How it Works
Alcatel
Loading...
1500
User Manual
28 pgs3.72 Mb0

Alcatel 1500 User Manual

Alcatel Conference 1500
USER’S GUIDE
TABLE OF CONTENTS
1. IMPORTANT SAFETY INSTRUCTIONS ......................................... 1
1.1. Package Contents 2
1.2. Location 3
2. SET UP YOUR PHONE ................................................................... 4
2.1. Connect the Base Unit 4
2.2. Activate the battery of the Wireless Microphone Unit 5
2.3. Insert the battery to the Wireless Microphone Unit 5
3. GETTING TO KNOW YOUR PHONE .............................................. 7
3.1. Base Unit Overview 7
3.2. Wireless Microphone Unit Overview 9
4. USING YOUR PHONE .................................................................... 10
5. PHONEBOOK ................................................................................. 13
6. CALLER DISPLAY (Network dependent) ..................................... 16
7. PHONE SETTINGS ......................................................................... 18
8. TROUBLESHOOTING .................................................................... 21
9. TECHNICAL SPECIFICATIONS ..................................................... 22
10. SAFETY .......................................................................................... 23
11. ENVIRONMENT .............................................................................. 24
1
When using your conference phone, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following:
Read and understand all instructions. Follow all warnings and instructions marked on the product. Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a
damp cloth for cleaning. Do not use this product near water such as near a bath tub, wash bowl, kitchen sink, laundry tub or
swimming pool, or in a wet basement or shower. Do not place this product on an unstable table, shelf, stand or other unstable surfaces. Slots and openings in the back or bottom of the base unit and wireless microphone unit are provided
for ventilation. To protect them from overheating, these openings must not be blocked by placing the product on a soft surface such as a bed, sofa or rug. This product should never be placed near or over a radiator or heat register. This product should not be placed in any area where proper ventilation is not provided.
This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply in your office, consult your dealer or local power company.
Do not allow anything to rest on the power cord. Do not install this product where the cord may be walked on.
Never push objects of any kind into this product through the slots in the base unit or wireless microphone unit because they may touch dangerous voltage points or create a short circuit. Never spill liquid of any kind on the product.
To reduce the risk of electric shock, do not disassemble this product, but take it to an authorized service facility. Opening or removing parts of the base unit or wireless microphone unit other than specified access doors may expose you to dangerous voltages or other risks. Incorrect reassembling can cause electric shock when the product is subsequently used.
Do not overload wall outlets and extension cords. Unplug this product from the wall outlet and refer servicing to an authorized service facility under the
following conditions:
When the power supply cord or plug is damaged or frayed. If liquid has been spilled onto the product. If the product has been exposed to rain or water. If the product does not operate normally by following the operating instructions. Adjust only those
controls that are covered by the operation instructions. Improper adjustment of other controls may result in damage and often requires extensive work by an authorized technician to restore the product to normal operation.
If the product has been dropped and the base unit and/or wireless microphone unit has been damaged.
If the product exhibits a distinct change in performance.
Avoid using the conference phone during an electrical storm. There is a remote risk of electric shock from lightning.
Do not use the conference phone to report a gas leak in the vicinity of the leak. Under certain circumstances, a spark may be created when the adapter is plugged into the power outlet, or when the remote microphone unit is replaced in its cradle. This is a common event associated with the closing of any electrical circuit. The user should not plug the phone into a power outlet, and should not put a charged wireless microphone unit into the cradle, if the phone is located in an environment containing concentrations of flammable or flame-supporting gases, unless there is adequate ventilation. A spark in such an environment could create a fire or explosion. Such environments might include: medical use of oxygen without adequate ventilation; industrial gases (cleaning solvents; gasoline vapors; etc.); a leak of natural gas; etc.
Only put the wireless microphone unit next to your ear when it is in normal talk mode. The power cables are intended to be correctly oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
•
•
•
•
•
•
13.
14.
15.
16.
1. IMPORTANT SAFETY INSTRUCTIONS
2
1.1. Package Contents
The package contains the following items.
• 1 Alcatel Conference 1500 base unit
• 2 Wireless microphone units
• 1 AC power cord
• 1 Interface module (AC power / To Phone & From Wall)
• 1 Telephone line cord
• 2 3.7V 240mAh Li-Polymer rechargeable batteries
• 1 6-metre connector cable
• User’s guides
Important: Only use the mains power adaptor, cables, and rechargeable batteries supplied in the package. Otherwise, this product might not work. Any replacement rechargeable batteries must be of the same type.
Alcatel Conference 1500 base unit x 1
User guides
Telephone line cord x 1
Wireless microphone unit x 2
6-metre connector cable x 1
3.7V 240mAh Li-Polymer rechargeable battery x 2
Interface module x 1
AC power cord x 1
User guide
ErisStationJ
TM
3
1.2. Location
For maximum coverage and reduce the interference, here are some guidelines you should consider when you place the base unit:
- place it away from electronic appliances such as televisions, microwave ovens, radios, personal computers, wireless devices, or other cordless phones.
- avoid facing radio frequency transmitters, such as external antennas of mobile phone cell stations.
- avoid plugging it into the same circuit as other major household electrical appliances because of the potential for interference. Try moving the appliance or the base unit to another power outlet.
- If the reception between a wireless microphone unit and the base unit is not satisfactory, move the units to another location for better reception.
4
2.1. Connect the Base Unit

Always use the cables provided in the box.
2. SET UP YOUR PHONE
Plug one end of the 6-metre connector cable into the base unit, and then plug the other end into the interface module. Route the cord through the slots.
Plug one end of the telephone line cord into the interface module, and then plug the other end into the wall jack or micro-filter.
Plug the small end of the AC power cord into the interface module, and plug the large end into the wall power outlet.
1.
2.
3.
5
2.2. Activate the battery of the Wireless Microphone Unit
1. Activate the battery of each wireless microphone unit by pulling the plastic tag away from the back of the unit.

If the microphone unit still does not turn on after the pull tag is removed and charged over 8 hours, take the battery out and re-insert it by following the steps in the section 2.3.
•
1
2.3. Insert the battery to the Wireless Microphone Unit
1. Place the supplied rechargeable battery carefully as indicated. Pay extra attention to the direction of battery.
6
2. Slide the battery compartment cover back.
3. Put the microphone unit on the base unit and charge for 8 hours before first use. The unit will emit red light when it is properly placed on the base.

Use only the supplied Li-ion Polymer rechargeable battery. If the wireless microphone units will not be used for a long time, disconnect and remove the battery
to prevent possible leakage - Slide open the cover, and then press the 2 ribs outwards. After that, use finger to lift the battery from the end side, and then slowly take out the battery.
•
•
If you have a Broadband Line
If you connect your telephone to a line with a broadband connection, you will need to insert a micro-filter between the telephone and the telephone line. Otherwise, there may be interference between the telephone and the broadband, which could cause problems.
In a fixed line with broadband, every telephone must have a micro-filter connected, not just the one at the telephone point that your modem is connected to. If you need more broadband micro-filters, contact your broadband supplier.
Loading...
+ 19 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use