AEG-Electrolux EPE800 User Manual
Specifications and Main Features
- Model: EPE 800
- Cooling capacity: 2100 W / 7200 Btu/hr
- Heating capacity: 1500 W
- Power consumption (cooling): 850 W
- Power consumption (heating): 1550 W
- Power consumption (dry): 1500/1100 W
- Dehumidification in cooling: 1,0 Vhr
- Dehumidification in dry: 1,4 Vhr
- Air delivery: 340 cu m/hr / 220 CFM
- Indoor fan speeds: 3 + AUTO
- Electrical supply: 220-240 V / 1 Ph / 50 Hz
- Fuse rating: UK 15 Amp (delayed action)
- Dimensions: 800 mm (H) x 470 mm (W) x 340 mm (D)
- Weight: 46 Kg
- Optimal operation temperature range: Indoor 15-36C / 59-97F
- Modes of operation: Cooling, Heating, Auto Cooling/Heating, Dry, Fan
- Customer features: FEEL Function, Timer Operation, Table of Sleep Function, Remote control operation, Memory function, Filter Indicator, Buzzer Indicator, Hot Keep feature, 3-min delay timer for initial operation.
Frequently Asked Questions
Q: What is the cooling capacity of the EPE 800? A: The cooling capacity is 2100 W/7200 Btu/hr.
Q: Can the unit also provide heating? A: Yes, the EPE 800 can provide heating with a capacity of 1500 W.
Q: Tell me how I can set the timer for the air conditioner.
A: To set the timer, select the TIMER mode and set the turn ON or turn OFF time with the up and down buttons.
Q: I want to know what to do when the Units filter indicator goes up.
A: This indicates the filter requires cleaning. Remove the filter, clean it and re-activate the position.
Q: Is it possible to run of the unit without using the remote?
A: Yes, you can use the air conditioner from the indoor unit control panel.
Q: What are the warning indications for the compressor?
A: If the operating indicator shows blinking light then that may shows that the compressor is in high pressure mode.
Q: Tell me what happens when the water overflow indicator lights up.
A: This means that the drainage tube is blocked or the water pan is full, and there is a need to remove the blockage or to empty the water pan.
Q: In what way can I activate the 'sleep mode'?
A: In order to enable sleep mode and change the room temperature to that which is adequate for sleeping, you have to press the ‘SLEEP’ button available on the remote control device.
Q: For which reason is the FEEL option required?
A: For providing a custom setting, the FEEL function changes the remote control from sensing to the location of the thermostat.
User Manual
Loading...