Altec Lansing IM9 User Manual

UUsseerr’’ss gguuiidde
e
GGuuííaa ddeell uussuuaarriio
o
FCC Instructions for a Class B digital device or peripheral
ote: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
N provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
ot installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
n will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
quipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
e
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Caution: To prevent the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
CAUTION
o prevent electric shock do not use this (polarized) plug with an
T extension cord, receptacle or other outlet unless the blades can be fully
nserted to prevent blade exposure.
i
WARNING
O REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
T APPLIANCE TO RAIN OR MOISTURE.
CONNECTING THE POWER SUPPLY (AC WALL OUTLET)
S
nap plug into power supply and then insert the blades into the outlet. Please note,
the inMotion iM9 can also be powered with four C batteries (not included).
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instru 2
. Keep these instructions.
3
. Heed all warnings.
4. Follow all instru
5. Do not use this apparatus near water – This apparatus shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the apparatus.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufactur rug or similar sur not be placed in a built-in installation, such as a closed bookcase or cabinet that may impede the fl not be impeded by covering the openings with items such as newspapers, tablecloths, curtains, etc.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9. No naked flame sources, such as lighted candles, should be placed on the apparatus.
10. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for the replacement of the obsolete outlet.
11. Protect the power cord from being walked on or pinched — particularly at plugs, convenience r
12. Do not install in an area which impedes the access to the power plug. Disconnecting the power plug is the only way to completely r
oduct and must be r
pr Power sour
13. instructions or as marked on the appliance. If a separate power supply is included with this apparatus, do not substitute with any other power supply – use only manufacturer-provided power supplies.
14. Unplug this apparatus during lightning storms or when unused for long periods of time.
15. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. For service, refer to qualified service personnel, return to the dealer, or call the Altec Lansing service line for assistance.
16. For products which incorporate batteries, please refer to local regulations for proper battery disposal.
ctions.
ctions.
uctions. The apparatus should not be situated on a bed, sofa,
’s instr
er
face that may block the ventilation openings. The apparatus must
ow of air through the ventilation openings. Ventilation should
. A grounding type
eceptacles, and the point where they exit from the apparatus.
eadily accessible at all times.
ce – Use only power supplies of the type specifi
emove power to the
ed in the operating
ALTEC LANSING TECHNOLOGIES, INC. ONE YEAR LIMITED WARRANTY (TWO-YEAR LIMITED WARRANTY IN THE EUROPEAN UNION AND ASIA)
WWhhaatt DDooeess TThhee WWaarrrraannttyy CCoovveerr?
from defects in materials or workmanship, with the exceptions stated below.
WWhhaatt IIss TThhee PPeerriioodd OOff CCoovveerraaggee?
w
arranty runs for two years from the date of purchase. For units not purchased in
E
urope or Asia, this warranty runs for one year from the date of purchase. The term of any warranties implied by law shall expire when your limited warranty expires. Some s
tates and/or Member States in the European Union do not allow limitations on how
long an implied warranty lasts, so the above limitation may not apply to you.
WWhhaatt DDooeess TThhee WWaarrrraannttyy NNoott CCoovveerr?
malfunction or failure that occurs as a result of: improper installation; misuse or failure t
o follow the product directions; abuse; or use with improper, unintended or faulty
e
quipment. (For information on proper installation, operation and use consult the manual supplied with the product. If you require a replacement manual, you may d
ownload a manual from damages are not recoverable under this warranty. Some states do not allow the e
xclusion or limitation of incidental or consequential damages, so the above limitation o
r exclusion may not apply to you.
WWhhaatt WWiillll AAlltteecc LLaannssiinngg DDoo TToo CCoorrrreecctt TThhee PPrroobblleemm?
repair or re If your product is no longer being manufactured, or is out of stock, at its option, Altec Lansing may replace your product with a similar or better Altec Lansing product.
HHooww TToo GGeett WWaarrrraannttyy SSeerrvviicce
contact Altec Lansing during the warranty period by email (csupport@alteclansing.com). You must include in your email, your name, address, email address, telephone number, d
ate of purchase and a complete description of the problem you are experiencing. In the United States, you may alternatively contact Altec Lansing by telephone at 1
-800-ALTEC88 — please be prepared to provide the same information. If the problem appears to be r pr shipments shall be at the customer’s expense, and the return must be accompanied by the original proof of purchase. You should insure the shipment as appropriate because you are responsible for the product until it arrives at Altec Lansing.
HHooww WWiillll SSttaattee LLaaww AAffffeecctt YYoouurr RRiigghhttss?
and you may also have other rights which var the European Union, you as a consumer might have other legal rights under national legislation of European Union Member States governing the sale of Altec Lansing’s goods. Those rights are not affected by this guarantee.
The above limited war to purchaser, if, and to the extent, valid and enforceable under the applicable law.
place any pr
ovide you a return authorization and instructions for return shipment. Return
elated to a defect in material or workmanship, Altec Lansing will
?
:
Altec Lansing warrants that its products shall be free
?
: For units purchased in European Union or Asia, this
?
: This warranty does not cover any defect,
wwwwww..aalltteeccllaannssiinngg..ccoom
oduct that pro
e
: To get a covered product repaired or replaced, you must
ranties and remedies are sole war
m
.
) Also, consequential and incidental
?
:
ves to be defective in material or workmanship.
?
: This warranty gives you specific legal rights,
Altec Lansing will, at its option,
om state to state. Please note that in
y fr
ranties and r
emedies available
CUSTOMER SERVICE
The answers to most setup and performance questions can be found in the
oubleshooting guide. You can also consult the FAQs in the customer support section
r
T of our Web site at find the information you need, please call our customer service team for assistance
etur
e r
befor
el: 800-258-3288
T Email: csupport@alteclansing.com If you live outside of North America, please visit our website at
and select your r For the most up-to-date information, be sure to check our Web site at
wwwwww..aalltteeccllaannssiinngg..ccoom
INTERNA
International customers: For information regarding the distribution of Altec Lansing products in your country, please visit
wwwwww..aalltteeccllaannssiinngg..ccoom
ning the speakers to your r
egion to locate your countr
m
.
NAL
O
TI
DISTRIBUTI
m
. If you live in North America and still can’t
etailer under their return policy.
y’s distributor.
N
O
wwwwww..aalltteeccllaannssiinngg..ccoom
wwwwww..aalltteeccllaannssiinngg..ccoom
m
and click on your region.
m
FCC NOTE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
1.
2. This device must accept any interference received, including interference that may cause undesir
ed operation.
1
Loading...
+ 7 hidden pages