AEG CKE5015W User Manual

Electric cooker
INSTRUCTION BOOK
CKE5015W
U
2
Important Safety Information
These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. Keep this instruction book for future reference and ensure it is passed on to any new owner.
Installation
The work of installation must
be carried out by competent and qualified installers according to the regulations in force.
The appliance must be installed at a minimum distance of 50 cm from curtains or other combustible material.
Any modifications to the domestic electric mains, which may be necessary for the installation of the appliance, should only be carried out by qualified electrician.
This cooker is heavy. Take care when moving it.
Remove all packaging before using the cooker.
Ensure that the electrical supply complies with the type stated on the rating plate, located near the gas supply pipe.
It is dangerous to modify, or attempt to modify, the characteristics of this appliance.
This appliance cannot be positioned on a base.
The NON-TIP DEVICE must be fitted according to instructions to prevent the cooker from tipping, for example by a child climbing onto the open oven door.
Child Safety
This appliance has been designed for use by adults. Supervise children to ensure they do not attempt to play with it.
This appliance is not intended for use by young children of infirm persons unless they have been adequately supervised to ensure they can use the appliance safely.
The cooker gets hot when it is in use and retains heat for a long period after use. Children should be kept away until it has cooled.
Children can also injure themselves by pulling pans or pots off the cooker, they should be supervised at all times to ensure their safety.
Heating elements, plates, grills and pans remain hot for a long time after being switched off. Supervise children at all times when in use paying attention that they do not touch surfaces or remain in the vicinity of the appliance when in use or when not completely cooled.
During use
This cooker is intended for domestic cooking only. It is not designed for commercial or industrial purposes.
Do not use this cooker if it is in contact with water. Do not operate the cooker with wet hands.
Always grill with the oven door closed.
3
The grill pan will become hot
during use, always use oven gloves when removing or replacing a hot grill pan.
During use the appliance
becomes hot. Care should be taken to avoid touching heating elements inside the oven.
DO NOT store or use gasoline or other flammable vapours, liquids or items in the vicinity of this or any other appliance.
Do not spray aerosols in the vicinity of this appliance while it is in operation.
The oven must be switched off before removing the oven fan guard and after cleaning the guard must be replaced in accordance with the manufacturer's instructions.
Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.
Never use plastic dishes in the oven or on the hob hotplates. Never line any part of the oven with aluminium foil.
Unstable or misshapen pans should not be used on the hob hotplates as unstable pans can cause an accident by tipping or spillage.
Ensure the control knobs are in the ‘OFF’ position when not in use.
When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooker.
Never leave the cooker unattended when cooking with oil and fats.
This cooker should be kept clean at all times. A build-up of fats or foodstuffs could result in a fire.
Only clean this oven in accordance with the instru ctions.
In case of repairs, do not attempt to correct yourself. Repairs carried out by unqualified persons can cause damage. Contact the nearest Electrolux service Centre and use only original spare parts.
Always stand back from the oven when opening the oven door, to allow any build-up of steam or heat to release.
4
Always ensure that the oven vent, which is located at the centre back of the hob, is left unobstructed to ensure ventilation of the oven cavity.
Perishable food, plastic items and aerosols may be affected by heat and should not be stored above the cooker.
Before maintenance or cleaning disconnect the appliance and allow cooling.
Never use steam or high-pressure steam cleaners to clean the appliance.
Do no store flammable materials (e.g. aerosols, plastic aprons, paper baking sheets etc) in the warming drawer, it is only intended for warming of plates and baking trays.
Be careful when removing items from the warming drawer, as they may be hot.
Service
This cooker should only be repaired or serviced by an authorised Electrolux Service Engineer and only genuine approved spare parts should be used.
Your safety is of paramount importance. Therefore, if you are unsure about any of the meanings of these WARNINGS, contact the Customer Care Department.
These instructions are only valid in the country whose symbol appears on this instruction’s cover.
This product should not be treated as household waste. Instead it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
Environmental Information
After installation, please dispose of the packaging with due regard to safety and the environment.
When disposing of an old appliance, make it unusable, by cutting off the cable.
5
Contents
Instructions for the Installer
Technical features Location The safety equipment Electrical connections
Instructions for the User
Use and care Use of appliance Before the first use of the oven Electric oven Oven function control knob Using the Conventional Oven Hints and Tips Grilling Oven Cooking Chart Roasting/Grilling Chart Electric Hotplates Maintenance and Cleaning Oven bulb replacement Something Not Working Electrolux Warranty
7 8 9
11
13 14 14 15 15 16 16 17 19 20 21 25 28 29 31
Guide to Use the Instructions
The symbols below will guide you when
reading the instruction book
Safety instructions Step by Step Operation Advice and recommendations
Environmental Information
6
Instructions for the Installer
Technical features
Dimensions Height
Width Depth Oven Capacity
900 mm 500 mm 600 mm
45 l
Hob Front left
Back left Front right Back right
Oven Top element
Supply Rated voltage
Accessories Oven grid (2 pieces)
Total hob rating 5760 W
Bottom element Grill element Light in the oven Cleaning
Total oven rating 1925 W
Rated frequency
Roasting tray + roasting grid Total cooker rating
This appliance complies with:
European Council Directive 73/23/EEC EMC Directive 89/336/EEC CE Marking Directive 93/68/EEC, current edition.
Hob element Ø 180 mm Hob element Ø 145 mm Hob element Ø 145 mm Hob element Ø 180 mm
Lamp 25W type E14
2090 W 1050 W 1050 W 1570 W
1000 W
925 W
1925 W
manual
240V/415V
50 Hz
7685 W
7
Location
Qualified tradespersons must carry out installation work on the cooker. The cooker is heavy. Certain edges and corners, which will not normally be exposed, may be sharp. USE GLOVES when mov ing the cooker.
Before installing the cooker, you should check that its dimensions correspond to the rest of your kitchen units. Measure the height of the worktop from floor to top surface of the worktop, and the cooker depth from the wall to the front edge of the cooker (see picture). The cooker must also be installed in conformity with the following standards. Check the cooker cable is not trapped when moving the cooker.
The cooker may be located in a kitchen or dining room, but not in a bathroom or shower room. The levelling feet fitted to the appliance can be adjusted to achieve a nominal height to hotplate of 900mm + 10mm.
150
690
400
max
600
min
min
570
500
The cooker should be installed only on the floor, it is not suitable for installation on a
8
base.
The safety equipment
Leveling the cooker
The appliance is provided with adjustable small feet placed in the back and front corners of the base. Never pull the appliance by the oven handle. By adjusting the small feet it is possible to change the height of the appliance so as to ensure a better leveling with other surfaces and a uniform distribution of the liquids contained in pans or pots.
To check whether the cooker is level, use a spirit level on the hob surround. Check the level first front to back and then side to side.
Non-tip device
When installing the cooker it
is compulsory to install the non­tip device. The non-tip device should be fitted, to prevent the cooker from tipping if subjected to an abnormal loading, for example by a child climbing on to an open oven door. The non-tip device can only provide protection when the cooker is pushed into its normal position.
Before fitting the non-tip device, make sure the cooker has been leveled.
9
Draw a line on the wall – after leveling the cooker – along the top edge of the hob (see illustration).
The measurements shown can be applied when the non-tip device is fitted on the left (see illustration). Measure and mark where the non-tip device is to be placed. Attach the bracket to the wall with the fixings that are recommended for your wall type and then check that the bracket is secure enough to hold the cooker in place with weight applied to the open cooker door.
Due to the large range of wall types and different fixings required for each type, the fixings are not supplied, so the appropriate fixings should be obtained from a hardware store.
NOTE! If the space between kitchen units is wider than the cooker, you will need to alter the measurements shown in the illustration if the cooker is to be centered.
If you alter the measurements, remember to align the cooker correctly when pushing it into place, so that the non-tip device enters the hole on the cooker rear.
10
Electrical connections
Any electrical work required to install this cooker and the supply cable should be carried out by a qualified licensed electrician, in accordance with the current regulations.
This cooker must be earthed.
The manufacturer disclaims any responsibility should these safety instructions not be carried out.
Before any maintenance or cleaning can be carried out, you must DISCONNECT the cooker from the electricity supply.
This cooker is designed to be connected to a 240V/415V AC, 50Hz electrical supply. To connect to the electricity supply, use cable type H05 RR-F.
Before connection, make sure the electricity supply voltage is the same as that indicated on the rating plate.
The cooker is supplied without supply cable. A flexible supply cable must be fitted, in accordance with the specification give in the relevant table no. 1. The electrical connection should be made using a double pole isolating switch (cooker control switch) with at least 3 mm contact separation in all poles. The cable must have conductors of sufficiently high cross-sectional area to prevent overheating or deterioration.
The switch should be sited within
2m of the cooker and be easily accessible at all times.
The switch must not interrupt the yellow-green grounding cable.
NOTE: The earth wire should be about 2 cm longer than the live and neutral wires.
After installation and connecting, the cable must be placed so that it cannot at any point reach a temperature of more than 50°C above the ambient temperat ure.
Before connecting check that:
The fuse and household electrical installation can carry the absorbed current of the appliance (see rating plate);
The cooker connection outlet or the cooker control switch is easily accessible when the appliance is installed.
11
Loading...
+ 25 hidden pages