AEG-Electrolux ZC4570AT User Manual

Commercial Upright Vacuum Cleaner Owner’s Guide

Z4500 Series

Index

Important Safeguards ........... 2

Service Information ............... 4

Assembly............................5-6

Use........................................ 7

Thermal Cut Off...............4 & 7

Accessories........................... 8

Brush Roll.............................. 9

Brush Roll Belt..................9-10

Dust Bag ........................ 10-11

Hose Blockage ...............12-13

Filters .................................. 14

Micron Filter ........................ 14

Problem Solving .................. 16

Warranty.............................. 17

www.electrolux.com

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.

WARNING

To reduce the risk of fire, electric shock, or injury:

• Do not use outdoors or on wet surfaces.

• This appliance is provided with double insulation. Use only identical replacement parts. See instructions for Servicing of

Double-Insulated Appliances.

• Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and

before servicing.

• Do not allow to be used as a toy. Close attention is necessary when used by or near children.

• Use only as described in this manual. Use only manufacturer’s recommended attachments.

• Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left

outdoors, or dropped into water, return it to a service center before using.

• Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do

not run vacuum cleaner over cord. Keep cord away from heated surfaces.

• Do not use extension cords or outlets with inadequate current carrying capacity.

• Turn off all controls before unplugging.

• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

• Do not handle plug or vacuum cleaner with wet hands.

• Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that

may reduce airflow.

• This vacuum cleaner creates suction and contains a revolving brush roll. Keep hair, loose clothing, fingers, and all parts

of body away from openings and moving parts.

• Do not place cleaner on furniture or stairs as the brush roll may cause damage. Place cleaner on floor with the handle in

storage position while using attachments.

• Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.

• Do not use without dust bag in place.

• Belt pulleys can become hot during normal use. To prevent burns, av oid touching the belt pulley when servicing the drive

belt.

• Use extra care when cleaning on stairs.

• Do not use to pick up flammable or combustible liquids such as gasoline, or use in areas where they may be present.

• Store your cleaner indoors in a cool, dry area.

• Keep your work area well lighted.

• Unplug electrical appliances before vacuuming them.

SAVE THESE INSTRUCTIONS

BEFORE Y OU ST ART

CHECK THE VOLTAGE

First check the voltage shown on the data plate (see rear view) to make sure that the cleaner is of the correct voltage for your electricity supply. If it is not, do not use the cleaner but refer back to your dealer.

CONNECTING TO YOUR ELECTRICITY SUPPLY

Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux Retailers and must be of the same colour as indicated by the coloured insert on the base of the plug. If difficulty is experienced in obtaining a replacement, contact Electrolux on 08706 055055.

In no circumstances must the plug be used without a correct fuse cover fitted.

If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home. The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. Brown: Live. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. This cleaner is double insulated and no earth connection is necessary. It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the guarantee.

Fuse Cover

13 Amp Fuse

Fuse

Blue

WARNING

The brush in the cleaning head rotates at high speed and can cause damage to the mains supply cable if the cleaner passes over it during cleaning operations.

Care should be taken to ensure that this does not happen. If the cleaning head has accidentally passed over the mains supply cable the following action should be taken:

1. Switch off and remove the plug from the socket outlet.

2. Examine the mains supply cable for damage (only after removing the plug from the socket outlet).

3. If there is any sign of damage to the supply cable it MUST be renewed. The repair MUST be carried out by an Electrolux Service

Agent or a similar qualified person.

4. NEVER use the machine with a damaged mains supply cable. Proprietary carpet conditioning and air freshening materials

After using proprietary car pet conditioning powders, it is recommended that the dust cup or filters be changed. Some of these preparations contain substances which if left in the vacuum cleaner f or extended periods could damage the plastic mouldings which form the structure of the cleaner. Many air fresheners, household deodorants, sprays and polishes contain a highly flammable gas propellant. Because of this, it is particularly impor tant that these products are used strictly in accordance with the relevant manufacturer’s instructions. It is essential that none of the above products are sprayed directly into the vacuum cleaner or any of its filters, hose assembly, dust cup chamber or dust cup.

Brown

Cord Clamp

Thermal Cut Off

This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly shuts off, push the switch pedal once and unplug the cleaner. Check the cleaner for a possible source of overheating such as a full bag, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 60 minutes before attempting to use the cleaner. After the 60 minute period, plug the cleaner back in and turn on the switch. If the cleaner still does not run, please call Electrolux on 08706 055055.

SERVICE

Should you require service on your Electrolux cleaner, please telephone 08706 055055. Before requesting service, please check whether your problem is covered under Service Checklist (see below).

New filter pads, brush rollers and drive belts can be obtained from Electrolux Dealers. If difficulty is experienced in obtaining spares, please contact 08706 055055.

SERVICE CHECKLIST

• If your cleaner will not operate, check the plug connection, plug fuse and mains fuse.

• Never allow the dust cup to become so full that it impedes the air-flow, thus reducing the cleaning efficiency of the machine. The character of household dust and its effect on the air-flow through the machine may vary considerably. Fluffy dust allows air to pass through readily whereas fine powdery dust or proprietary cleaning powders, pack tightly in the dust cup, offering greater resistance to air-flow and will reduce cleaning efficiency if it becomes overloaded.

• Always store your cleaner in a dry place.

• Renew the filter pads three or four times a year. This is essential to ensure continued high filtration of dust particles.

• Sucking up such items as stockings, clippings of cloth, sizeable pieces of paper, wrappings from cigarette packets or sweets etc., may block the hose. Electrolux regrets that the clearing of blocked hoses cannot be regarded as service that can be given free of charge, under the guarantee. Should a blockage occur, first disconnect the cleaner from the electricity supply, refer to section headed “Blockages.” If these operations are not successful, contact 08706 055055.

• Never pick up hot cinders or lighted cigarette ends.

• Make certain that your cleaner does not come into contact with water or any other liquid. It is not designed as

a wet pick up cleaner, and must never be used on damp carpets or wet floors.

Important - in the event of the mains supply cable of this vacuum cleaner requiring replacement, we recommend that this be carried out by a Electrolux Service Agent.

Guarantee

This guarantee is in addition to your statutory and other legal rights.

Electrolux products are carefully designed, manufactured, tested and inspected and, in consequence, we undertake to replace or repair any part found to be defective in material or workmanship, within one year of delivery to the original purchaser, free of charge. You may be required to take the product to your nearest service provider if the product requires attention during the first year.

There are certain conditions which may invalidate this guarantee: a. It is dependent upon the appliance being correctly installed and used in accordance with the Company’s instructions

under normal domestic conditions within the United Kingdom or the Republic of Ireland.

b. Service at all times must be carried out by an Electrolux Service Representative or authorised agent. c. The guarantee may be invalidated by unauthorised repair or modification of the appliance. d. You may be charged by Electrolux if you call for an engineer to resolve a problem that we believe is covered in the

instruction booklet.

The Company does not accept liability for defects arising from neglect, misuse or accident. This guarantee excludes such normal wearing parts as drive belts, brushes and filters as the life of these depends upon the amount and nature of use.

Proof of the date of purchase will be required before service under guarantee is provided. Please call 08706 055055 for assistance.

Important:

For future reference we suggest you record the following details here, and keep the receipt with the handbook as proof of purchase.

Purchased from_____________________________________________ Date purchased______________ Model no ______________________

LUTON, BEDFORDSHIRE, LU4 9RJ

Features of the Electrolux vacuum cleaner and accessories supplied with it are protected in Great Britain and abroad by Patents or Registered Designs. This appliance conforms with the requirements of the amended E.E.C. directive No. 89/336/EEC relating to electromagnetic compatibility (EMC) CE. Electrolux, may introduce modifications to their product from time to time, and consequently the details given in this booklet are subject to alteration without

notice.

HOW TO ASSEMBLE

CAUTION: Moving parts, make sure on/off switch is in off position before plugging in. CAUTION: Assemble the cleaner before using.

NOTE: Features may vary by model yet all parts assemble the same.

Step A Attach Handle

CAUTION: Do not catch cord under handle.

Groove

Electrical

Cord

Groove

Step B Attach Hose

Ledge

Tab

1. From rear of cleaner, align handle with groo ve and slide onto cleaner. If necessary, use thumb and finger pressure to slide handle into position.

2. Once handle is in place, check that the electrical cord is not pinched between the unit and the handle. Push excess cord back into the hole provided in the back of the handle.

3. Attach handle with two 5/8 inch screws in the assembly packet. Use a Phillips® head screwdriver.

1. Before placing the front cover on the unit, install the hose.

2. Locate the tab on the hose adapter (shortest end).

3. Look at the opening on the top of the cleaner and locate the ledge. The tab on the hose adapter will be under the ledge in the opening when hose is installed properly .

4. Push hose adapter into opening and rotate until tab is under ledge. If installed proper ly, the hose cannot be lifted out of the hose opening.

Hose Adapter

Paper Bag Collar

1. Check to be sure the paper bag collar is secure with the hose adapter inside the paper bag collar.

Step D Store Hose and AccessoriesStep C Check Disposable Dust Bag

Dusting Brush

Upholstery Tool

Crevice Tool

Carrying Handle

2. Replace front bag cover. Place the tabs on the bag cover in the slots at the bottom of the bag compartment. Using both hands, one on each side, press the bag cover firmly back against unit until latch clicks shut.

1. Wind the cord around the two cord hooks on the left side of cleaner. On some models the upper cord hook turns to release the cord. Turn the hook up to store the cord.

Telescoping Wand

Hose Retainer

Step E Store Electrical Cord

Cord Hook

+ 14 hidden pages