AEG EFC9540X, EFC6540X, EFC7540X User Manual

USER MANUAL

CH910

We were thinking of you

when we made this product

IMPORTANT SAFETY INFORMATION 4

YOUR APPLIANCE 5

OPERATING INSTRUCTIONS 6

MAINTENANCE AND CLEANING 8

SOMETHING NOT WORKING 11

GUARANTEE/CUSTOMER SERVICE 12

GUARANTEE CONDITIONS 13

INSTALLATION INSTRUCTIONS 15

ELECTRICAL CONNECTIONS 16

INSTALLING THE COOKER HOOD 17

Welcome to the world of Electrolux

Thank you for choosing a ﬁ rst class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You ﬁ nd some examples on the cover in this manual. Please take a few minutes to study this manual so that you can take advantage of the beneﬁ ts of your new machine. We promise that it will provide a superior User Experience delivering Ease-of-Mind. Good luck!

electrolux 3

Guide to use the instruction book

The following Symbols will be found in the text to guide you through the instruction book

Safety instructions Step by step instructions

4 electrolux IMPORTANT SAFETY INFORMATION

IMPORTANT SAFETY INFORMATION

These warnings are provided in the interests of your safety. Ensure that you

understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these

warnings contact the Customer Care Department.

Installation

• Any installation work must be undertaken by a qualiﬁ ed electrician or a competent person.

• This hood must be installed in accordance with the installation instructions and all measurements must be adhered to.

• If the cooker hood is installed for use above a gas appliance then the provision for ventilation must be in accordance with the Gas Safety Codes of Practice BS.6172, BS.5440 and BS.6891 (Natural Gas) and BS.5482 (LP Gas) 1994, the Gas Safety (Installation & Use) Regulations, the Building Regulations issued by the Department of the Environment, the Building standards (Scotland) (Consolidated) Regulations issued by the Scottish Development Department.

• The fan motor of this cooker hood incorporates a cut-out device which will operate if the cooker hood is installed below the minimum height recommended under section ‘Clearance Height’, or if the motor becomes overheated. If the cutout device is activated, switch off the fan motor and allow the cooker hood to cool. The cut-out device will reset itself when the fan motor has cooled signiﬁ cantly.

• It is dangerous to alter the speciﬁ cations or modify this product in any way.

• When installed between adjoining wall cabinets the wall cabinets must not overhang the hob.

• If the room where the hood is to be used contains a fuel burning appliance such as a central heating boiler then its ﬂ ue must be of the room sealed or balanced ﬂ ue type.

• If other types of ﬂ ue or appliances are ﬁ tted ensure that there is an adequate supply of air to the room.

• The ducting system for this appliance

• Do not install above a cooker with a high

Child Safety

• This appliance is designed to be operated

During Use

• This product is for domestic use only.

• Never leave frying pans unattended during

• Never do flambé cooking under this

• Do not leave naked ﬂ ames under the

• This cooker hood is designed to extract

Maintenance and Service

• This appliance can be a hazard if the

• Under no circumstances should you

must not be connected to any existing ventilation system which is being used for any other purpose.

level grill.

by adults. Children should not be allowed to tamper with the controls or play with the appliance.

use as over-heated fats and oils might catch ﬁ re.

cooker hood.

hood.

unpleasant odours from the kitchen, it will not extract steam.

synthetic paper and charcoal ﬁ lters are not replaced as recommended.

attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or more serious malfunction. Refer to your local Electrolux Service Force Centre. Always insist on genuine spare parts.

YOUR APPLIANCE AND OPERATING INSTRUCTIONS electrolux 5

YOUR APPLIANCE

740

490 60

108

598-698-898-1198

300

150

870

260

1200

650 min.

6 electrolux YOUR APPLIANCE AND OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.

The hood can be switched on pushing directly onto the requested speed without

ﬁ rstly having to select 0/1 button.

L T1 T2 T3 T4 T5 F

Touch Basic functions

Dual Function

When brieﬂ y pressed it switches the lighting system on/off.

When pressed for 2 seconds it starts the lighting system in “courtesy light" mode.The lamps are fed at a reduced power of approximately 5W. Such function can be stopped by pressing the touch control for 2 seconds or just by pressing it shortly in order to return to the normal lighting mode. In courtesy light mode the touch control is not lit.

When pressed the motor is stopped, regardless of the speed it is set to.

When pressed the motor is set to the ﬁ rst speed

By a brief pressing the motor is set to the second speed.

By pressing the touch control for approximately 2 seconds the Delay function is enabled, i.e delayed shutdown of the appliance ensuring a complete elimination of the residual odours. This function can be activated at OFF- position and at 1°, 2° and 3°speeds. It can be stopped in advance by pressing any of the touch controls (T) with the exception of T3. The Delay function works according to the following scheme:

1°speed / OFF = 20 minuets 2°speed =15 minutes 3°speed = 5 minutes

Indicator lights

Touch control unlit Lights off

Touch control lit Lights on

Touch control unlit Courtesy light on

Touch control lit Motor on

Touch control unlit Motor off

Touch control lit

Touch control lit Second speed on

Flashing touch control Delay function on

When pressed the motor is set to the third speed Touch control lit

When pressed the motor is set to the intensive speed timed to 5 minutes. At the end of 5 minutes of intensive speed the hood starts again at the speed it was set to previously. In case the hood is set to the intensive speed directly from OFF-state it will then start from the ﬁ rst speed after 5 minutes of intensive speed.

When pressed for 4 seconds it resets the ﬁ lter alarm s- ignal indicated by ﬂ ashing of the touch control T1.This procedure can be carried out only when the motor is stopped.

Touch control lit Metal grease ﬁ lters saturation

Flashing touch control Charcoal odour ﬁ lter saturaion

Touch control lit

alarm.Metal grease ﬁ lters need to be washed.The alarm starts up after 100 working hours.

alarm.Charcoal ﬁ lter has to be replaced and metal grease ﬁ lters washed.The alarm starts up after 200 working hours.(Activation; check the paragraph "Odour ﬁ lter")

To Operate

Select the required fan speed and light if required.

electrolux 7

Recirculation

In the recirculation mode the contaminated air enters the cooker hood through the grease ﬁ lters. The air is cleaned by passing through the charcoal ﬁ lters before being passed back into the kitchen through the grilles in either side of the chimney stack.

Extraction

In the extraction mode the contaminated air enters the cooker hood passing through the grease ﬁ lters and is passed out through the ducting into the atmosphere. To obtain the best performance when cooking it is advisable to switch the cooker hood on for a few minutes before you start cooking and leave it running for about 15 minutes after ﬁ nishing.

When used in the ducting mode the

charcoal ﬁ lters are not required.

Never do ﬂ ambé cooking under this

cooker hood.

Never leave frying pans unattended

during use, as over-heated fats and oils can catch ﬁ re.

Do not leave naked ﬂ ames under the

cooker hood.

Ensure heating areas on your hob

are covered with pots and pans when using the hob and cooker hood simultaneously.

8 electrolux MAINTENANCE AND CLEANING

MAINTENANCE AND CLEANING

Before carrying out any maintenance

or cleaning isolate the cooker hood

from the mains supply.

The cooker hood must be kept clean,

as a build up of grease or fat can be a ﬁ re hazard.

External Cleaning

Wipe the cooker hood frequently with warm soapy water using a mild detergent.

Never use scouring pads or abrasive

cleaners.

Never use excessive amounts of wa-

ter when cleaning particularly around the control panel.

Metal Grease Filters

The ﬁ lters are washable and must be cleaned when the F-Touch control lights up or at least every 2 months of operation, or more frequently for particularly heavy usage.

Remove the metal grease

ﬁ lters one at a time by:

Releasing the catches on the ﬁ lters, the ﬁ lters can be removed.

The metal grease ﬁ lters should be washed, by hand, in mild soapy water or in a dishwasher. Allow to dry completely before replacing.

Alarm signal reset

Stop the motor. Press the F-Touch control for

at least 4 seconds until the T1-

Touch control ﬂ ashes.

MAINTENANCE AND CLEANING electrolux 9

Before carrying out any maintenance

or cleaning isolate the cooker hood from the mains supply.

Charcoal Filters

In the recirculation mode the charcoal ﬁ lters absorb smells and unwanted odours.

Enabling the alarm signal

• In Recirculation Version Hoods, the Filter saturation Alarm must be enabled at the time of installation or later.

• Switch off the lights and the motor.

• Disconnect the mains power supply to the hood by removing the motor unit power supply cable connector, switching off the power supply at the Mains or turning the Main switch off.

• Restore the connection, pressing and holding T2.

• Release the touch control, touch controls L, T2 and F will light up normally.

• Within 3 seconds press the touch control F until the key itself ﬂ ashes to conﬁ rm as follows:

•2 ﬂ ashes – Charcoal odour Filter saturation Alarm ENABLED

•1 ﬂ ash - Charcoal odour Filter saturation Alarm DISABLED

This ﬁ lter cannot be washed or regenerated, and must be replaced when the F touch control starts to ﬂ ash, or at least once every 4 months. The alarm is only triggered when the motor is on.

To Remove/Replace the

Charcoal Filters

• Remove the metal grease ﬁ lters

• Remove the saturated activated carbon ﬁ lter by releasing the ﬁ xing hooks

• Fit the new ﬁ lter by hooking it into its seating

• Replace the metal grease ﬁ lters.

This appliance can be a possible ﬁ re

hazard if the grease and charcoal ﬁ l- ters are not cleaned and replaced as recommended.

Alarm signal reset

• Stop the motor.

• Press the touch control F for at least 4 seconds, until the touch control T1 ﬂ ashes.

+ 19 hidden pages