Aiphone KB-DAR User Manual

83071700 0200®

KB Series

VIDEO DOOR STATION

Model: KB~DAR, Single-gang surface mount

INSTALLATION & OPERATION MANUAL

PRECAUTIONS ON INSTALLATION & WIRING

WARNING Negligence could result in death or serious injury.

1. When exisitng chime wires are used, be sure to locate and disconnect the bell transformer.

Unit damage or electric shock could result. Ask qualified personnel.

2. Do not change or alter KB-DAR. It can cause fire or electric shock.

3. Video door station is weather-resistant, but do not spray water directly on video door

station to prevent electric shock.

4. Make sure wires are connected properly before plugging in power supply. Fire or electric

shock could result.

GENERAL PRECAUTIONS - A mark indicates caution statement (incl. danger and warning), which is specifically shown inside.

GENERAL INSTRUCTIONS - • mark indicates contents which demand a specific action shown inside or attached.

GENERAL PROHIBITIONS: - Q mark indicates

contents which prohibit a specific action shown

inside or attached.

DISMANTLE PROHIBITIONS

® AlPHONE'

Package Contents

• Video door station

(KB-DAR)

• Packet of screws

• Hexagonal wrench

• Installation & Operation

Manual

1 SYSTEM OUTLINE & COMPONENTS

KB-DAR is a video door station for use with KB-3MRD system. Up to three KB-DAR's can be connected to master station.

KB-DAR

KB-DAR: Video door station. KB-3MRD: Master station.

---------------

NAMES & FEATURES

KB-DAR

White iight-------------------

When it becomes dark

outside, it automaticaiiy

turns on when CALL button is pressed. Can be set to OFF at inside monitor.

Speaker

Bracket case

Tamper-proof screw/cover

' Coior CCD camera

Mic.

CALL button Locator LED

Backlit for visibiiity in the dark

Do not cover water drainage holes with caulking seals.

: PS-24E

d INSTALLATION-----------------------------------------------

Wiring precautions

1. Keep video wires more than 30cm/1' away from AC 100 ~

240V power lines.

2. Employ 2-conductor parallel wires only.

Specify PE (polyethylene) insulation, vynil-sheathed. Coax-cable cannot be used. For other types, normal operation or max. communication distance cannot be guaranteed.

3. When existing cable is used, install a 1200 resistor at both

ends of unused wires.

4. Do not mix audio/video wires with those of another video door station or device. Extra cables

120 ohm

KB-DAR

Image view area (approx.) when tiited

•235om VERTICAL (tilting) HORIZONTAL

(7'9")-r^\ .

1130cm 50cmT /

(4'3") {20’)1 /

SOcmm^

(20")

Over view

*60cm

(2')

Mounting on KAW-D 30‘ Angle box

Mounting locations & height

Do not install a video door station in the following locations;

- Places subject to temperature/humidity extremes.

- Places near dust, vapor, smoke and chemicals.

- Places where a call is strongly backlit (bright background).

- Places where direct sunlight or strong light comes into the

camera lens.

Mounting locations Mounting height

120 ohm

KAW-D

KB-DAR

KB-3MRD

Door I—I

KAW-D

(OPTION)

Features • 2-conductor non-polarized wiring

• White LED light auto turn on or off

• Single-gang surface mounting

4 WIRING DIAGRAM

Hexagonal wrench

KB-DAR Screw cover

Single-gang surface mounting

Pull the cover up and outward.

6 OPERATIONS -------------------------------------------------------

Calling

Momentarily press CALL button on video door station. After room station replies, talk hands free in front of camera.

Instant-On audio/video

After chime tone sounds, inside stations see image and hear audio of door without lifting handset.

TECHNICAL PRECAUTIONS

Caulking seals

Cleaning: Clean KB-DAR with a soft cloth

Do not apply any caulking seals around video door station. Water drainage holes on bottom will help water or moisture to dissipate.

dampened with neutral household cleaner and cloth. Do not spray high-pressure water on video door station.

8 SPECIFICATIONS

Power source:

Current consumption:

Communication: Picture element: Night viewing:

Ambient temperature: Housing: Color: Dimensions:

Weight:

Max. 22V DC (approx.), supplied by master station. Standby 12V DC (approx.). Max. 260mA (approx.). Standby 5mA (approx.) Simultaneous in open voice. 1/4 inch color CCD. Up to 30cm (1') in front of camera. White LED light projects up to 30cm (1') away. Back ground scene over 30cm (1') can not be seen.

- 10"C ~ 60"C (14"F~ + 104T). Fire-retardant ABS plastic.

Gray.

105Wx140Hx44D(mm).

4-1/8"W X 5-1/2"H X 1-3/4"D. 300g (0.66 lbs.) approx.

This equipment has been tested and found to eomply with the limits for a Class B digital deviee, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and ean radiate radio frequeney energy, and if not installed and used in aecordance with the instruetions, may cause harmfiil interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfiil interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving anteima. • Coimect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Increase Ae separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician for help.

-5-

Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for a period of two years after delivery to the ultimate user and will repair free of charge or replace at no charge, should it

-5-

■>*-

become defective upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto itself the sole right to make the final decision whether there is a defect in materials and/or workmanship; and whether or not the product is within the warranty. This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in

-Í-

-Í*

violation of instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This warranty does not cover batteries or damage caused by batteries used in connection with the unit. This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by

-I-

Aiphone. Aiphone will not be responsible for any costs incurred involving on site service calls.

-Í-

AIPHONE CO., LTD., NAGOYA, JAPAN AIPHONE CORPORATION, BELLEVUE, WA, USA AIPHONE EUROPE N.V., ANTWERP, BELGIUM

KB-DAR-I(E) 0200A

WARRANTY

COMMUNICATION SYSTEMS

-Í-

AIPHONE

HOME, BUSINESS, INDUSTRY.

Printed in Japan (E)