Allen & Heath IP-8 Datasheet

Allen & Heath Limited
Kernick Industrial Estate
Penryn, Cornwall,
TR10 9LU, UK

www.allen-heath.com

Reset
Network
Settings

Network

PoE

+

Ext DC In

2.5 A

Lnk

/Act

Err

ENGINEERED IN THE UK BY ALLEN & HEATH LIMITED MADE IN CHINA

Serial No:

This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)

00000000

Overview

IP8 Te c h n i c a l D a t a s h e e t

• 8 Motorised faders

• 6 x Layers

• PoE+ or external 12V PSU (supplied)

• Programmed via dLive Surface or

Director software

• Interface with dLive via TCP/IP

• Network with other controllers,

computers and third party devices

IP 8 Technical Data Sheet Issue 2018 1 Allen & Heath Ltd

A&E Specifications

The remote controller shall be compact and portable
with 8 motorised faders, 8 LCD displays, 23 backlit
softkeys and a dimmable pre-set control for all
displays.

The faders shall be fully assignable, configured
individually or part of a vertical strip. There shall be
6 layers of control, accessed via softkeys, allowing
control of 48 individual channels.

There shall be a fast Ethernet connection via a
locking Neutrik EtherCon connector and a 12V DC
inlet connector on the rear of the unit.

Connection of the controller shall be either direct to
the Mixrack/Surface via standard Cat5 data
infrastructure. Alternatively, it shall be capable of
multiple parallel connections using an Ethernet
switch.

Configuration and programming of the controller
shall be via an embedded HTTP browser, the
console touchscreen or remote software installed on
a PC or MAC.

The controller shall be powered using a supplied
12V 2.1A power supply or by the Cat5 control cable
via a PoE+ enabled device. The controller shall be
compatible with PoE+ standard 802.3at (30W at
source). The maximum power consumption of the
controller shall be 25W.

The remote controller shall be used free standing or
there shall be provision made to fix the unit
permanently into furniture via six captive screws
located on the underside of the unit.

Recommended operating temperature for the
controller shall be 0 to 35 degrees Celsius.

The controller shall weigh no more than 2.5kg
(5.5lbs).

The controller shall be the Allen & Heath IP8.

IP 8 Technical Data Sheet Issue 2018 2 Allen & Heath Ltd