Ag Leader Versa DirectCommand Injection Reference Guides

Create Conguration

Enter Settings

DirectCommand
Direct Injection

Start of Conguration wizard

TM

There is a tab for each pump

Controller Settings screen

Pump Calibration

Factory Calibration

number found on pump speed sensor, pulses/10
uid ounces, divide by 10 and enter number, once

Rate Response Warning

Flow Monitor Warning

entered, number should not be changed

Perform Calibration

pump will not run until calibrated, calibrate at
beginning of season and when repairs are made

Error Threshold and Error Delay

duration and error allowed before alarm is
displayed

Error Threshold

percentage of perceived application error allowed
before displaying ow sensor warnings

Enable Warning

option of displaying Flow Monitor Warning

PN 206311 Rev A

1

DirectCommand
Direct Injection

To start the Field Operation Wizard and load a conguration:

To view run screen:

Product Control Toolbox

To change values shown on Product Tab and in Product Control
Toolbox, go to the next page where the Rate Control Settings
screen is explained.

TM

Target Rate

desired amount of product to apply

Actual Rate

actual rate of product being applied as

determined by the ow sensor

Product in Tank

Target Rate #1 & #2

preset application rates that allow a quick change between rates

Manual Valve Control

allows operator manual control of valve

Prescription

allows rates to be determined by a loaded prescription

Up and Down Arrows

allow rates to be adjusted manually

Settings button

opens Rate Control Settings screen (explained on next page)

PN 206311 Rev A

2

To access the Rate
Control Settings window:

DirectCommand
Direct Injection

TM

Rate 1 and Rate 2

allows operator to set desired target rates

Increment

values when using up and down arrows in the Product Control Toolbox

Prescription

press to load a map-based prescription le

Minimum Flow

used to set a minimum application rate for injection pump

Tank Full

press to ll container

Tank Partially Filled

press to specify container amount

Tank Empty

press to empty container

Tank Alarm Settings

set % or amount remaining for low container alarm

PN 206311 Rev A

3

DirectCommand

TM

Direct Injection

Injection Controls button

number of injection controllers in conguration, green when product is
being dispensed

Prime

prime each time you ush/rell a tank, or
change products

Agitate

Allows operator to enable the agitation
system on the injector tank

PN 206311 Rev A

4