Aiwa CDC-X927M YUC User Manual

OPERATING INSTRUCTIONS MANUAL DE INSTRUCCIONES MODE D’EMPLOI

CDC-X927M

STEREO CAR CD RECEIVER RADIO-TOCADISCOS DE CD ESTEREOFONICO PARA AUTOMOVIL

YUC

ENGLISH ESPAÑOL FRANÇAIS

OWNER’S RECORD

For your convenience, record the model number and serial number (you will find them on the bottom side of your set) in the space provided below. Please refer to them when you contact your AIWA dealer in case of difficulty.

Model No. CDC-X927M Serial No.

8C-KC4-901-01 020131ATM-OX

PRECAUTIONS

• Use only in a 12-volt DC negative-ground electrical system.

• Disconnect the vehicle’s negative battery terminal while mounting and connecting the unit.

•

When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit.

• Do NOT attempt to disassemble the unit. Laser beams from the optical pickup are dangerous to the eyes.

• Make sure that pins or other foreign objects do not get inside the unit; they may cause malfunctions, or create safety hazards such as electrical shock or laser-beam exposure.

• When your vehicle has been parked in direct sunlight resulting in a considerable rise in the temperature inside, allow the unit to cool off before operating it.

• Keep the volume at a level at which you can hear outside warning sounds (horns, sirens, etc.).

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

— Reorient or relocate the receiving antenna. — Increase the separation between the equipment

and receiver.

— Connect the equipment into an outlet on circuit

different from that to which the receiver is connected.

— Consult the dealer or an experienced radio/TV

technician for help.

CAUTION

Modifications or adjustments to this product that are not expressly approved by the manufacturer may void the user’s right or authority to operate this product.

TABLE OF CONTENTS

THEFT PROTECTION .............................................. 2

BASIC OPERATION, AUDIO AND CLOCK

ADJUSTMENT ..................................................... 2

RADIO OPERATION................................................. 3

CD PLAYER OPERATION ........................................ 4

AUXILIARY EQUIPMENT ......................................... 5

OTHER FUNCTIONS ............................................... 5

CARD REMOTE CONTROL ..................................... 6

CD CHANGER OPERATION.................................... 7

TROUBLESHOOTING .............................................. 7

MAINTENANCE ........................................................ 8

SPECIFICATIONS .................................................... 8

CD Notes

• Playing a defective or dusty CD can

cause dropouts in sound.

• Hold CDs as illustrated.

• Do NOT touch the unlabeled side.

• Do NOT attach any seal, label or data

protection sheet to either side of a disc.

• Do NOT expose a CD to direct sunlight or excessive

heat.

• Wipe a dirty CD from the center outward with a cleaning

cloth. Never use solvents such as benzine or alcohol.

• This unit cannot play 3-inch (8 cm) CDs.

• NEVER insert a 3-inch CD contained in the adapter or

any irregularly shaped CD. The unit may not be able to eject it, resulting in a malfunction.

DEMO (Demonstration) mode

The unit has an extra display mode, which demonstrates the display of the operation modes of the unit. The unit switches to DEMO mode automatically if you turn the unit on and leave it as it is for 5 seconds after all the connections have been completed.

To cancel DEMO mode

1 Press and hold SRC until “CONT.” appears on the

display.

2 Press TUNE i or TUNE k until “DEMO.” appears

on the display.

3 Turn AUDIO CONTROL to select “DEMO. OFF”.

To resume DEMO mode, select “DEMO. ON” in step 3.

In addition to ordinary CDs, CD-Rs or CD-RWs can be read by this unit. However, NEVER use a CD-R or CD-RW that contains no data or data in the wrong format, such as MP3 or other computer files.

ENGLISH

THEFT PROTECTION

(Retractable Front Panel)

When your car’s ignition switch is turned off, the front panel will be retracted automatically as if there were no car audio in the console. When the ignition switch is set to ACC or ON position, the front panel will appear automatically.

Note

Do not touch and put excessive pressure on the front panel while it is rotating.

BASIC OPERA TION, AUDIO AND CLOCK ADJUSTMENT

AUDIO CONTROL TUNE

SEL DISP SRC

PWR/MUTE BAND

Turning the unit on/off

• You can turn the unit on by pressing any button on the front panel except z. The unit also turns on when you press z and insert a CD.

• Press and hold PWR/MUTE until the unit turns off.

Note

Most operations described in this manual require the unit to be turned on before starting the operation, unless explicitly stated otherwise.

Changing the source mode

1 Press SRC.

Pressing SRC cycles through source modes in the following order:

* To select another bands, press BAND to select F2,

F3, A1, A2, while “F1” is displayed.

** “DISC” does not appear on the display when there is

no CD in the unit.

***CD Changer Play mode (available when an optional

CD Changer is connected)

EJECT

Adjusting the volume

1 Turn AUDIO CONTROL.

VOL (volume) indication appears.

Muting the sound

1 Press PWR/MUTE briefly.

MUTE indicator flashes.

To restore volume, briefly press PWR/MUTE again.

Adjusting sound

You can select the following modes for adjusting sound depending on the music you listen to: BASS (low frequencies), TRE (high frequencies), BAL (left/right), FAD (front/rear), H-BASS (high bass)*, DSSA (Drivers Sound Stage Adjustment)** and BBE***. * You can reinforce the bass sound. ** You can adjust sound stage and tone balance to best

serve a particular seat in the car.

*** You can enhance the clarity of high-frequency sound.

1 Press SEL repeatedly to select the mode to be

adjusted. Pressing SEL cycles through the modes. The selected mode’s indicator appears.

2 Turn AUDIO CONTROL to increase or decrease

the level for the selected mode (except for H-BASS, DSSA and BBE). In H-BASS mode, turn AUDIO CONTROL to select 1, 2, 3, or OFF. In DSSA mode, turn AUDIO CONTROL to select L (for the front left seat), R (for the front right seat), or OFF. In BBE mode, turn AUDIO CONTROL to select 1, 2, or OFF.

Notes

• Adjust the level or select an item within 5 seconds, or the selected mode will return to previous state.

• When DSSA is activated, you cannot adjust BAL, FAD, BASS, TRE and BBE.

• When BBE sound is activated, you cannot adjust BASS and TRE.

Aligning the source levels

(Source Level Adjuster)

Volume may vary each time you change the source mode. In this case, you can align each source mode’s volume to almost the same level.

1 Press SRC repeatedly to select the desired mode. 2 Press DISP while pressing SEL.

“LEVEL 0” appears on the display.

3 Turn AUDIO CONTROL to adjust the level.

Note

Adjust the level within 5 seconds, or this function will be canceled.

ENGLISH

+ 7 hidden pages