Amazon loud WiFi Camera Operation Manual

Amazon Cloud WiFi Camera

Operation Manual

Dear user, welcome to use this product, please read the operating instruction
carefully before using this product and keeping this manual for future use.

1、Main Function Description

2、How To Download Mobile APP

A: Search and download “YCC365” in Apple Store or Android app store.
B: Scan the QR code as below.

C: Android mobile needs to open the location service to

device. App will pop up the window to ask for "location service" when you use ‘YCC365”

at the first time , Please select “allow”. If you refused by mistake,, please uninstall APP and

download it again.

For Android For IOS

get the network access of the

3、How To Operate The Mobile APP

Register an account



When you use this app at the first time, you need to use your email to register an
account, click “Sign Up” and set a password according this procedure.
*If you forget your password, you can reset your password, just click "Forgot
password” on the login page.
*Password should be at least 6 characters and not longer than 30 characters. It
should be a combination of letters and numbers

Add The Camera



1、 Scan QR code to add

A、P

lease make your phone connect to the Wi-Fi, and then click “Scan QR code to

add”, reset the camera, and then click “Pressed the SET button”, waiting for the

camera start up again.

B、 Select your own Wi-Fi and login with your password.

C、Align the two-dimensional code displayed on the phone with the camera lens,

maintain a distance of 4-8 inches and keep balance.

D、Click “Heard the buzzing” after hearing

the beep, a few seconds later, you will hear the voice “Internet connected welcome to
use cloud camera”

Choose a wired network（Only support Lan port device

2、

A、 Please connect Ethernet cable between camera and Wi-Fi router.

）

B、 After your phone connect to the Wi-Fi, Click “Add device” and “Choose a wired

network”

C、P

lease scan the QR code on the device and wait for the network connection to

succeed.

If you need to change WiFi, please do the following

pen the video, click “ ” in the right up corner

D、O

E、Select “Wi-Fi Network” and choose your Wi-Fi, login with your password, then click

“Connect”

F、Unplug the ethernet cable.restart the camera and finish adding

3、 Wi-Fi Smart configuration

A、After your phone connect to a Wi-Fi, please click “Add device” and “Choose a

Wi-Fi network”

reset the camera, after hearing the voice “Please use mobile phone for Wi-Fi
configuration”, please click the “Pressed the SET button”

B、Select your Wi-Fi and login with your password.

C、Hear the voice “Internet connected welcome to use cloud camera” and wait for the

Wi-Fi connection to succeed.

Function Introduction



Go to real-time video page

A：my favorite

B：Cloud video list，includes motion alarm video and sound alarm video

C: Video to phone local

D：Pan & Tilt

E：Full Screen

F：Cloud video replay, drag to timeline position to check the record from the video

G：

Mute/Unmute

H：

Two way audio

I: Snapshot

J: Parameter Menu

1、cloud video playback / edit

Click the icon

the cloud video
page

change the title of

this video

set the time of
this video

, check

choose the video and click “clip”

Click save, and the video will be saved to “my favorite” Automatically

2、Favorites video playback / share

A、Click “my favorite”

B、Choose and play the video

C、Click “Share”, You are share your Video on Facebook and YouTube, you can also

share it by link.

D、Select “Download” to save the video to your phone.

3、Close/Open the camera, set your monitoring plan

A、Click“

B、Click “Device is On” to open or close the camera

C、Set on/off time

, check the parameter menu

”

4、Cloud Storage Service

We offer 30-day-long cloud service, everyone can enjoy the cloud storage service for
free, after that you can choose to pay for the service with a low cost.

A、Select “Cloud service” and check Subscription packages

B、There are three kinds of subscription packages for you, you can choose to pay for

this service by monthly or yearly.

C、We support PayPal payment system, click “Go to PayPal now” and then finish the

payment ( please install PayPal app in advance )

Note：The cloud services are supported by Amazon AWS, all the videos and

messages are saved to amazon web services, it was authenticated by US-EU
Safe Harbor protocol verification, ensuring your safety and privacy are
inviolable. Due to the cloud subscription package is binding with the device, if
the camera stops working and you need to transfer the subscription package to
new device, please contact the seller.

5、Notification Settings

Click Notification Settings, set the notification model.

A 、 Turn on/off sound

detection message push

B 、 Turn on/off motion

detection message push

C、schedule notifications.

D 、 Open/Close mobile

phone notifications.

6、SD card

Insert the SD card into the camera and start the camera (Don’t do this while it’s
working)
TF card requirements

A:Memory space 8-128G
B:C10 TF card
C:FAT32 or exFAT format
D:Use after formatting

Click “SD Card State” to
check it

Note：After the SD card

is inserted, the video will
be save to the SD card
and loop coverage in the

future.

7、Other functions setting

A、Device name

B、Time zone.

HD video: switch the quality of pic, HD / SD
Device Microphone: Open / Close the microphone

Night Vision：

1、Off, close the night vision

2、On, always open night vision

3、Auto, automatic switchover

Rotate The Video Feed 180°：Flip the picture when the camera is installed under the

roof.

Wi-Fi Network: Change the Wi-Fi on the device.

Note: The Wi-Fi must be searchable, if the location changed and the Wi-Fi is different,

please reset and connect to a new Wi-Fi again.

Device Details：Check the ID and the number of the software\hardware of the

device.

Remove Device：P

another account to add the camera.

8、Multi-screen viewing video(Only applies to multiple devices under the same

account)

lease remove the camera in your account if you need to use

4、 How to check the video on PC

1、Login

Enter your email address and login with your password on https://www.eyeplusiot.com
Note: Don’t forget

錯誤! 超連結參照不正確。

2、Function introduction

A、4x Digital zoom

B、Stop playback

C、Volume setting

D、Talkback key

E、PAN / TILT

F、Full Screen

G、Close / Open Camera

H、Parameter setting, set the quality of picture and notifications.

I、Cloud video replay, drag to each timeline position to check the record from the video.

4、 FAQ

1、Can’t add the device

A、Please make sure the camera has been reset. Press the Reset button until hear the

prompt tone

B、Only support 2.4GHZ Wi-Fi, if your Wi-Fi router is 5GHZ, please switch to 2.4/5GHZ

dual mode.

C、Please turn on the GPS service before adding the device on the Android mobile phone .

After installation is complete, you will be asked to turn on GPS service when you use the
app at the first time, if you choose not to turn on the GPS service, please uninstall and
reinstall the app again

D、Please confirm the camera wasn’t binding by the other account.

There are four voice prompts in the progress

（1）“

（2）Select your Wi-Fi and login with your password, after the device makes a noise like

Please use mobile phone for Wi-Fi configuration” after powering on.

？

“beep” you will hear this “Please wait for Wi-Fi connecting”.

（3）“Please wait for internet connecting” after getting the Internet ip address.

（4）“

delete the special characters of your Wi-Fi password.

contact the seller.

2、What’s the difference of the timeline’s colors

gray means no exceptions and TF card video recording, white means no recording.

Internet connected welcome to use cloud camera”

A、If you can’t go to the second step, please check your Wi-Fi channel is not hidden,

and the Wi-Fi router can’t be so far from the camera. If this way doesn’t work, please
scan the QR code to add the camera.

B、If you can’t go to the third step, please reduce the number of the Wi-Fi users, and

C、If you can’t go to the forth step, please try again, if it still doesn’t work, please

？

Orange means alarm video recording, blue means audible alarm video recording,

3、Why does it have a interval while the video is recording to the TF card

The size of the video file is limited. Once the video size close to the critical value, the

video file will be created and the next video will continue to be recorded, there is a interval
but so short.

4、The TF card can’t be identified

Please check the TF card if it meets the quality requirements, when the Wi-Fi signal is
not good, it also can’t be identified.

？

5、The video recording timeline is blank after the cloud service expired.

The video can’t be replayed after cloud service expired, if there is no TF card in the

camera, the video can’t be recorded.

If the TF card is always working, but the video files disappeared, please check the
Check TF card state, if it is normal in the App but no video has been recorded, please
format the TF card. If it still doesn’t work, please get a new TF card and try again.

6、Why I can’t get the notifications on my phone

Make sure the App get the message pushing rights

Otherwise, when you are watching the real-time video in the App, there is no warning
notifications, because it’s unnecessary to send notifications when you are watching the
video online.

Advanced message push system, the warning notifications won’t be pushed to your

phone all the time but it will record all the messages and videos.

？

7、Camera disconnect

Please check the power and the Internet then restart the camera. If this way doesn’t
work please remove the camera and add it again in the App.

8、Circle in the video, video runs slowly

？

？

Circle in the video means it’s still loading, please check your network
environment.

9、How do the other people watch the video?

Share the App account with the other people.

10、How many people can use the account simultaneously.

There is no theoretical limit.

11、Why adding camera to another account would fail?

One camera one account, if the other account needs to add the camera, please
remove the camera in the current device.

？

12、How can I get my camera connected to the other Wi-Fi.

Two ways:

A：When you need to change to another Wi-Fi without moving the place.

Parameter setting >> Wi-Fi Network >> select the Wi-Fi
B: When the camera is moved to another place, please start the camera, you will see the
“Device disconnected” on the main page, and then click “TROUBLESHOOT” to connect
to the Wi-Fi again.

• After sales instruction

1、The product will be updated in real time, if there is update, it will not be

noticed anymore, please visit our official website for reference.

2、Introductions of the basic function of the products are included in the

instruction, please users to read all the information carefully.

3、lf any problems occur in the usage of the video camera, please contact the

Seller

4、We have made every effort to ensure the completeness and correctness of

contents of the instruction, but there may still some deviations between part of

the data and the actual situation, if you have any question or dispute,

5、Losses caused by operating without following the instruction of the manual

book should be assumed by users.

This instruction applies to consumer product.

Kindly reminder: if the instruction is updated, it will not be noticed any more,

dual video recording memory (TF card/cloud storage) is supported by the

video camera; to better safeguard safety of video recording, users could

select multiple cloud video recording mode for video camera via service

channels, choosing for monthly/yearly payment for storage.