Amana ACS3350AB, ACS3350AC, ACS3350AS, ACS3350AW Installation Instructions

Installation

Instructions

Installer–Leave this manual and other literature with owner for future use.

Slide-In Gas Range

Keep instructions for future reference. Be sure manual stays with range. Read entire instruction and Owner’s Manual before beginning installation.

You'll Need a Few Tools	1	PREPARE TO
Before You Begin		INSTALL
		RANGE AND
2SHQ (QGHG		INSTALL ANTI-
:UHQFK		TIP BRACKET

Anti-tip Bracket

Installation

To reduce risk of range tipping, secure

range with a properly installed antitip bracket. Refer to anti-tip installation instruction, provided with the bracket. Install bracket before placing range in cabinet cutout.

1XW 'ULYHU RU 6RFNHWV

6FUHZ 'ULYHUV

/HYHO

7DSH 0HDVXUH

'ULOO DQG 'ULOO%LW

IRU ZRRG IORRU

IRU FRQFUHWH IORRU

Pressure regulator location

Remove the storage drawer and locate regulator under oven cavity in rear.

Regulator

Measure cabinet area and prepare it according to illustrations in

Minimum Clearances to Combustible Surfaces and Range and Cabinet Dimensions section in this instruction sheet.

Gas supply must not interfere with electrical supply. Electrical supply must not be grounded to the gas supply line.

Once a suitable location is found meeting the specified requirements, proceed to the next step of the installation.

2 CONNECTSUPPLY GAS

Range is shipped to be connected to natural gas only. To convert to

LP/Propane, refer to the conversion instructions supplied with range.

! WARNING

To avoid risk of property damage or serious personal injury, never use a lighted match to test for gas leaks.

Gas Connection

Connect gas supply to regulator using hard pipe or flexible connector (check local codes). Pressure regulator supplied with this appliance has a 1/2 inch NPT female connection. If gas union is used, remove storage drawer, slide range into place, and connect union.

•A manual shutoff, not supplied with range, must be installed in an accessible location outside of range.

•Connector must be AGA/CGA design certified.

•Use joint compound that is resistant to the action of propane gas on all male threads.

•Use supplied pressure regulator only.

•Do not overtighten gas fitting when attaching to pressure regulator. Overtightening may crack regulator.

•Support pressure regulator with wrench when installing gas fitting.

Testing for Gas Leaks

After final gas connection is made, turn on manual gas valve and test all connections in gas supply piping and range for gas leaks. Leak testing of the appliance shall be conducted according to the manufacturer’s instructions.

1.Place soap suds on connection.

•Bubbles appear if leak is present.

2.If bubbles appear, shut off gas supply valve.

3.Tighten joint if leak is at factory fitting.

•If leak is not at factory fitting, unscrew, apply more joint compound, and tighten to correct leak.

4.Retest connection for leak after tightening.

•Retest any connections that were disturbed.

!WARNING

To avoid risk of property damage or personal injury, only use a new flexible connector that is AGA/CGA design certified.

•Do not use an old connector.

•Do not reuse a connector after moving appliance.

PDQXDO