AMD
TED
14” Notebook
User
Menual
Device layout figure
KB
KB
Finger Print
Click Pad SPEAKER
Device
layout figure
CAMERA
CAMERA LED
Mic
LCD &
Touch screen
VOLUME BUTTONPower Button
USB TYPC C
-
Continued
Mic
BATT Charge LED
Audio combo jack
Buttons & LEDs
Buttons/ LED Button Function
Power button
• Press and hold to turn the device on or off.
• Press and hold for 4 seconds to reset the device if it
has fatal errors or hang
Volume button
• Press to adjust the device volume.
LED
• Power LED: Blue as system power on
• Charge LED: Orange
-ups, or freezes.
– in charging, Blue – Full charged
Devices and Socket
Name Function
LCD + Touch panel
14.0” FHD LCD with touch
Wifi + BT4.0
802.11a/b/g/n/ac +BT4.1 combo module
Camera
Built
-
in
1M HD
Camera, digital microphone included
Touchpad
Precision touchpad
FingerPrint Security input
Speaker Internal speaker
USB type C
connector
1.
Connect to USB2/3 devices, display devices
2.
Other devices via a USB type C dongle
3.
Connect to type C adapter
Audio combo jack
Connect to audio headset
panel supported
Using mode
3 using mode supported: Clamshell mode, Tent mode and Tablet mode
Clamshell mode
Tablet mode:
KB & touchpad disabled
Clamshell mode
Tent mode:
Tent mode:
KB & touchpad disabled
• Use the adapter to
charge the battery
using it for the first time.
Charging the battery
• Please use only device-
provided chargers to charge battery.
chargers or cables
can cause the battery to explode or damage the device.
via USB type C connector before
Unapproved
Federal
Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.
This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
that
Continued
FOR PORTABLE DEVICE USAGE (<20cm from body/SAR needed)
Radiation Exposure Statement:
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of the U.S. Government.
The exposure standard for wireless device employs a unit of measurement known as the Specific Absorption
Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR are conducted using standard operating
positions accepted by the FCC with the device transmitting at its highest certified power level in all tested
frequency bands.
FOR
COUNTRY CODE SELECTION USAGE (WLAN DEVICES
Note
: The country code selection is for non
-
US model only and is not available to all US model. Per FCC
Note
: The country code selection is for non
-
US model only and is not available to all US model. Per FCC
regulation, all WiFi
product marketed in US must fixed to US operation channels only.
)
Industry Canada statement
This
device complies with Industry Canada license
the following two conditions:
1) this device may not cause interference, and
2)
this device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
1)
l'appareil ne doit pas produire de brouillage, et
2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES
Cet appareil numérique de la classe B est conforme à la norme NMB
This device complies with RSS-
310 of Industry Canada. Operation is subject to the condition that this
device does not cause harmful interference.
Cet appareil est conforme à la norme RSS-
310 d'Industrie Canada. L'opération est soumise à la
condition que cet
appareil ne provoque aucune interférence nuisible
-exempt RSS standard(s). Operation is subject to
-003.
-003 du Canada.
.
Industry Canada statement -
This device and its antenna(s) must not be co-
located or operating in conjunction
antenna or transmitter, except tested built-
in radios.
Cet appareil et son antenne ne doivent pas être situés ou fonctionner en conjonction avec une autre
antenne ou un autre émetteur, exception faites des radios intégrées qui ont été testées.
The
County Code Selection feature is disabled for products marketed in the US/ Canada.
La fonction de sélection de l'indicatif du pays est désactivée pour les produits commercialisés aux
États-Unis et au Canada.
Radiation Exposure Statement:
The product comply with the Canada portable RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual. The further RF exposure
reduction can be achieved if the product can be kept as far as possible from the user body or set the
device to lower output power if such function is available.
Déclaration d'exposition aux radiations:
Le produit est conforme aux limites d'exposition pour les appareils portables RF pour les Etats
Canada établies pour un environnement non contrôlé.
Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel. La réduction aux expositions
RF peut être augmentée si l'appareil peut être conservé aussi loin que possible du corps de l'utilisateur
ou que le dispositif est réglé sur la puissance de sortie la plus faible si une telle fonction est disponible
Continued
with any other
-Unis et le
.
Industry Canada statement -
Caution :
1) the device for operation in the band 5150-
5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-
channel mobile satellite systems;
2)
the maximum antenna gain permitted for devices in the bands 5250
comply with the e.i.r.p. limit; and
3)
the maximum antenna gain permitted for devices in the band 5725
limits specified for point
-to-
point and non point
-
to
4) Users should also be advised that high-
power radars are allocated as primary users (i.e. priority users) of
the bands 5250-5350 MHz and 5650-
5850 MHz and that these radars could cause interference and/or
damage to LE-LAN devices.
Avertissement:
1) les dispositifs fonctionnant dans la bande 5150-
5250 MHz sont réservés uniquement pour une utilisation à
l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant
les mêmes canaux;
2)
le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5250
et 5470-
5725 MHz doit se conformer à la limite de p.i.r.e.;
1)
le gain maximal d’antenne permis (pour les dispositifs utilisant la bande 5725
à la limite de p.i.r.e. spécifiée pour l’exploitation point à point et non point à point, selon le cas.
2)
De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute puissance sont
désignés utilisateurs principaux (c.-à-
d., qu’ils ont la priorité) pour les bandes 5250
et 5650-
5850 MHz et que ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs
LAN-EL.
Continued
-5350 MHz and 5470-5725 MHz shall
-5825 MHz shall comply with the e.i.r.p.
-
point operation as appropriate.
-
5350 MHz
-5825 MHz) doit se conformer
-5350 MHz
System specification
System
specification
Voltage/ Current: Voltage
20V, Maximum current 2A
AC Adapter
Input voltage range / Frequency
：
DC Output：20V/0 ~ 2.25A
Trade name / Model :
DELTA ELECTRONICS, INC.
Battery
Built-in Lithium-ion Polymer
rechargeable battery
Capacity: 52.2 Whr
100 ~ 240 V AC, 50/60 Hz
/
ADP
-
45PE
BB
Loading...