AEG EA3255 User Manual

207 4895 01

Gebrauchsanleitung 3
Mode demploi 6
Instruzioni per luso 9
Operating instructions 12
Gebruiksaanwijzing 16
Instrucciones de manejo 19
Bruksanvisning 22
Håndbok 25
Betjeningsvejledning 28
Käyttöohje 31

EA3255

miniCool

®

S

N

DK

SF

D AT CH

F LU

I

GB

NL

E

IE

BE

2

12

IMPORTANT

First make sure that the appliance has not
been damaged in transit. If any dam-age
has been incurred, please inform the
supplier immediately.

Please read these instructions carefully.
Keep the instructions in a safe place and
make sure that they are retained with the
refrigerator when the appliance is trans­ferred to a new location or owner.

Note! If this refrigerator is replacing a
larger one which is going to be scrapped,
remove the door before disposal to pre­vent children from becoming trapped in­side.

Please contact the relevant area refuse
office to arrange disposal. The pipe sys­tem of your refrigerator must not be
damaged if technically correct disposal is
to be guaranteed.

If possible, please take the packaging of
your new refrigerator to the recycling
centre for your area.

Recommendation: before installation or
initial use of the appliance, clean the in­terior and fittings with lukewarm water
and, if necessary, a mild detergent. Never
use acidic, abrasive or strong-smelling
detergents or wax polishes!

Connecting to the mains

The refrigerator must only be connected
to the electricity supply using an earthed
socket outlet, installed in accordance with
local regulations. Before connecting the
refrigerator, check from the data la-bel
inside the cabinet that the voltage agrees
with your mains supply.

Plug connection (for United Kingdom
only).

If a 3-pin 13 amp fused plug is used, it
should be fitted with a 3 amp fuse; with
other plug types, the circuit should con­tain a 5 amp fuse.

Warning - This Appliance must be
earthed.

MOULDED-ON PLUG

The mains lead is fitted with a non­rewirable moulded-on 13 amp plug con­taining a 3 amp fuse. If the fuse requires
replacing at any time, the fuse
cover/carrier should be removed using a
small screwdriver to lever it out. The old
fuse should be replaced by a 3 amp ASTA
approved BS1362 fuse and the fuse
cover/carrier must be refitted before the
plug is used again.

If the fuse cover/carrier is lost, a re­placement can be obtained from
Electrolux Service Shops. The fuse
cover/carrier must be of the same colour
as that of the coloured insert in the base
of the plug. In no circumstances must the
plug be used without a correct fuse
cover/carrier fitted.

If the plug supplied on the mains lead is
not suitable for the socket in your home, it
should be cut off and disposed of safely,
or destroyed, to avoid any possi-ble shock
hazard resulting from the plug being
inserted into a 13 amp socket elsewhere
in the house. A suitable re-placement plug
should then be fitted as given below.

IMPORTANT

The wires in the mains lead of this appli­ance are coloured in accordance with the
following code:

GREEN-AND-YELLOW : EARTH
BLUE : NEUTRAL
BROWN : LIVE

GB