Electrical Grounding Instructions — This refrigerator is
equipped with a three-prong (grounding) plug for
protection against possible shock hazards. If a twoprong wall receptacle is encountered, contact a
qualified electrician and have the two-prong wall
receptacle replaced with a properly grounded threeprong wall receptacle in accordance with the National
Electrical Code.
Refrigerator is designed to operate on a separate 103
to 126 volt, 15 amp., 60 cycle line.
Do not under any circumstances cut or remove
the round grounding prong from the plug.
Refrigerator must be grounded at all times. Do not
remove warning tag from power cord.
WARNING
Do not use a two-prong adapter. Do not use an
extension cord.
2
Model Identification
Thank you for purchasing this Amana® refrigerator. Please
read this Owner's Manual thoroughly . This manual
provides proper maintenance information. Any questions,
call the Consumer Affairs Department at 1-800-843-0304
inside U.S.A. and 1-319-622-5511 outside U.S.A.
Complete registration card and promptly return. If
registration card is missing, call the Consumer Affairs
Department.
When contacting Amana , provide product information.
Product information is on the serial plate, located on
ceiling of Fresh Food section. Record the following
information:
Model Number:
Manufacturing Number:
S/N or Serial Number:
Date of purchase:
Dealer’s name and address:
Keep a copy of sales receipt for future reference.
Amana also has a network of independent authorized
technicians. Locate a Factory Service Center or
independent authorized technician by calling 1-800-628-5782 inside U.S.A. and 1-319-622-551 1 outside U.S.A.
Warranty service must be performed by an authorized
Amana technician. Amana also recommends contacting
an authorized Amana technician if service is required
after warranty expires.
Amana offers a complete line of appliances: cooktops,
dishwashers, dryers, freezers, microwave ovens, ranges,
wall ovens, and washers. Amana also manufactures a
complete selection of high efficiency gas furnaces plus
both central and room air conditioners.
Enjoy this new Amana refrigerator.
Proper Disposal of your Refrigerator
IMPORT ANT: Child entrapment and suffocation are not
problems of the past. Junked or abandoned refrigerators
are still dangerous—even if they sit for "just a few days".
If you are getting rid of your old refrigerator , please follow
the instructions below to help prevent accidents.
BEFORE YOU THROW AWAY YOUR OLD
REFRIGERAT OR OR FREEZER:
• T ake off the doors.
• Leave the shelves in place so children may not easily
climb inside.
3
Cutout Dimensions
g
D
H
W
Installation Instructions
Proper installation will ensure that this refrigerator
operates most efficiently . Amana cannot be responsible
for improper installation.
1. Remove doors if necessary .
a. Remove top hinge cover. Remove top hinge.
b. Remove Fresh Food door.
c. Lift door closure off center hinge pin. Remove
center hinge pin.
d. Remove Deepfreeze® door. An internal support rod
may slide out. Replace rod before hanging door.
e. Remove center hinge.
f. Remove toe grille. Remove bottom hinge.
Single
Inst allatio n
H69" with 12" deep cabinets above refrigerator
70" with 24" deep cabinets above refri
W36"72¾" *
D24"24"
* See BID trim kit for specifications
Double
Inst allatio n
erator
A
J
A.5/16" (8 mm) screwsB. Door closure
C. PlugD. Door closure
E. Bottom hingeF . Pin
G.3/8" (9 mm) screwsH. Phillips screws
I.Center hingeJ.T op hinge
B
D
C
F
I
GH
Caution
T o avoid property damage, protect soft vinyl or other
flooring with cardboard, rugs, or other protective
material when moving refrigerator.
E
F
g. Slide appliance cart under side of refrigerator. Wrap
refrigerator with blanket or pad. Thread cart strap
around refrigerator and tighten. Do not overtighten
strap. Move refrigerator in front of final location.
4
h. Reverse doors if necessary .
BRF20 model
• Nameplate logo will automatically reverse.
• Replace internal support rod in hinge side of
Deepfreeze® door prior to hanging door .
Support
rod
• Move bottom hinge pin and door closure from
right bottom hinge to left bottom hinge. Move
plastic plug from left bottom hinge to right
bottom hinge using a needle nose pliers. Pinch
tabs from underside of hinge to remove.
BBI20 model
• Do not install the 2 supplied trim pieces
until doors have been reversed.
• Kit, #TK231L, is required to reverse doors.
Specify color when ordering:
TK231L W is white
TK231LL is almond
TK231LE is ebony
TK231LS is stainless
2. Connect ice maker water supply line.
• See instructions on rear of refrigerator cabinet.
3. Plug in power cord.
4. Move refrigerator into final location.
5. Level refrigerator.
a. Remove toe grille.
b. Turn roller adjustment screw to raise or lower rear
of refrigerator.
c. Turn stabilizing legs clockwise to raise or
counterclockwise to lower front of refrigerator.
Stabilizing legs must be firmly against floor.
Caution
T o avoid personal injury or property damage caused by
refrigerator tipping, stabilizing legs must be firmly
against floor.
Rear roller
adjustment
screw
Stabilizing leg
i. Rehang doors by reversing steps a-f.
• Use a penny at top to space door 3/4" (18 mm)
from cabinet.
• Handle side of door should be approximately
1
/8" (3 mm) higher than hinge side.
3/4" (18 mm)
BRF20 models have a different hinge cover then shown
5
6. Install Decorator Panels
(BBI20 Models)
If raised panels are used, must allow 2 1/2" minimum
of clearance between raised edge of panel and
refrigerator handle.
2 1/2" minimum
clearance from
raised panel
edge to edge
of rerigerator
door
Raised or
applied
decorator
panels
Raised or
applied
decorator
panels
a. Remove refrigerator door handle. Slide panel in
place on refrigerator door. Replace door handle and
install left side trim.
b. Slide panel in place on freezer door . Install right
side trim.
A
B
C
E
D
A. Decorator door panelB. Door handle
C. Door handle trimD. Phillips screws
E. Refrigerator door
Listed below are required height x width dimensions for
decorator panels. Panels are not supplied with the
refrigerator and can be purchased locally or as optional
kits from an Amana dealer.
Caution
T o avoid personal injury or property damage, Fresh
Food panel should not weigh more than 30 lbs (14 kgs)
and Deepfreeze® panel should not weigh more than 15
lbs (7 kgs).
Fresh Food Door41" x 35 1/8"
104 mm x 89 mm
Deepfreeze® Door21 15/16" x 35 5/8"
56 mm x 90 mm
Trim
Decorator door
panel
Freezer door
7. Review “Installation Checklist”.
6
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.