Allen&Heath GL3300 User Manual

FITTING INSTRUCTIONS

METERBRIDGE FITTING INSTRUCTIONS

PFL/AFL ACTIVE

GL4000 meterbridge shown

The meterbridge has been designed to compliment the Allen & Heath GL series of Live consoles. Its purpose is to
monitor the programme signal at the console main outputs i.e; Groups 1 to 8, Left, Right and Mono. The meterbridge
is available in various sizes to fit each console size and runs full length.

Connecting the meterbridge to a console is very easy and only requires plugging in the meterbridge harness and
tightening the three "grub" screws in the lower lip of the meterbridge.

To fit the meterbridge:

1.) Carefully unpack the meterbridge and
fit it over the console rear extrusion (A)
as shown in fig 1. Make sure all of the
grub screws (B) are fully withdrawn
from the meterpod extrusion (C) before
fitting.

2.) Once the meterbridge is in place, tighten
the grub screws (B) to secure the
meterbridge in place.

3.) Plug in the meterbridge harness (D) into
the connector marked METERPOD
on the rear panel of the console. See fig.

2.

A

C

B

FIG. 1

D

FIG. 2

Please note; the PFL LED indicator illuminates when any PFL is selected with the PFL signal level displayed on
the MONO meter.

Manufactured in the UK by:
Allen & Heath Limited
Kernick Industrial Estate,
Penryn,
Cornwall. TR10 9LU.
tel: [phone]

Publication .AP2126 Issue 4

copyright © 2001 ALLEN & HEATH. All
rights reserved.

L3dSM

fax: [phone]
http://www.allen-heath.com

Section A - 1

ALLEN & HEATH