A.J. Antunes & Co HDH-4 9300130 User Manual

Hot Dog Hutch
Models HDH-3, HDH-3DR, & HDH-4
owner’s manual
Manufacturing Numbers:
9300100, 9300101, 9300102, 9300104, 9300106, 9300108, 9300112, 9300116, 9300118, 9300120,
9300124, 9300125, 9300130, 9300132
www.ajantunes.com
P/N 1010736 Rev. G 05/14
CONTENTS
General 2 Warranty Information 2 Service/Technical Assistance 2 Important Safety Information 3 Warnings 3 Specications 4
Electrical Ratings 5 Capacities 5
Installation 6
Unpacking 6 Equipment Setup 6
Operating Instructions 7
Hi-Limit Reset Button 7
Maintenance 8 Daily Cleaning 8 Troubleshooting 9 Wiring Diagram 10
HDH-3 Racks & Baskets 13 HDH-3DR Racks 14 HDH-3DR (Mfg. # 9300112 ONLY) 15 HDH-3DR (Mfg. # 9300125 ONLY) 16
Limited Warranty 19
IMPORTANT
A.J. Antunes & Co. reserves the right to
change specications and product de-
sign without notice. Such revisions do not
entitle the buyer to corresponding changes,
improvements, additions or replacements
for previously purchased equipment.
GENERAL
This manual provides the safety, installation, and operating procedures for your toaster. Please read all of the information contained in this manual prior to installing and operat­ing the toaster.
This product is manufactured from the finest materials available and is assembled to Roundup’s strict quality standards. This toaster was tested at the factory to ensure dependable trouble-free operation.
WARRANTY INFORMATION
Please read the full text of the Limited War­ranty in this manual.
If the unit arrives damaged, contact the carrier immediately and file a damage claim with them. Save all packing materials when filing a claim. Freight damage claims are the responsibility of the purchaser and are not covered under warranty.
The warranty does not extend to:
y Damages caused in shipment or
damage as result of improper use. y Installation of electrical service. y Normal maintenance as out-
lined in this manual. y Malfunction resulting from
improper maintenance. y Damage caused by abuse
or careless handling. y Damage from moisture into
electrical components.
Damage from tampering with, removal of, or changing any preset control or safety device.
SERVICE/TECHNICAL ASSISTANCE
If you experience any problems with the installation or operation of your system, contact A.J. Antunes & Co. at 1-630-784­1000, or toll free in the United States at 1-800-392-7854.
Fill in the information in the next column and have it handy when calling for assis­tance. The serial number is on the specifica­tion plate located on the system.
Purchased From
Date of Purchase
Model Number
Serial Number
Mfg. Number
Use only genuine Roundup replacement parts in this unit. Use of replacement parts other than those supplied by the manufac­turer will void the warranty. Your Authorized Service Agency has been factory trained and has a complete supply of parts for this unit.
Visit www. ajantunes.com or contact the factory at 1-630-784-1000 to locate your nearest Authorized Service Agency. Refer to the service agency directory packaged with your manual and fill in the information below.
Authorized Service Agency
IMPORTANT
Keep these instructions for future refer-
ence. If the unit changes ownership, be sure
this manual accompanies the equipment.
Name
Phone Number
Address
P/N 1010736 Rev. G 05/14
IMPORTANT SAFETY INFORMATION
Use the following guidelines for safe opera­tion of the unit.
y Read all instructions be-
fore using equipment.
y For your safety, the equipment is
furnished with a properly grounded cord connector. Do not attempt to defeat the grounded connector.
y Install or locate the equipment only
for its intended use as described in this manual. Do not use corrosive chemicals in this equipment.
y Do not operate this equipment if
it has a damaged cord or plug, if it is not working properly, or if it has been damaged or dropped.
y This equipment should be serviced
by qualified personnel only. Contact your nearest Authorized Service Agency for adjustment or repair.
y Do not block or cover any
openings on the unit. y Do not immerse cord or plug in water. y Keep cord away from heated surfaces. y Do not allow cord to hang over
edge of table or counter. y Turn the power off, unplug the
power cord, and allow unit to cool
down before performing any service
or maintenance on the unit. y The equipment should be grounded
according to local electrical codes
to prevent the possibility of electri-
cal shock. It requires a grounded
receptacle with separate electrical
lines, protected by fuses or circuit
breaker of the proper rating. y All electrical connections must be in
accordance with local electrical codes
and any other applicable codes. y Do not clean this appli-
ance with a water jet.
WARNINGS
Be advised of the following warnings when operating and performing maintenance on this unit.
y If the supply cord is damaged, it must
be replaced by the manufacturer or its service agent or a similarly quali­fied person in order to avoid a hazard.
y Do not modify the power sup-
ply cord plug. if it does not fit the outlet, have a proper outlet in­stalled by a qualified electrician.
y Do not use an extension
cord with this appliance.
y Electrical ground is re-
quired on this appliance.
y Check with a qualified electri-
cian if you are unsure if the ap­pliance is properly grounded.
y If a chemical cleaner is used, be
sure it is safe to use on cast alu­minum. Observe all precautions and warnings on product label.
y Inspection, testing, and repair
of electrical equipment should only be performed by quali­fied service personnel.
y This equipment is to be installed to
comply with the basic plumbing code of the Building Officials and Code Administrators, Inc. (BOCA) and the Food Service Sanitation Manual of the Food and Drug Administration (FDA).
y Do not use abrasive materials.
The use of these may cause dam­age to the stainless steel finish.
y Chlorides or phosphates in clean-
ing agents (e.g. bleach, sanitizers, degreasers or detergents) could cause permanent damage to stainless steel equipment. The damage is usually in the form of discoloration, dulling of metal surface finish, pits, voids, holes, or cracks. This damage is permanent and not covered by warranty.
The following tips are recommended for maintenance of your stainless steel equip­ment:
y Always use soft, damp cloth for
cleaning, rinse with clear water and wipe dry. When required, always rub in direction of metal polish lines.
y Routine cleaning should be
done daily with soap, ammo­nia detergent, and water.
y Stains and spots should be sponged
using a vinegar solution.
y Finger marks and smears should be
rubbed off using soap and water.
y Hard water spots should be re-
moved using a vinegar solution.
P/N 1010736 Rev. G 05/14
SPECIFICATIONS
HDH-3
POWER
18 1/4"
(464 cm)
DRAIN
18 1/4"
(464 cm)
RESET
15"
(381 cm)
15"
(381 cm)
THERMOSTAT
OFF
HEATER
HDH-3DR
15"
(381 cm)
15"
(381 cm)
P/N 1010736 Rev. G 05/14
Electrical Ratings
Model & Mfg. No.
HDH-3
9300100
HDH-3
9300101
HDH-3
9300102
HDH-3
9300104
HDH-3DR
9300106
HDH-3DR
9300108
HDH-3DR
9300112
HDH-3
9300116
HDH-3
9300118
HDH-3DR
9300120
HDH-3DR
9300124
HDH-3DR
9300125
HDH-4
9300130
HDH-3DR
9300132
Volts Watts Amps Hertz
120 1000 8.3 50/60
220-240 1000 4.2-4.5 50/60 CEE 7/7, 16 Amp., 250 Volt
230 1000 4.4 50/60 CEE 7/7, 16 Amp., 250 Volt
230 1000 4.3 50/60
120 1000 8.3 50/60
230 1000 4.4 50/60 CEE 7/7, 16 Amp., 250 Volt
120 1000 8.3 50/60
240 1000 4.2 50 CEE 7/7, 16 Amp., 250 Volt
120 1000 8.3 50/60
220 925 4.2 50/60
120 1000 8.3 50/60
230 1000 4.3 50/60 CEE 7/7, 16 Amp., 250 Volt
230 1000 4.3 50/60
120 1000 8.3 50/60
NEMA 5-15P, 15 Amp., 120 Volt
NEMA 5-15P, 15 Amp., 120 Volt
NEMA 5-15P, 15 Amp., 120 Volt
NEMA 5-15P, 15 Amp., 120 Volt
NEMA 5-15P, 15 Amp., 120 Volt
NEMA 5-15P, 15 Amp., 120 Volt
NEMA 5-15P, 15 Amp., 120 Volt
Australian Plug, 10 Amp., 250 Volt
NEMA 5-15P, 15 Amp., 120 Volt
Plug
Description
Capacities
Water
7 Quarts (5.6 litres) in water tray
Food
(Refrigerated product only - Not Frozen)
HDH-3: Up to 33 standard size 7” (18 cm) hot dogs in the hot dog rack; up to 20 standard size hot dog buns in the basket.
HDH-3DR: Up to 66 standard size 7” (18 cm) hot dogs in the hot dog racks.
HDH-4: Up to 20 jumbo hot dogs in the hot dog rack, up to 24 standard size hot dog buns in the basket.
P/N 1010736 Rev. G 05/14
INSTALLATION
Unpacking
1. Remove unit and all packing materi-
als from shipping carton.
2. Open the large box. Remove all packing materials and protective coverings from the unit and parts.
NOTE: If any parts are missing or dam-
aged, contact A.J. Antunes & Co. IMMEDIATELY at 1-800-392-7854 (toll free in the U.S. and Canada) or at 630-784-1000.
3. Wash all components in soap and
water. Wipe all surfaces of the unit with a hot damp cloth.
NOTE: Do NOT use a dripping wet cloth.
Wring out before use.
4. Install components in unit.
Equipment Setup
When placing the unit into service, pay at­tention to the following guidelines.
y Make sure power is off and the
unit is at room temperature.
y Do NOT block or cover any
openings on the unit.
y Do NOT immerse cord
or plug in water. y Keep cord away from heated surfaces. y Do NOT allow cord to hang over
edge of table or counter. y Place unit on a sturdy, level
table or work surface.
Ensure that the line voltage corresponds to the stated voltage on the unit specification label.
Ensure the power to the unit is turned off before plugging in the power cord.
NOTE: The power cord for Mfg. No.
9300132 is located on the left side of the unit. See note on page
11.
BASKET
TR AY
Figure 1. Hot Dog Hutch Components (HDH-3 Shown)
CAUTION
All electrical connections must be in
accordance with local electrical codes
and any other applicable codes.
WARNING
y ELECTRICAL SHOCK HAZARD.
Failure to follow the instruc­tions in this manual could result in serious injury or death.
y Electrical ground is re-
quired on this appliance.
y Do NOT modify the power sup-
ply cord plug. If it does not t the outlet, have a proper outlet installed by a qualied electrician.
y Do NOT use an exten-
sion cord with this unit.
y The unit should be grounded ac-
cording to local electrical codes to prevent the possibility of electri­cal shock. It requires a grounded receptacle with separate electrical lines, protected by fuses or circuit breaker of the proper rating.
y Check with a qualied electrician
if you are unsure if the appli­ance is properly grounded.
RACKS
BULKHEAD
P/N 1010736 Rev. G 05/14
Loading...
+ 14 hidden pages