Amana Am26lp-p Owner's Manual
THREE BURNER GAS GRILL
Assembly/Installation Instructions and Use & Care Guide
For questions about features, operation/performance, parts call: 1-800-229-5647 or visit www.sureheat.com
Table of Contents..............................................................................................................................2
IMPORTANT:
Save for local inspector’s use.
Installer: Leave installation instructions with the homeowner.
Homeowner: Keep installation instructions for future reference.
MODEL AM26LP-P
TABLE OF CONTENTS
OUTDOOR GRILL SAFETY ...................... 3
UNPACKING INSTRUCTIONS .................. 5
ASSEMBLY REQUIREMENTS .................. 5
Parts Supplied ................................................... 5
ASSEMBLY INSTRUCTIONS .................... 6
INSTALLATION REQUIREMENTS ......... 10
Location Requirements ...................................... 9
Product Dimensions .......................................... 9
Gas Supply Requirements ................................. 9
Gas Connection Requirements ....................... 10
INSTALLATION INSTRUCTIONS ........... 10
Make Gas Connection ..................................... 10
Check and Adjust the Burners ......................... 10
OUTDOOR GRILL USE ........................... 11
Using Your Outdoor Grill ................................. 11
Using Your Side Burner ................................... 12
TIPS FOR OUTDOOR GRILLING ........... 13
Cooking Methods ............................................. 13
OUTDOOR GRILL CARE ........................ 14
Replacing the Igniter Battery ........................... 14
General Cleaning ............................................. 14
TROUBLESHOOTING ............................. 15
ASSISTANCE .......................................... 15
REPLACEMENT PARTS ......................... 16
WARRANTY ............................................. 18
2
OUTDOOR GRILL SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
You can be killed or seriously injured if you don’t immediately
follow instructions.
You can be killed or seriously injured if you don’t follow
instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you
what can happen if the instructions are not followed.
DANGER
WARNING
Do not store or use gasoline or other 1.
If you smell gas:
Shut off gas to the appliance.
1.
ammable liquids or vapors in the
vicinity of this or any other appliance.
Extinguish any open ame.2.
Open lid.3.
If odor continues, keep away from the 4.
appliance and immediately call your gas
2.
An LP cylinder not connected for use
shall not be stored in the vicinity of this
or any other appliance.
supplier or your re department.
State of California Proposition 65 Warnings:
WARNING: This product contains a chemical known to the State of California to cause cancer.
WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm.
In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualied or licensed contractor, plumber, or gas tter qualied or licensed ■
by the State of Massachusetts.
If using a ball valve, it shall be a T-handle type. ■
A exible gas connector, when used, must not exceed 3 feet. ■
3
IMPORTANT: This grill is manufactured for outdoor use only. For grills that are to be used at elevations above 2000 ft (609.6 m) orice
conversion is required. See “Gas Supply Requirements” section. It is the responsibility of the installer to comply with the minimum
installation clearances specied on the model/serial rating plate. The model/serial rating plate for built-in models can be found on the
right-hand side of the grill. The model/serial rating plate for freestanding models can be found on the right-hand inside cabinet wall.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of re, electrical shock, injury
to persons, or damage when using the outdoor cooking gas
appliance, follow basic precautions, including the following:
Do not install portable or built-in outdoor cooking gas ■
appliances in or on a recreational vehicle, portable trailer,
boat or in any other moving installation.
Always maintain minimum clearances from combustible ■
construction, see “Location Requirements” section.
The outdoor cooking gas appliance shall not be located ■
under overhead unprotected combustible construction.
This outdoor cooking gas appliance shall be used only ■
outdoors and shall not be used in a building, garage, or any
other enclosed area.
Keep any electrical supply cord and fuel supply hose away ■
from any heated surfaces.
Keep outdoor cooking gas appliance area clear and free ■
from combustible materials, gasoline and other ammable
vapors and liquids.
Do not obstruct the ow of combustion and ventilation air. ■
Keep the ventilation openings of the cylinder enclosure free
and clear from debris.
Inspect the gas cylinder supply hose before each use of ■
the outdoor cooking gas appliance. If the hose shows
excessive abrasion or wear, or is cut, it MUST be replaced
before using the outdoor cooking gas appliance. Contact
your dealer and use only replacement hoses specic for
use with the outdoor cooking gas appliance.
Visually check the burner ames. They should be blue. ■
Slight yellow tipping is normal for LP gas.
Check and clean burner/venturi tube for insects and insect ■
nests. A clogged tube can lead to re under the outdoor
cooking gas appliance.
The LP gas supply cylinder to be used must be: ■
constructed and marked in accordance with the –
Specication for LP Gas Cylinders of the U.S.
Department of Transportation (DOT) or the National
Standard of Canada, CAN/CSA-B339, Cylinders,
Spheres and Tubes for Transportation of Dangerous
Goods; and Commission.
provided with a listed overlling prevention device. –
provided with a cylinder connection device compatible –
with the connection for outdoor cooking gas
appliances.
Always check connections for leaks each time you connect ■
and disconnect the LP gas supply cylinder. See “Installation
Instructions” section.
When the outdoor cooking gas appliance is not in use, the ■
gas must be turned off at the supply cylinder.
Storage of an outdoor cooking gas appliance indoors ■
is permissible only if the cylinder is disconnected and
removed from the outdoor cooking gas appliance.
Cylinders must be stored outdoors and out of the reach of ■
children and must not be stored in a building, garage, or
any other enclosed area.
The pressure regulator and hose assembly supplied ■
with the outdoor cooking gas appliance must be used. A
replacement pressure regulator and hose assembly specic
to your model is available from your outdoor cooking gas
appliance dealer.
Gas cylinder must include a collar to protect the ■
cylinder valve.
For appliances designed to use a CGA791 Connection: ■
Place a dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap on
the cylinder valve outlet that is provided with a cylinder
valve. Other types of caps or plugs may result in leakage of
propane.
If the following information is not followed exactly, a re
causing death or serious injury may occur.
Do not store a spare LP gas cylinder under or near this ■
outdoor cooking gas appliance.
Never ll the cylinder beyond 80 percent full. ■
SAVE THESE INSTRUCTIONS
4
UNPACKING INSTRUCTIONS
Using a utility knife, cut the tape to open the top aps of the 1.
carton.
Remove the Assembly/ Installation Instructions and Use 2.
and Care Guide.
Remove the corner supports on the top of the inside of the 3.
carton. Remove the foam from the two sides.
Remove the two grill cart wheels, the package of the four 4.
grill support poles and the front panel. Remove the bread
warmer rack.
Remove the foam packaging from the top and sides of the 5.
grill head assembly.
Remove all the parts along the front and sides of the carton.6.
Remove the four corner supports from the inside of the 7.
carton.
Using a utility knife, cut along the vertical dotted cut lines 8.
located on 2 sides of the carton. Lay the box sides at.
Using two or more people, remove grill head assembly and 9.
set aside.
ASSEMBLY REQUIREMENTS
Remove the plastic bag from the grill head.10.
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
Remove screws (with hang tags attached) located on either 11.
side of the grill head.
Open hood and remove boxed grill component parts and 12.
set aside.
Remove wrapped avor grids from top of box. Open box 13.
and remove contents and set aside.
Dispose of/ recycle all packaging materials.14.
View of Unassembled Grill Parts
F
H
M
Parts Supplied
A
E
D
G
I
B
C
J
L
Q
N
K
Bread Warming RackA.
Flavor GridsB.
Main Cooking GratesC.
LP Gas Fuel Tank Retention BarD.
Drip Pan HolderE.
Drip PanF.
LP Gas Fuel Tank HolderG.
Side Shelf - Left AssemblyH.
Side Burner Shelf - Right AssemblyI.
Grill Head AssemblyJ.
Support Poles - LeftK.
Support Poles - RightL.
Cart Front PanelM.
Cart BaseN.
O
Tank Barrier BarO.
Grill Cart WheelsP.
IgniterQ.
Not shown:
Package of small components
P
5
Assembly Hardware Supplied (actual size)
Assembled Grill View
9 - Self-tapping screws ■
8 - M5 x 10 Phillips pan head screws ■
8 - M5 x 40 Phillips pan head screws ■
4 - M6 x 65 Phillips pan head screws ■
1 - Side burner knob with bezel ■
NOTE: Other hardware required is attached to the grill where
needed.
Tools Needed
# 2 Phillips screwdriver ■
Adjustable wrench ■
1/2” wrench or socket ■
1/4” nut driver or socket ■
Tape measure ■
Level ■
Noncorrosive leak detection ■
solution
D
C
B
A
A. Control knob: main burners
B. Side shelf
C. Grilling/cooking surface
D. Roll top grill hood
E. Hood handle
F.
Bread Warming Rack
E
F
G
H
I
J
G. Side burner
H. Control knob: side burner
I. Electronic igniter: main
burners and side burner
J. Grill Cart
Parts Supplied
Gas pressure regulator/hose assembly set for 11” WCP LP gas ■
(attached to manifold).
Parts Needed
20 lb LP gas fuel tank ■
ASSEMBLY INSTRUCTIONS
Assemble cart base
The LP gas fuel tank barrier is attached to the cart base. 1.
Turn the LP gas fuel tank barrier 90 degrees as shown (A).
Bend the LP gas fuel tank barrier into a “V” shape (B).2.
Use (1) self-tapping screw to install the LP gas fuel tank 3.
barrier onto cart base
Use (2) self-tapping screws to install the LP gas fuel tank 4.
holder onto the cart base.
Insert the end of LP gas fuel tank retention bar through the 5.
holes of the cat base as shown.
A. LP gas fuel tank barrier
B. Self-tapping screw
A. LP gas fuel tank retention bar
B. LP Gas fuel tank holder
6
Loading...