Page 1
Part Number 30-2012
Fluid Temperature Sensor
Kit Contents:
1 x Fluid Temp Sensor
1 x Mating Connector
1 x Connector Lock
3 x Terminal
Specs:
Thread Size 1/8”NPT
Hex Size ½”
Typical Voltage Supply 5 Vdc
Operating Temperature
Sensor Tip -40C to 200C
Connector -40C to 150C
Typical Pullup Resistor 2K2 Ohms
Wire Size 22AWG TXL
Pinout:
One wire to sensor ground
One wire to sensor signal
Polarity does not matter
Crimper:
Delphi 12039500 or equivalent
Wire Strip Length:
0.175” to 0.200”
50.6
16.64
14.00
11.64
5 .60 DIA
AEM Performance Electronics
th
2205 126
Phone: (310) 484-2322 Fax: (310) 484-0152
Street Unit A, Hawthorne, CA. 90250
http://www.aemelectronics.com
Instruction Part Number: 10-2012 Rev 01
© 2011 AEM Performance Electronics
Page 2
Figure 1. Insert Terminals and Lock
Voltage 2.2K
Temp Temp Res
pullup
Temp Temp Res
degC degF Ohms Volts degC degF Ohms Volts
-40 -40 402K 4.97 60 140 2.7K 2.74
-35 -31 289K 4.96 65 149 2.2K 2.52
-30 -22 210K 4.95 70 158 1.9K 2.30
-25 -13 154K 4.93 75 167 1.5K 2.09
-20 -4 114K 4.91 80 176 1.3K 1.88
-15 5 85.0K 4.87 85 185 1.1K 1.70
-10 14 64.3K 4.83 90 194 965 1.52
-5 23 48.9K 4.78 95 203 826 1.37
0 32 37.5K 4.72 100 212 710 1.22
5 41 29.0K 4.65 105 221 613 1.09
10 50 22.5K 4.56 110 230 531 0.97
15 59 17.7K 4.45 115 239 462 0.87
20 68 14.0K 4.32 120 248 403 0.77
25 77 11.1K 4.18 125 257 352 0.69
30 86 8.9K 4.01 130 266 309 0.62
35 95 7.2K 3.83 135 275 272 0.55
40 104 5.8K 3.63 140 284 241 0.49
45 113 4.7K 3.42 145 293 213 0.44
50 122 3.9K 3.20 150 302 189 0.40
55 131 3.2K 2.97
Voltage 2.2K
pullup
Table 1. Temperature Calibration
12 MONTH LIMITED WARRANTY
Advanced Engine Management Inc. warrants to the consumer that all AEM High Performance products will be free from defects in
material and workmanship for a period of twelve (12) months from date of the original purchase. Products that fail within this 12month warranty period will be repaired or replaced at AEM’s option, when determined by AEM that th e product failed due to defects
in material or workmanship. This warranty is limited to the repair or replacement of the AEM part. In no event shall this warranty
exceed the original purchase price of the AEM part nor shall AEM be responsible for special, incidental or consequential damages
or cost incurred due to the failure of this product. Warranty claims to AEM must be transportation prepaid and accompanied with
dated proof of purchase. This warranty applies only to the original purchaser of product and is non-transferable. All implied
warranties shall be limited in duration to the said 12 month warranty period. Improper use or installation, accident, abuse,
unauthorized repairs or alterations voids this warranty. AEM disclaims any liability for consequential damages due to breach of any
written or implied warranty on all products manufactured by AEM. Warranty returns will only be accepted by AEM when
accompanied by a valid Return Goods Authorization (RGA) number. Product must be received by AEM within 30 days of the date
the RGA is issued.
Please note that before AEM can issue an RGA for any product, it is first necessary for the installer or end user to contact the AEM
Performance Electronics tech line at 1-800-423-0046 to discuss the problem. Most issues can be resolved over the phone. Under
no circumstances should a system be returned or a RGA requested before the above process transpires.
Page 2
Loading...