American DJ Mini Starball User Instructions

Revised 5/01

Los Angeles Ca. 90058

www.americandj.com

4295 Charter Street

American DJ®

User Instructions

MINI STARBALL

American DJ®

cian. Use of a different type fuse from that which is recommended may

cause fire or electric shock and will void the manufactures warranty.

otherwise instructed by an authorized American DJ

©American DJ Supply® - www.americandj.com - MINI Starball™ Instruction Manual Page 2

Safety Issues: This unit may blow a fuse if the maximum allotted

load of 2 amps is reached. If the fuse needs replacement, always

replace the fuse with same exact type that was remove, unless

PLEASE do not discard the shipping carton in the trash. Please

recycle when ever possible.

attempt any repairs yourself, doing so will void your manufactures war-

ranty. In the unlikely event your unit may require service please contact

your nearest American DJ dealer.

Caution! There are no user serviceable parts inside this unit. Do not

not expose this unit to rain or moisture.

Warning! To prevent or reduce the risk of electrical shock or ﬁ re, do

Fax: (323) 582-2610

E-mail: support@americandj.com

related issue please contact American DJ®. Service Hours are Monday

through Friday 9:00 a.m. to 5:00 p.m. Paciﬁ c Standard Time.

Voice: (800) 322-6337

up help and to answer any question should you encounter problems

during your set up or initial operation. You may also visit us on the web

at www.americandj.com for any comments or suggestions. For service

American DJ® provides a toll free customer support line, to provide set

return the unit to your dealer without ﬁ rst contacting customer support.

Customer Support:

™

Unpacking:

Thank you for purchasing the MINI Starball™ by American DJ®. Every

MINI Starball™ has been thoroughly tested and has been shipped

in perfect operating condition. Carefully check the shipping carton for

damage that may have occurred during shipping. If the carton appears

to be damaged, carefully inspect your unit for any damage and be sure

all equipment necessary to operate the system has arrived intact. In the

event damage has been found or parts are missing, please contact our

toll free customer support number for further instructions. Please do not

MINI Starball™ Introduction

® service techni-

©American DJ Supply® - www.americandj.com - MINI Starball™ Instruction Manual Page 3

marked change in performance.

• Always mount this unit in safe and stable matter.

• Power-Cord Protection - Power-supply cords should be routed

so that they are not likely to be walked on or pinched by items

placed upon or against them, paying particular attention to cords at

plugs, convenience receptacles, and the point where they exit from

the fixture.

• Cleaning -The fixture should be cleaned only as recommended by

the manufacturer.

• The fixture should be serviced by qualified service personnel when:

A. The power cord or the plug has been damaged.

B. Objects have fallen, or liquid has been spilled into the appliance.

C. The appliance has been exposed to rain or water.

D. The fixture does not appear to operate normally or exhibits a

user serviceable parts inside.

• Never plug this unit in to a dimmer pack

• Always be sure to mount this unit in an area that will allow proper

ventilation. Allow about 6” (15cm) between this device and a wall.

• To reduce the risk of electrical shock or ﬁ re, do not expose this unit

rain or moisture.

• This unit is intended for indoor use only, use of this product outdoors

voids all warranties.

• During long periods of non use, disconnect the unit’s main power.

• Be sure that the local power outlet match that of the required voltage

for your unit.

• Do not attempt to remove or break off the ground prong from

the electrical cord. This prong is used to reduce the risk of electrical

shock and ﬁ re in case of an internal short.

• Do not remove the fan cover under any conditions. There are no

erence.

MINI Starball™ Safety Precautions

MINI Starball™ General Instructions

Please carefully read and understand the instructions in this manual

thoroughly before attempting to operate this unit. These instructions

contain important safety information regarding the use and mainte-

nance of this unit. Please keep this manual with the unit, for future ref-

• Bright LL-200 or LL-200/2 (200 Watt Lamp).

age in your area matches the required voltage for your American DJ®

your dealer without ﬁ rst contacting customer support.

MINI Starball™ Operation

and 220v version. Because line voltage may vary from venue to venue,

be sure to plug your ﬁ xture into a wall outlet with a matching power

supply before attempting to operate.

General Operation:

Simplicity! Just plug this fixture in, and watch it go. This fixture is

designed to operate as a stand alone unit, there is no need of a

controller. It has been tested and the lamp has been installed at

the factory there is no assembly necessary. The MINI Starball™ is

ready to be plugged in, out of the box. There is no power switch, after

plugging the unit the unit will light up and begin to slowely rotate in

a single direction. If there is no lamp output check the fuse and bulb.

If the fuse and bulb are good, please contact our toll free customer

support number for further instructions. Please do not return the unit to

Power Supply: Before plugging your unit in, be sure the source volt-

MINI Starball.™ The American DJ® MINI Starball

™

• Low Power Consumption (about 2 amps).

MINI Starball™ Power Supply

is available in a 120v

• Built-In Mounting Plate.

for a R.A. number.

MINI Starball™ Features

of purchase invoice. Please contact American DJ

® customer support

• 177 Clear Beams.

• 10 RPM Motor.

• Easy Lamp Replacement.

• Air Cooled.

• Light Weight, Compact Case Design.

If the unit is under warranty, you must provide a copy of your proof

MINI Starball™ Warranty Registration

The MINI Starball™ carries a 90 day limited warranty. We recom-

mend you fill out the enclosed warranty card to validate your purchase.

All returned service items whether under warranty or not, must be

freight pre-paid and accompany a return authorization (R.A.) number.

+ 2 hidden pages