.com Rainbow 250™ Page 2
Loading...