Agilent 86120C Installation Guide

Installation Guide

Soft Carrying Case

For protecting HP 86120A/B/C instruments.

HP Part No. 5962-5909
Printed in USA
March 1996

First Edition

© Copyright Hewlett-Packard Company 1996
All Rights Reserved. Reproduction, adaptation, or translation without prior
written permission is prohibited, except as allowed under copyright laws.

Hewlett-Packard Company
Lightwave Operations
1400 Fountaingrove Parkway
Santa Rosa, CA 95403-1799, USA
[phone]

Notice.

The information contained in this document is subject to
change without notice. Companies, names, and data used in examples
herein are fictitious unless otherwise noted. Hewlett-Packard makes no
warranty of any kind with regard to this material, including but not lim­ited to, the implied warranties of merchantability and fitness for a par­ticular purpose. Hewlett-Packard shall not be liable for errors
contained herein or for incidental or consequential damages in connec­tion with the furnishing, performance, or use of this material.

Restricted Rights Legend.

Use, duplication, or disclosure by the U.S.
Government is subject to restrictions as set forth in subparagraph (c)
(1) (ii) of the Rights in Technical Data and Computer Software clause
at DFARS 252.227-7013 for DOD agencies, and subparagraphs (c) (1)
and (c) (2) of the Commercial Computer Software Restricted Rights
clause at FAR 52.227-19 for other agencies.

2

7R #LQVWDOO#WKH#VRIW#FDVH

To install the soft case

1. Open the soft carrying case, and place it on the floor as shown on the
following page.

2. Set the instrument on the case as shown in the figure. The
instrument should be resting on it’s feet in the normal operating
position.

CAUTION If the instrument is placed upside down on the soft case, the case’s front flap

could be damaged when it is closed.

3. Fold the top of the soft case over the instrument.

4. Fold up one of the soft case’s side panels, and locate the zipper that
joins the side panel to the soft case’s rear panel.

5. Close the zipper all the way to the front of the case.

6. Zipper the remaining side panel in place.

7. Open the soft case’s rear ventilation flap, and attach the power cord
to the instrument.

CAUTION Operating the instrument with the soft case’s rear flap closed causes

overheating and could damage the instrument. Always open the flap before
turning on the instrument.

3

To install the soft case

4