Aiphone Ix-dvf-ra, Ix-dvf-p, Ix-dvf-l, IX-SSA-2RA, Ix-ssa-ra User Manual

Installation Manual

IX Series

Networked Video Intercom System

IX-DV, IX-DVF, IX-DVF-P, IX-DVF-2RA, IX-DVF-RA, IX-DVF-L,
IX-SSA, IX-SSA-2RA, IX-SSA-RA

Introduction

• Read this manual before installation and connection. Read the "Setting Manual" and "Operation Manual". The manuals
can be downloaded from our homepage at “

• After completing installation and connection, program the system according to the "Setting Manual". The system cannot
operate unless it is programmed.

• After performing installation, review with the customer how to operate system. Leave documentation accompanying the
Master Station with the customer.

https://www.aiphone.net/support/software-document/” free of charge.

• Perform installation and connection only after gaining sufficient understanding of the system and this manual.

• The illustrations used in this manual may differ from the actual stations.

Literature information

The important information concerning correct operation and what you should observe is marked with the following
symbols.

This symbol means that operating the device incorrectly or ignoring these precautions may

Warning

Caution

cause severe injury or death.

This symbol means that operating the device incorrectly or ignoring these precautions may
cause severe injury or property damage.

This symbol is intended to alert the user to prohibited actions.

This symbol is intended to alert the user to important instructions.

Precautions

Warning

Do not disassemble or modify the device.

May cause fire or electrical shock.

Do not use with a power supply voltage
above the specified voltage.

May cause fire or electrical shock.

Do not install two power supplies in parallel
to single input.

Fire or damage to the unit could result.

Do not connect any terminal on the unit to
AC power line.

Fire or electric shock could result.

Caution

Do not install or connect the device with the
power on.

May cause electrical shock or malfunction.

Do not turn on power without first checking
to make sure the wiring is correct and there
are no improperly terminated wires.

May cause fire or electrical shock.

Negligence could result in death or serious injury.

Negligence could result in injury to people or damage to property.

For power supply, use Aiphone power supply
model specified for use with system.

If non-specified product is used, fire or

mulfunction could result.

Do not, under any circumstances, open up the
device.

Voltage within some internal components may

cause electrical shock.

The device is not designed to explosion-proof
specifications. Do not install or use in an
oxygen room or other such locations filled

with volatile gases.

May cause fire or explosion.

Do not put your ear close to the speaker when
using the device.

May cause harm to the ear if a sudden loud noise

is emitted.

- 1 -

General Precautions

• Install low-voltage lines at least 30cm (11") away from high-voltage lines (AC100V, 200V), especially inverter air conditioner
wiring. Failure to do so may result in interference or malfunction.

• When installing or using the device, give consideration to the privacy rights of subjects, as it is the responsibility of the system
owner to post signs or warnings in accordance with local ordinances.

Notice

• If the device is used in areas where there are business-use wireless devices such as a transceiver or mobile phones, it may
cause malfunction.

• If the device is installed close to a light dimmer, an inverter electrical appliance or the remote control unit of a hot-water system
or floor-heating system, it may create interference and cause a malfunction.

• If the device is installed in an area with an extremely strong electrical field, such as in the vicinity of a broadcasting station, it
may create interference and cause a malfunction.

• If warm air from inside the room enters the unit, the internal and external temperature difference may cause condensation on
the camera. Plugging of cable holes and other gaps where warm air might enter is recommended for preventing condensation.

Precautions for mounting

• If installed in the place where the sound is easy to echo, it may be difficult to hear the conversation with echoed sounds.

• Installing the device in locations or positions such as the following may affect the clarity of the image:

– Where lights will be shining directly into the camera at night time

– Where the sky fills much of the background

– Where the background of the subject is white

– Where sunlight or other strong light sources will shine directly into the camera

Where the sky fills much of
the background

Sky

Where the background of
the subject is white

White

wall

Where sunlight or other strong light sources
will shine directly into the camera

• In 50Hz regions, if a strong fluorescent light shines directly into the camera, it may cause the image to flicker. Either shield the
camera from the light or use an inverter fluorescent light.

• Installing the device in the following locations could cause malfunction:

– Locations that get hot

Close to a heater, boiler, etc.

– Locations where there is risk of exposure to liquid, dust, oil, or chemicals

– Locations with high humidity

Bathroom, basement, greenhouse, etc.

– Locations with low temperature

Inside a cold storage warehouse, the front of a cooler, etc.

– Locations directly exposed to steam or oil smoke

Next to heating devices or a cooking space, etc.

– Sulphurous environments such as a hot spring area

– Locations close to the sea or directly exposed to sea breeze

• If existing wiring is used, the device may not operate properly. In that case, it will be necessary to replace the wiring.

• Do not, under any circumstances, use an impact driver to fasten screws. Doing so may cause damage to the device.

- 2 -

Table of contents

Literature information ...................................................................................1

Precautions ..................................................................................................1

Example of System Configuration................................................................4

Part Names and Accessories.......................................................................5

Part Names .................................................................................................................. 5

Included accessories .................................................................................................... 8

IX-DV .............................................................................................................................................. 8

IX-DVF, IX-DVF-P, IX-DVF-2RA, IX-DVF-RA, IX-DVF-L, IX-SSA, IX-SSA-2RA, IX-SSA-RA ....... 8

Status Indicator ............................................................................................8

How to Install ...............................................................................................9

Video Door Station Installation ..................................................................................... 9

IX-DV (surface mount) ................................................................................................................... 9

IX-DVF, IX-DVF-P, IX-DVF-2RA, IX-DVF-RA, IX-DVF-L, IX-SSA, IX-SSA-2RA,

IX-SSA-RA (flush mount) ............................................................................................................. 10

Camera View Area and Mounting Location (IX-DV, IX-DVF, IX-DVF-P, IX-DVF-2RA,

IX-DVF-RA, IX-DVF-L) ............................................................................................... 11

Camera view adjustment .............................................................................................................. 11

Camera view range ...................................................................................................................... 11

How to Connect .........................................................................................12

Connection Precautions ............................................................................................. 12

Cat-5e/6 cable .............................................................................................................................. 12

Precautions regarding low-voltage line ........................................................................................ 12

Wiring Connection......................................................................................13

- 3 -

Example of System Configuration

PoE switch
(third party)

PoE switch
(third party)

PoE switch
(third party)

PoE switch
(third party)

IX-DVFIX-DA

IX-MV

LAN

Network video

recorder

(third party)

PC (third party)

Network camera

(third party)

PoE switch

(

third party

IX-SS-2G

IX-RS-BIX-MV7-HB

PoE switch
(third party)

)

PoE switch

(

third party

IXW-MA

)

- 4 -