Amana NFW7200TW User Manual

Front Loading Washer

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

DRAIN SYSTEM OPTIONS

NFW7200T

Electrical: 120-volt, 60 Hz, 15-amp fuse or circuit breaker. It is recommended that a separate circuit serving only this appliance be provided. Do not use an extension cord.

Water: Pressure of 20 to 120 p.s.i. (138 to 827 kPa) is required.

Hot and cold water faucets must be within 4 ft (1.2 m) of the back of the washer for inlet hoses.

NOTE: Inlet hoses are available in lengths up to 10 ft (3m) for faucets more than 4 ft (1.2 m) from the washer.

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and speciﬁcations without notice.

Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Speciﬁcations subject to change without notice.

Ref. W10161756

09-11-08

The standpipe or laundry tub must be at least 18" (45.7 cm) high and no higher than 96" (2.4 m). The standpipe must be large enough to accept the outside diameter of the factoryattached drain hose.

LOCATION CONSIDERATIONS

It is recommended that the washer never be installed in areas where water may freeze since the washer will always maintain some water in the water valve, pump and hose areas. This can cause damage to belts, pump, hoses and other components. Operating temperature should be above 60° F.

A. Overall height: 38" (96.5 cm) B. Width: 27" (68.6 cm) C. Depth with door open 90°: 49" (124.5 cm) D. Depth: 28" (71.1 cm)

NOTE: The height of the washer from the ﬂoor is 38" (96.5 cm). This includes the leveling leg screwed all the way in. The leg can be unscrewed an additional 7/8" (2.2 cm) for a total overall height of 38-7/8" (98.7 cm).

Alcove or closet installation:

Minimum clearances for closet and alcove installations: Sides 0" (0 cm) Rear 2-3/8" (6.0 cm) Top 0" (0 cm) Closet front 2" (5.1 cm)

The closet front must have a total unobstructed air opening of 72"2(465 cm2) minimum, if both washer and dryer are installed together. A louvered door with equivalent air opening is acceptable. Washer alone does not require speciﬁc air opening.