Amana RMS10DS Quick Guide

Quick Start Reference Guide

Menu Guide

2:00

1:00-2:00

1:30-2:30

:30

Refer to Product Safety Manual for Safety Statements

Complete Owner’s Manual available online

Oven Wall Clearances

A—For North American (UL/CSA) models,

allow at least 3” (7.2 cm) of clearance around top of oven. For International (50 Hz) models, allow at least 12” (30 cm) of clearance around top of oven. Proper air ow around oven cools electrical components. With restricted air ow, oven may not operate properly and life of electrical parts is reduced.

B—Allow at least 3” (7.2 cm) between air

discharge on back of oven and back wall.

C—Allow at least 3” (7.2 cm) of clearance

around side of oven. One side of oven must be open.

DO NOT power spray

No metal pans

So...how do I use it? (Mechanical Dial)

Heating

1. Open oven door, place food in oven, and close oven door.

2. Turn time entry knob clockwise to desired time.

• Cooking time can be set up to 6 minutes.

• Oven begins operation and time counts down.

3. When cooking time has elapsed, microwave energy stops and oven signal sounds.

Interrupting Operation

Open oven door to interrupt operation or turn time entry knob counterclockwise to “0”.

To resume microwave oven operation, close door and turn knob.

Changing Time and Canceling Mistakes

Heating time can be changed at any time while the oven is operating. Turn knob to desired new setting. To set cooking time to zero, turn knob counterclockwise to “0”.

The switching operation of this microwave oven can cause voltage uctuations on the supply line. The operation of this oven under unfavorable voltage supply conditions can have adverse effects. This device is intended for the connection to a power supply system with a maximum permissible system impedance Zmax of 0.2 Ohms at the interface point of the user’s supply. The user has to ensure that this device is connected only to a power supply system which fullls the requirement above. If necessary, the user can ask the public power supply company for the system impedance at

the interface point.

Part No.20037401 Revised 7/10

For full product documentation visit:

www.acpsolutions.com

Cedar Rapids, Iowa 52404

 2010 ACP , Inc.