Amana Am30lp (2006), Am30 (2006) Rottiserie Manual

Amana

M

T

SS 4 Burner Gas Grill

USE AND CARE MANUAL

FOR OUTDOOR USE ONLY

ALWAYS KEEP YOUR GRILL COVERED WHEN NOT IN USE

BEFORE YOU BEGIN – We’ve included easy-to-follow, step-by-step instructions which have been carefully written to
ensure quick assembly of your grill. Reading the instructions will be a time saver in the end.

YOU WILL NEED – A Phillips scre
needed to assemble this grill. All other necessary hardware has been included.

re here to help

QUESTIONS? – W
number handy when calling.

e’

wdriver, adjustable wrench, 1/2 wrench or socket and a 1/4” nut driver or socket will be

aster service, have the model number and serial

or f

ust call 1-800-320-0859.

J

.

F

Welcome & Congratulations

Register Your Product

The PRODUCT REGISTRATION CARD
should be filled in completely, signed
and returned to Electrolux Home
Products North America.

Congratulations on your purchase of a new grill! We at

ure Heat Mfg. are very proud of our product and we

S
are completely committed to providing you with the best

ervice possible. Your satisfaction is our #1 priority.

s

Please read this Use & Care Manual very carefully. It
contains valuable information on how to properly
maintain your new grill.

We know you’ll enjoy your new grill and thank you for
choosing our product. We hope you consider us for
future purchases.

PLEASE READ AND SAVE THESE INSTRUCTIONS

This Use & Care Manual provides specific operating
instructions for your model. Use your grill only as
instructed in this manual. These instructions are not
meant to cover every possible condition and situation
that may occur. Common sense and caution must be
practiced when installing, operating and maintaining any
appliance.

Please record your model and serial numbers below for
future reference.This information is found on the serial
plate located on the back of the built-in grill .

Questions?

1-800-320-0859

Register Your Product

The PRODUCT REGISTRATION CARD

should be filled in completely signed

and returned to Sure Heat Manufacturing.

NOTE: Use only soap and water to clean serial plate.

Model Number: ______________________________

Serial Number: ______________________________

Purchase Date: ______________________________

Type: __________________________________

Gas

Please complete and mail in the

Registration Card

included with your grill.

Please retain this manual for future reference

Please attach sales receipt here for

future reference.

Product

AmanaTMis a registered trademark of the Maytag Corporation and is used under license

ing

actur

to Sure Heat Man

© 2006 Sure Heat Manufacturing All rights reserved

uf

1

General Safety Instructions

IMPORTANT SAFETY INFORMATION

- Read this manual carefully before using your grill to reduce the risk of fire, burn

hazard or other injury.

- Extreme care should be used because of the high temperatures produced by this
appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA
WHERE THE GRILL IS BEING OPERATED.

- This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids. Do not
allow flammable materials to come in contact with grate, burner or hot surfaces.

- Use only outdoors and provide good ventilation to avoid carbon monoxide build-up which could result in injury or death.

- Do not repair or replace any part of this appliance unless it is specifically recommended in this manual. A qualified
service technician should conduct all other service.

- Follow the installation and servicing instructions provided with this product. Have your grill installed by a qualified service
technician.

- Locate the main gas supply valve so that you know how to shut the gas off to your grill.

- If you smell gas, make sure all gas connections are tight before operation. If you continue to smell gas call a qualified
technician.

- When lighting a burner, always pay close attention to what you are doing and be certain you are pushing the igniter that
lights the burner you intend on using.

- Always keep your face and body as far away as from the grill as possible when lighting to reduce the risk of burn.

- Extinguish all flames and do not smoke while engaging gas and igniting the grill.

FOR YOUR SAFETY

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flames.

3. Open grill hood.

4. If odor continues, immediately
call your gas supplier.

CALIFORNIA
The Burning of gas cooking fuels generates some by
products which are on the list of substances which
are known by the State of California to cause cancer
or reproductive harm. California law requires busi­nesses to warn customers of potential exposure to
such substances.
substances, always operate this unit according to the
use and care manual, provide good ventilation when

cooking with gas.

PROPOSITION 65 - WARNING:

o minimize exposure to these

T

This appliance is not intended to be

installed in or on recreational

vehicles or boats.

TESTED IN ACCORDANCE WITH ANSI
Z21.58b-2002/CGA 1.6b-M02 STANDARD FOR
OUTDOOR COOKING GAS APPLIANCES.
THIS GRILL IS FOR OUTDOOR USE ONLY.

Check your local building codes for the proper
method of installation. In the absence of local
codes, this unit should be installed in accordance
with the National Fuel Gas Code No. Z223.1-2002
and the National Electrical Code ANSI/NFPA
No. 70-1990

FOR YOUR SAFETY

DO NOT store or use gasoline or other flammable vapors

and liquids in the vicinity of this or any other appliance.

An LP cylinder not connected for use shall not be stored in

the vicinity of this or any other appliance.

WARNING

DO NOT

the

“LIGHTING INSTRUCTIONS” section of

try lighting this appliance without reading

this manual.

FOR OUTDOOR USE ONLY

2

Grill Features

1

2

3

4

5

6

7

10

11

8

9

1. Roll top grill hood

2. Grilling/cooking surface

3. Side shelf

4. Towel bar/utensil hanger

5. Control knobs: main burners

6. Hood Handle

7. Warming shelf

8. Electronic igniter: main & side burner

9. Cart with doors

10. Side burner

11. Control knob: side burner

3

Assembly

CART ASSEMBLY

1. Attach two (2) rubber door stops to top center of
cart base using supplied bolts. (See Fig. 1)

2. Install door pivot screws into front left and front right
holes. Secure each screw in place with two (2) nuts.
Make sure to tighten 1 nut on top of the other. (See
Fig. 2-3)

3. Set the cart base on the floor and then lay the fixed
wheel channel on the left and the swivel wheel
channel on the right side of the cart base.
(See Fig. 4)

4. Pick up the left side of the cart base and set the
wheel channel in place by inserting the attached
bolts through the three (3) holes in the cart bottom.
(See Fig. 5)

5. Pick up the right side of the cart base and set the
swivel wheel channel in place by inserting the
attached bolts through the three (3) holes in the
cart bottom. (See Fig. 6)

Fig. 1

Fig. 2

Fig. 5

Fig. 6

Fig. 3

Fig. 4

Fixed Wheels

Front Of Grill

Swivel Wheels

w

Door Piv

4

ot Scre

Door Stops

Door Piv

ot Scre

w

Assembly

6. Place the left cart side onto the two (2) outer fixed

wheel channel bolts, make sure the large flange is
toward the front of the cart base. (See Fig. 7)

7. Secure the left cart side in place by hand tightening

nuts onto the wheel channel bolts. (See Fig. 8)

8. Place the right cart side onto the two (2) outer

swivel wheel channel bolts, make sure the large
flange is toward the front of the cart base.
(See Fig. 9)

9. Secure the right cart side in place by hand tightening

nuts onto the wheel channel bolts. (See Fig. 8)

Fig. 7

Large Flange Toward Front

Fig. 8

Fig. 9

Large Flange

oward Front

T

5

Assembly

10. Place the cart back onto the two (2) rear wheel

channel bolts. (See Fig. 10)

11. It twill be necessary to push the top of the left

and right sides outward slightly to get the cart
back down completely on the base. (See Fig. 11)

12. Press the sides back together making sure that

the side flanges cover the cart back flange.
(See Fig. 12)

13. Attach three (3) self tapping screws through the

left cart side into the cart back. Repeat for right
cart side. (See Fig. 13)

14. Fasten two (2) nuts onto the back wheel channel

bolts. (See Fig. 14)

15. Tighten all six (6) wheel channel nuts with a

wrench. (See Fig. 15)

Fig. 10

Large Flange With

Holes On Bottom

Fig. 11

Fig. 14

Fig. 15

Fig. 12

Fig. 13

6

Assembly

MOUNTING GRILL TO CART

1. Loosen the four (4) grill mounting bolts so that there

is approximately 1/4” between the bolt head and grill
bottom. (See Fig. 16)

2. Have someone help you pick up the grill and set it

squarely on top of the cart. (See Fig. 17)

3. Make sure the four (4) bolts fall through the large

opening on the key hole slots on the sides of the
cart. (See Fig. 18)

4. Slide the grill forward in the key hole slots until the

front grill flange rests against the side cart flanges.
(See Fig. 19)

5. Install two (2) self tapping screws into the top left

and right cart flanges. (See Fig. 19)

6. Tighten the four (4) grill head mounting bolts under-

neath the grill to secure the grill to the car

t.

(See Fig. 20)

Fig. 16

Mounting Bolts

Fig. 17

Fig. 18

Fig. 19Fig. 20

Bolt Head Inserted Here

Key Hole Slot

ront Grill Flange

F

7

Side Car

t Flange