
lnstructions
@
for
use
Assembly
Fit the telescopic
tightly
using
from the start button: this serves onlv
during transport.
a wall
Select
wall socket. Check that the
floor and that it can be lifted out of
without difficulty.
mark where the fastening screws are to
When fitting using
push
they only
Wind any surplus cable
see Fig. 2.
on the bottom of
holder on the screws and tighten.
not be fitted outdoors or anywhere damp.
When connecting
household supply
the recharging unit's
bottom of the recharging holder and
into the socket.
plastic plugs
the
handle to the vacuum cleaner and fix it on
the enclosed screw.
position
project
The
for the
Hold the recharging holder against
plastic plugs,
into the wall and insert the screws until
by about 15 mm.
cable should
round the back of the recharging holder,
the recharging holder. Hang the recharging
the
electricity
current is the same as the current specified on
plate.
Remove the
recharging holder in the vicinity of a
vacuum
Connect
cleaner
the recharging holder
the holes using a 7 mm bit,
drill
pass
out between the two
The recharging holder
supply, check first that
the round
plug
piece
to
go,
the
secure
is
away
Fig. 1.
see
plug
the recharging unit
Recharging
-
The vacuum cleaner should
recharged.
-
only the original
Use
Put the vacuum cleaner
The charging
cleaner is
the
vacuum cleaner
When
recharged separately by connecting
to the vacuum cleaner, see
The vacuum cleaner should always be
holder when not in use:
maintained, which in turn
will always be ready
When the vacuum cleaner
hours
A fully charged battery
cleaning, depending on how
while cleaning.
-
The recharging unit will
perfectly
-
The vacuum cleaner should not be recharged where the
temoerature is below 0"C or above + 40'C.
lf the vacuum cleaner
should be
months.
indicator
recharging. The
necessary,
recharging are required before full capacity
of
normal.
kept in
is connected
the vacuum
for
a cool
be switched
recharger
in the
L comes
this
use
will suffice for about 19-25 minutes of
is to remain unused for long
place
when recharging.
recharging holder.
on,
charging
to
cleaner
ig.3b.
f
ensures
guarantees
to its full
is
completely
long the rotating
get
hot during recharging.
and recharged at least every 6
off before
f ig(3a).
which shows that the vacuum
indicator stays
the recharger.
(hand
unit) may be
the recharging
kept in the recharging
that the battery's charge is
that the vacuum
capacity.
discharged, about B-10
brush
periods,
Use
The vacuum cleaner should be charged
it is used for the first time.
before
When cleaning
Lift the
complete
Fig. 4. Adjust the telescopic handle to an appropriate
see
see Fig. 5. The
floor.
Cleaning using a
for
Used
Push the start button
indicated
The vacuum cleaner is fitted with automatic
which trips if the rotating brush becomes blocked.
the
by
operation indicator D on the nozzle
problem
cleaner:
floors
and carpets
vacuum cleaner
vacuum
cleaning
the operation indicator D on the
by
can be
cleaner
rotating brush
floors and shortpile carpets.
position
into
remedied
by completely turning
for
from the recharging holder,
is now ready for cleaning the
see Fig. 6. This
C,
10 hours
about
nozzle
motor
going
out. The
off the vacuum
protection
This is shown
plastic
of
button
start
from the
the wall
grooves
should
your
to the
it is
as long
on
plug
directly
cleaner
is restored.
is
used
This is
it
length,
position
coming on.
and
as
is
-
pushing
-
removing
-
then
The vacuum cleaner is then readv
Cleaning without
Used
Push the
Cleaning furniture, tables,
Detach the hand
detach the hand
The attachable nozzle is
difficult to
see Fig.8.
Cleaning the
-
Always turn
it.
Empty
Fig.
Detach the dust
the
-
Remove the
-
Empty the
-
Brush away
ordinary vacuum cleaner to
Put the
position.
Cleaning the brush
-
Always turn off the vacuum
The rotating
order to facilitate,
removal
round
the start button
whatever is blocking the
press
the reset
rotating
for
cleaning hard
start button into
unit by
unit
get
at,
between
dust filter/dust container
the vacuum cleaner
the dust container
9 and 10.
dust contanier
filter back into the
of threads and the
the brush roller.
container by first
dust filter from the
dust container.
dirt and dust from the filter. Hint:
brush is fitted with
by using a knife
back to
button E on the nozzle.
brush
floors and long-pile
position
car seats, etc.
pushing
from
the shaft.
used when cleaning
the
cushions
and clean the dust filter
downwards.
clean the filter.
dust container and snao it
cleaner before
cleaning
like, which have
lmportant information
-
Do
not use
flammable
allowed to
-
Do not vacuum
-
Do not
-
your
lf
is exposed,
-
Do not
Service Information
Should
your
for
to obtain consumables,
contact Electrolux
Care Helpline on
_{P^
(AA)
uV
\^/
X
Pb
1.
Switch
battery is completely
2. Release
3. Pull off the
Make
4.
The removed
point
your
vacuum
solvents have
dry out completely.
up
your
leave
vacuum
you
cleaner is
do not subject the
open or short the
require
Electrolux
cleaner on surfaces
been used until these have
glowing particles
vacuum
damaged and the lead-acid
assistance
cleaner
please
Customer
08706 055 055.
Note
Your cordless vacuum
acid battery which
give
and
However,
cordless
please
on
the hand
sure the battery is not
designed for
long life
should
vacuum cleaner
think
of
the
vacuum
flat and the
unrt and remove the
cables connected
battery must
disposal of waste
cleaner exposed to
battery.
or
can be recharged
and repeatedly full
you
protecting
cleaner and let it run
position
to be used
B,
the
off before attempting
pushing
dust container.
or
battery to intense heat.
one day find that
short
be returned
A, see Fig.
brush
aoain.
carpets
Fig.6.
see
catch G up, see Fig.7,
places
on chairs, for example;
button H, then twist
grooves,
pair
of scrssors, the
become trapped
which may
cleaner contains a lead-
need to
our environment:
cleaner
to the battery
circuited.
batteries.
which
after use,
you
can use
back into
cleaning it.
see Fig,
on which
cause a fire.
direct sunlight.
many times
power.
your
replaced.
be
until the
stops.
dust
container.
(Fig.
to a collection
6 and
and
are
to clean
see
your
11, in
been
battery
12).