Keep this user’s manual with your washing machine. If you sell your washing machine or give it away, make sure that it is
accompanied by its user’s manual. The new user can then be informed of how the washing machine operates and read relevant warnings.
These warnings have been written for your safety and for the safety of others. Please read these comments carefully before installing and using your washing machine. Thank you for your attention.
1.1. Usage
•When you receive your washing machine, unpack it or
have it unpacked immediately. Check its general
appearance. Make any reserves in writing on the delivery form and keep a copy.
•Your washing machine was designed for use by adults.
Make sure that children do not touch it or use it as a
toy.
•Do not modify or attempt to modify the characteristics
of this washing machine. This could be dangerous for
you.
•Your washing machine is intended for normal domestic
use. Do not use it for commercial or industrial purposes or for any purpose other than that for which it was
designed : to wash, to rinse and to spin.
•Unplug the power suplly plug and close the water supply tap every time after using your washing machine.
•Only wash articles that can resist machine washing.
Refer to the instructions on the label for each article.
•Do not wash underwear with bones, or any material
without hems, or torn materials in your washing
machine.
•Remember to remove all coins, safety pins, boraches,
screws, etc., before each wash. They can cause
serious damage if they are left in your washing.
•Do not put articles in your washing machine if you have
used a solvent, alcohol, trichloroethylene, etc., to
remove stains from them. If you must use these stain
removers, wait until the product has evaporated before
putting the articles in the drum.
•Collect all small articles such as socks, belts, etc., in a
small cloth bag or pillow case.
•Use the quantity of detergent indicated in the «proportioning of detergents» section.
•Always unplug the washing machine before cleaning it
and doing any maintenance.
1.2. Precautions against frost
•Switch the washing machine off by putting the program
selector to the «Off»
Off»* key.
•Unplug the washing machine.
•Screw in the water inlet pipe and install the drain pipe.
Water that remained in the pipes will then be evacuated,
thus preventing the formation of frost or ice that can damage your washing machine.
The next time you want to use your washing machine,
make sure that it is installed in a room in which the temperature is above 0°C.
*
position or pressing on the «On/
1.3. Scrapping
All materials marked with the symbol can be recycled.
Put them in a waste tip (ask for information from your municipal offices) so that they can be recovered and recycled.
When you take your washing machine to the tip, make sure
that everything that could be dangerous is out of service ;
cut the power supply cable flush with the surface of your
washing machine.
1.4. Protection of the environment
We recommend that the following instructions should be
followed to achieve savings in water and energy and therefore to contribute to protection of the environment:
•If possible, use the washing machine at full capacity
rather than with partial loads (however, do not overload
the drum).
•Only use the Prewash or Soak function for very dirty
washing.
•Use a detergent dose adapted to the water hardness
(see «proportioning of detergents» section) and to the
amount of washing and how dirty it is.
If your washing machine is exposed to temperatures below
0°C, take the following precautions :
•Close the tap and disconnect the water supply pipe.
•Put the end of this pipe and the drain pipe into a bowl
on the floor.
•Select the «Drain» programme and make sure it works
until it is complete.
*depending on model
3
2. WASHING MACHINE DESCRIPTION
1
2
2
1
1 - Control panel
2 - Lid opening handle
3 - Leveling screws
4 - Filter door
5 - Lever for moving the washing machine
4
5
3
3
The detergent dispenser
1 - prewash
2 - wash
3 - softener
(do not exceed the MAX mark)
4 - softener overflow (if overfilled).
4
2.1. The control panel
1 - Program selector and «Stop» position3 - Pushbuttons and their functions
2 - Display4 - «Sart/Pause» pushbutton
2
3
2.2. The display
Indications about the choosed programme
Temperature
1
3
COTTON12.45
Cycle end15.05
95°C 1000
Spinning speed
Rinse hold / Silence cycle
Supplementary options
4
Real time
End cycle time
4
3. CONFIGURATION OF YOUR
APPLIANCE
When your appliance is connected to the electrical
network, turn the programme selector on the Cotton position. You can then configurate your washing machine according the following parameters :
3.1. Language
When you switch on your washing machine for the first
time (programme selector on the cotton programme), the
language that will appear in the display window will be English.
Note: If you want to change this language, please follow
the following instructions :
•Press the "Spin " and "Options" buttons simultaneously for at least 2 seconds,
•Press the "Change" button to select the required language,
•Press the "Exit" button to confirm your choice.
3.3. Permanent extra rinse
Your washing machine is economical with water. But in
some cases, depending on the hardness of the water or if
you have sensitive skin, it may be useful to rinse with more
water.
•Press the "Options" button until the "Setup" option
appears,
•Press the "Change" button once to go into the "Setup"
option,
•Press the "Options" button to select the "Rinse +"
menu,
•Press the "Change" button to select the Rinse + option
or not (YES / NO in the display window),
•Press the "Exit" button to confirm your choice. Then
press it once more to go back to the programme selection
When "Rinse +" mode is selected two additional rinses
take place in the Cotton programmes and one extra rinse
for the Synthetics and Delicates programmes. In addition,
the symbol will appear in the options line in the display
window.
Langage :
ENGLISH
Options
Change
Exit
3.2. Clock
Setting the time is important because the end of cycle time
display depends on it. To set the time :
•Press the "Options" button until the "Setup" option
appears,
•Press the "Change" button once to go into the "Setup"
option,
•Press the "Options" button to select the "Clock" menu,
•The time changes in minute stages just by pressing
the "Change" button. The time changes in 10 minute
stages by holding the "Change" button down.
•Press the "Exit" button to confirm your choice. Then
press it once more to go back to the programme selection.
Rinse +
Yes
Options
Change
Exit
3.4. Brightness
To set the brightness of the display window:
•Press the "Options" button until the "Setup" option
appears.
•Press the "Change" button once to go into the "Setup"
option.,
•Press the "Options" button to select the "Brightness"
menu,
•Press the "Change" button to set the required brightness level,
•Press the "Exit" button to confirm your choice. Then
press it once more to go back to the programme selection.
Clock :16.04
Set time :
Options
Change
Exit
Brightness :
I--------->--------I
5
Options
Change
Exit
3.5. Contrast
To set the contrast of the display window :
•Press the "Options" button until the "Setup" option
appears,
•Press the "Change" button once to go into the "Setup"
option,
•Press the "Options" button to select the "Contrast"
menu,
•Press the "Change" button to set the required contrast
level,
•Press the "Exit" button to confirm your choice. Then
press it once more to go back to the programme selection.
Contrast :
I--------->--------I
Options
Change
Exit
3.6. Audible signal volume
To set the audible signal volume:
•Press the "Options" button until the "Setup" option
appears,
•Press the "Change" button once to go into the "Setup"
option,
•Press the "Options" button to select the "Sound" menu,
•Press the "Change" button to set the required sound
level : normal, low, no sound,
•Press the "Exit" button to confirm your choice. Then
press it once more to go back to the programme selection.
SOUND :
Normal
Options
Change
Exit
6
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.