Alpine NVD-W901 Instruction

NVD-W901 Update Instructions:

• Takes 2 hours to copy the software from the SD card into the INA-W900/INA-W900BT.

• SD card has to be in the SD card slot during the update process. The Navigation

system will not be operable until the process is completed.

• During the update, the screen will automatically transition to the audio screen.

1. Power on your INA-W900/INA-W900BT

2. Press the “Eject” button

3. Select “Open” on the screen

4. Open the rubber cover over the SD card slot, then insert the SD card
containing the update software

5. Re-attach the rubber cover

6. Close the unit by pressing the “Eject” button again

7. Press the “NAVI MENU” button

8. Select the “Setup” button on the screen (picture of a wrench)

Note: Parking brake must be engaged for this button to appear

9. Select the down arrow to go to the next page

10. Select the “Update” button on the screen

11. Select the “Yes” button to start the update

Note: The installation will be completed in two phases:

1) Navigation software (7 minutes). Vehicle ignition on/running during this process.

2) Map (2 hours). Map will get updated when vehicle ignition is on or running.

Once the map update has started, the parking brake may be disengaged.

You will be notified after the first phase is complete and the system will reset.

12. At the start of the second phase, you will need to enter a key code. The
key code can be found on the other side of this page

Note: The key code will be highlighted

13. You will be notified after the second phase is complete.

Congratulations! Your update is now complete!