Assembling the Unit ..................................................6
OWNER INFORMATION
General
The Vertical Contact Toaster, is designed for contact
toasting of buns. The toaster design allows the operator to place buns on both sides of the heated Platen
at the same time. Buns are placed into the top of the
toaster and uniform, golden brown, warm buns are then
retrieved from the bottom of the toaster in
approximately 15 seconds (VCT-1000) or 45 seconds
(VCT-50).
This manual provides the safety, installation, and operating procedures for the Vertical Contact Toaster. We
recommend that all information contained in this
manual be read prior to installing and operating the
unit.
Your Vertical Contact Toaster is manufactured from the
finest materials available and assembled to Roundup’s
strict quality standards. This unit has been tested at
the factory to ensure dependable trouble-free
operation.
Please read the full text of the Limited Warranty in this
manual.
If the unit arrives damaged, contact the carrier immediately and file a damage claim with them. Save all
packing materials when filing a claim. Freight damage
claims are the responsibility of the purchaser and are
NOT covered under warranty.
The warranty does NOT extend to:
• Damages caused in shipment or damage as
result of improper use.
• Installation of electrical service.
• Normal maintenance as outlined in this manual.
• Malfunction resulting from improper maintenance.
• Damage caused by abuse or careless handling.
• Damage from moisture into electrical
components.
• Damage from tampering with, removal of, or
changing any preset control or safety device.
IMPORTANT! Keep these instructions for future reference. If the unit changes
ownership, be sure this manual accompanies the equipment.
2
P/N 1010930 Rev. C 09/13
VERTICAL CONTACT TOASTER
OWNER INFORMATION (continued)
Service/Technical Assistance
If you experience any problems with the installation
or operation of your unit, contact your local Roundup
Authorized Service Agency.
Fill in the information below and have it handy when
calling your Authorized Service Agency for assistance.
The serial number is on the specification plate located
on the rear of the unit.
Purchased From:
Date of Purchase:
Model No.:
Serial No.:
Mfg. No.:
Refer to the service agency directory included with your
unit.
Authorized Service Agency
Name:
Phone No.:
Address:
Use only genuine Roundup replacement parts in this
unit. Use of replacement parts other than those supplied by the manufacturer will void the warranty. Your
Authorized Service Agency has been factory trained
and has a complete supply of parts for this toaster.
You may also contact the factory at 1-877-392-7854
if you have trouble locating your nearest Authorized
Service Agency.
IMPORTANT
A.J. Antunes & Co. reserves the right to change specifications and product design
without notice. Such revisions do NOT entitle the buyer to corresponding changes,
improvements, additions, or replacements for previously purchased equipment.
P/N 1010930 Rev. C 09/13
3
VERTICAL CONTACT TOASTER
IMPORTANT SAFETY INFORMATION (continued)
In addition to the warnings and cautions in this manual,
use the following guidelines for safe operation of the
unit.
• Read all instructions before using equipment.
• For your safety, the equipment is furnished with
a properly grounded cord connector. Do NOT
attempt to defeat the grounded connector.
• Install or locate the equipment only for its intended use as described in this manual. Do NOT use
corrosive chemicals in this equipment.
• Do NOT operate this equipment if it has a damaged cord or plug, if it is not working properly, or
if it has been damaged or dropped.
• This equipment should be serviced by qualified
personnel only. Contact the nearest Roundup
Authorized Service Agency for adjustment or
repair.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
The following warnings and cautions appear throughout
this manual and should be carefully observed.
• Turn the power off, unplug the power cord, and
allow unit to cool down before performing any
service or maintenance.
• The procedures in this chapter may include
the use of chemical products. These chemical
products will be highlighted with bold face letters followed by the abbreviated HCS (Hazard
Communication Standard). See Hazard
Communication Standard manual for the appropriated Material Safety Data Sheets (MSDS).
• The toaster should be grounded according to
local electrical codes to prevent the possibility of
electrical shock. It requires a grounded receptacle with separate electrical lines, protected by
fuses or circuit breaker of the proper rating.
• Bread may burn. Therefore toasters must not be
used near or below curtains or other combustible
walls and materials. Failure to maintain safe
operating distances may cause discoloration or
combustion.
• Failure to use Release Sheets may result in
damage to the equipment and loss of warranty
coverage.
• All electrical connections must be in accordance
with local electrical codes and any other applicable codes.
• WARNING ELECTRICAL SHOCK HAZARD.
FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR
DEATH.
- Electrical ground is required on this appliance.
- Do NOT modify the power supply cord plug.
If it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
- Do NOT use an extension cord with this
appliance.
- Check with a qualified electrician if you are
unsure if the appliance is properly grounded.
- If the power cord is damaged, it must be
replaced with a power cord available from
the manufacturer or an Authorized Service
Agency.
4
P/N 1010930 Rev. C 09/13
Electrical Ratings
VERTICAL CONTACT TOASTER
SPECIFICATIONS
Model &
Mfg. No.
VoltsWattsAmp.Hertz
VCT-1000
9210719
9210721
208–
240
2600–
3455
12.5–
14.4
9210728
Electrical Cord & Plug Configurations
Model &
Mfg. No.
VCT-100 0
9210719
9210721
9210728
DescriptionConfiguration
NEMA 6-20P 20
Amp, 250 VAC
Non–Locking
(Assembly Only)
Dimensions
20-5/16"
(515.87 mm)
60
15-1/4”
(387.35 mm)
P/N 1010930 Rev. C 09/13
29-3/16”
(741.36 mm)
9-3/4”
(247.65 mm)
5
VERTICAL CONTACT TOASTER
INSTALLATION
Unpacking
1. Remove unit and all packing materials from
shipping carton.
2. Open the large box. It should contain:
• Bun Chute (Figure 1)
• Butter Wheel and Pan (Figure 1)
• Two Release Sheets (Figure 1)
• Owner’s Manual
• Authorized Service Agency Directory
3. Remove all packing materials and protective
coverings from the unit and parts.
NOTE: If any parts are missing or damaged, con-
tact A.J. Antunes & Co. IMMEDIATELY at
630-784-1000.
Equipment Setup
When placing the toaster into service, pay attention to
the following guidelines.
• Make sure power to the unit is off and the toaster
is at room temperature.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
Assembling the Unit
NOTE: The factory has a pre-installed a Release
Sheet over the Platen (Figure 1). Verify that it is
properly in place before proceeding.
1. Remove the Bun Chute from the box and install
(Figure 1).
2. Remove the Butter Wheel and Pan from box.
3. Install the Pan over the front edge of the Heat
Shield and place the Butter Roller in Pan and
engage into gear case (Figure 1).
NOTE: Make sure the Heat Shield is activating the
Conveyor Interlock Safety Switch (Figure 1). The
conveyors will not rotate unless the Heat Shield
is in place and activating the Conveyor Safety
Interlock Switch.
CAUTION
Failure to use Release Sheets may result in damage
to the unit and loss of warranty coverage.
NOTE: Check the Release Sheet to make sure it
is not caught in the conveyor. Additional Release
Sheets can be purchased through your Authorized
Service Agency under P/N 7000249 (3-Pack) or
7000250 (10-Pack).
• Do NOT allow cord to hang over edge of table or
counter.
• Connect the unit to the power supply. Refer to
the specification plate for the proper voltage.
6
P/N 1010930 Rev. C 09/13
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.