American DJ Millennium Instruction Manual

American DJ

User Instructions

Technical Specifications

Model: Millennium

Voltage: 120v Fuse: 10A Lamp: ZB-64514 x 2 Colors: 7 Multi-Color Dichroic Duty Cycle: 15min./15min. on/off Dimensions:

11" x 11" x 14"

Weight: 7 Lbs.

Introduction: Congratulations and Thank You for purchasing

the American DJ Millennium. This light is one of American DJ’s continuing evolution in innovation. The Millennium is great for Mobile DJs, Clubs, and Bands. The Millennium utilizes an internal dichrioc dish that rotates by sound activation to create 40 beams of a unique colorful effect. This fixture has been lamped and tested for quality at the factory, there is no assembly necessary. Simply plug the unit in and it’s ready to go.

Functions and Controls: The fixture may be mounted on truss in any posi-

tion. After placing your fixture in a secure position, plug your unit into any standard 120v Edison outlet. This unit is sound activated and will not operate without a sound source. Turn up a music source and turn the sensitivity knob until the internal dish starts to turn. After the internal dish begins to move to sound you may adjust the sensitivity by turning the external knob until you reach desired effect.

Lamp Replacement: Disconnect from main power supply. Unscrew and

remove the three thumb screws that fasten the outer half of sphere to inner half. Remove outer half of the sphere to expose the color wheel. Unscrew and remove the color wheel to expose the lamps. Remove and replace the lamps (It’s avisable to replace both lamps at one time).

Be sure to follow all lamp handling procedures and guide lines, that are included with the new lamp to insure proper handling and long life.

Caution:

Always replace with the same type lamp and fuse unless otherwise instructed by an authorized American DJ Service representative.

Never open or attempt service while this unit is in motion or plugged in!