Aiphone GF-HID-I Instruction Manual
HID iClass™ Smart Card Reader Module for GF Entrance Panel
- INSTRUCTIONS -
The GF-HID-I is an Access Control module for the GF Entrance Panel that contains an HID iClass Card Reader. This
module installs into the entrance panel and cosmetically matches, so a separate card reader does not need to be
installed. The card reader provides electronic access to a building through the standard Access Control system, which is
not supplied by Aiphone.
INSTALLATION:
1. Install GF-HID-I card reader module in the GF entrance panel. (Install in a lower position for ease of access).
2. GF-HID-I will snap into the GF-2F or GF-3F frame.
3. Secure wire connections as shown on wiring chart.
4. Cut any unused wire so that bare wires are not exposed.
5. Refer to standard GF Installation Manual for complete system information. No additional information pertaining to
the Access Control system is provided by Aiphone.
GF-HID-I
(front view)
LED Power &
Activation Indicator
Connecting the Reader to the Host:
Connect the reader to the host according to the
wiring table below and the host installation guide.
Wiegand Wire Color
+ DC Red
Ground Black
--- Violet
Data0 Green
Data1 White
Shield Ground Drain
Green LED Orange
Red LED Brown
Beeper Yellow
Hold Blue
18" pigtail cable
GF-HID-I
(back view)
To Host
Page 1
TYPICAL LAYOUTS:
123
456
789
0
#
*
Video with 4 buttons and
iClass® reader
Audio with 4 buttons
and iClass® reader
Digital audio with iClass®
reader
Digital video with iClass®
reader
TESTING AND OPERATION:
When power is applied to the
iClass® reader, the LED will turn RED while the beeper beeps
simultaneously 3 times. (The last tone is a higher frequency). The LED will then flash once after the last
tone. This indicates that the microcontroller is operating properly.
Present an ID card to the reader. (Hold card directly in front of and within one inch of the reader module.
In some cases, the card may need to actually touch the reader.) The LED will momentarily turn green
while the beeper beeps once, indicating that the card was read successfully.
SPECIFICATIONS:
Power Source: 10 – 16 VDC / 65 – 225mA
Current Requirements: 80mA (Avg); 300mA (peak) at 12VDC
Transmit Frequency: 13.56 MHz
Terminations: Color-coded pre-wired pigtails
Wiring Distance: 500'
Dimensions (H x W x D): 3 ¾” x 4 3/16" x 1 7/8"
Operating Temperature: -10° ~ 60° C / 14° ~ 140° F
Operating Humidity: 5% to 95% relative humidity non-condensing
123
456
789
0
#
*
FCC WARNING:
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may cause undesired operation.
For proper regulatory compliance, the drain wire should be disconnected at the
power supply end of the cable.
Changes or modifications not expressly approved by the party responsibl e for
compliance could void the user’s authority to operate the equipment.
The Reader is intended to be powered from a limited power source output of a
previously certified power supply.
Aiphone Communication Systems
1700 130th Ave. N.E.
Bellevue, WA 98005
(425) 455-0510
FAX (425) 455-0071
TOLL FREE TECHNICAL SUPPORT: (800) 692-0200
TOLL FREE FAX LINE: (800) 832-3765
E-MAIL: tech-serv@aiphone.com
GF-HID-I Instr.
0605PHJS
Loading...