COMMERCIAL FREEZER
INSTRUCTION BOOK
CB 150GL CB 225GL CB 280GL CB 375GL CB 425GL
820 41 69 261264498
2
this appliance complies with the following EC Directives:
- 73/23/EEC of 19. 02. 1973 - Low-Voltage Directive
- 89/336/EEC of 03. 05. 1989 (including Amendment Directive 92/31/EEC - EMC Directive.
CONTENTS
SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 page
Warnings and Guidelines
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-5 page
Position
Electrical connections
Switching On
Fitting wheels
HOW TO USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 page
Packaging and Positioning
Temperature Control
Lock
Basket
MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 page
Defrosting
How to Clean Your Freezer
When Not in Use
3
SAFETY INSTRUCTIONS
WARNINGS AND GUIDELINES
These warnings are provided to improve safety, and should
be read carefully before installing or using your freezer.
This freezer is only intended for the selling and storage of
icecream and frozen food products.
This freezer should only be operated by adults. Children
must not be allowed to tamper with the control buttons or
play with the freezer.
Changes in the electrical mains system in connection with
the installation of this freezer should always be carried out
by an authorised electrician or competent person.
Do not under any circumstances attempt to repair the
freezer yourself. Repairs carried out by untrained people
may result in personal injury or serious malfunction of the
freezer.
Service of the freezer should be carried out by an
authorised service company, and only original spare
parts should be used.
It is dangerous to alter the freezer specifications, or to
change the freezer in any other way.
Make sure that the freezer is not placed on top of the mains
cable.
Do not re-freeze food once it has been defrosted.
This freezer includes components that are heated during
operation. Consequently, adequate ventilation must
always be provided. If ventilation is insufficient defects
may occur, resulting in the loss of food. See under
Installation.
The inside of the freezer contains pipes through which
coolant flows. If these pipes are punctured the freezer
may be damaged beyond repair, and food may be lost.
Do not use sharp implements to remove frost or ice.
Frost can be removed using the enclosed scraper. Do
not knock ice off the sides of the freezer, but remove it by
defrosting the freezer. See under Maintenance.
Do not place drinks in the freezer. Bottles and cans
containing carbonic acid or sparkling drinks are
particularly prone to explosion, which may damage the
freezer.
IMPORTANT
It is vital that these instructions are kept with the
freezer for future use. If the freezer is sold or
given to another user, or if you move and leave
the freezer behind, you must ensure that the
instructions accompany the freezer to enable
the next user to use the freezer correctly and
read the relevant warnings.
This freezer is heavy. Take care when moving it.
If the freezer is fitted with a lock to prevent tampering by
children, the key must always be kept safely out of the
reach of children, and far away from the freezer.
Before disposing of an old freezer, make sure that the lock
(if present) no longer works. This is to prevent accidents
and avoid the danger of children getting locked inside.
IN THE INTERESTS OF THE
ENVIRONMENT:
When disposing of your old fridge, freezer or fridge/freezer:
Check with your local Council or Environmental Health
Officer to see if there are facilities in your area for
collecting the gas from the appliance for recycling. This
will help reduce the amount of CFC gas released into the
atmosphere.
Help to keep your countr y tidy - when disposing of an
old appliance or a CFC free appliance use an authorised
disposal site.
POSITION
Place the freezer horizontally on a firm surface, resting on all
four wheels.
The room should be dry and adequately ventilated.
If the room temperature exceeds 32°C, or falls below 10°C,
the freezer will not function as it should.
Do not place the freezer close to sources of heat, radiators,
chimneys, etc., and do not place the freezer in direct
sunlight.
If the freezer has been handled standing on end it should be
allowed to stand in normal position for about 12 hours before
switching it on
Please ensure that when the appliance is installed it is easily
accessible for the engineer in the event of a breakdown.
SSWWIITTCCHHIINNGG OONN
Before switching on, the freezer should be cleaned inside.
See under Maintenance.
Allow the freezer to run for several hours before placing
food inside.
4
INSTALLATION
EELLEECCTTRRIICCAALL RREEQQUUIIRREEMMEENNTTSS
Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating
plate, located on the backside of the appliance.
WARNING:
This appliance must be earthed.
WARNING:
The enclosed wheels must be fitted before
switching on the freezer.Do not use the appliance
without the wheels because it may result
malfunction.
5
INSTALLATION
FITTING WHEELS
The wheels are fitted as shown in the drawing, using the
enclosed fitting key.
If the freezer is equipped with wheels with brake, you can
brake the freezer by pushing the brake down and you can
loosen it by pushing it up as shown in the figure.
To ensure the stabilization of the freezer you have to brake
two wheels at the same time.
6
PACKAGING AND POSITIONING
Food must be frozen before placing into the freezer.
Food must be packed in airtight and moisture-proof
packaging to pevent it from drying out.
Never fill the freezer above the load line" mark (see on
the figure) which can be found on the innerside of the
appliance.
TEMPERATURE CONTROL
The thermostat ensures that the required temperature is
maintained in the freezer. Adjust the temperature by turning
the button with a coin that fits the groove. Turning the
thermostat button towards no. 7 makes the temperature in
the freezer colder, and turning the button towards no. 1
makes the temperature warmer.
The correct setting can be found by measuring the
temperature of the top package in the middle of the freezer.
This should not have a temperature higher than -18°C.
The thermostat has been adjusted to the optimal position by
the manufacturer. Please do not adjust the thermostat
unless the temperature is permanently higher than -18 °C.
LOCK
(Not a standard accessory for all models.) The freezer can
only be locked when the upper lid is pushed to the left and
the lower lid is pushed to the right. Insert the key in the lock
and turn. The key can be removed. Remember to keep the
key out of the reach of children.
BASKET
(Not a standard accessory for all models.) The baskets are
designed for the storage of food which has already been
frozen. The baskets can be hung on the edge of the frame.
HOW TO USE
IMPORTANT
1. Before adjusting the temperature please
disconnect the appliance from the electricity
supply and remove the plastic grid from the right
side of the freezer.
2. Adjust the required temperature.
3. Fit the plastic grid to the appliance.
4. Reconnect the freezer to the electricity.
It is possible that the compressor does not start
immediately after a short-time disconnection from
the electricity supply.
WARNING
Before fitting the plastic grid to the freezer you must
not reconnect the appliance to the electricity.
7
DDEEFFRROOSSTTIINNGG
The formation of frost on the inside of freezers cannot be
avoided. Frost is formed when moisture contained in the air
comes into contact with the cold surfaces of the freezer.
Consequently, the lid should only be opened when
necessary, and it should never be left open.
A thin layer of ice or frost does not affect the function of the
freezer adversely, and can be removed carefully using the
scraper provided.
When the frost or ice layer is 10-15 mm thick, the freezer
should be defrosted. We suggest that you defrost your
freezer when there is little or no food inside.
Switch off the current. Remove the contents of the freezer
and leave them in a cold place.
The speed of defrosting can be increased by placing one or
more bowls of hot (not boiling) water inside the freezer and
closing the lid. Open the lid after a while, and remove the
layer of ice carefully.
The defrost water can be collected in a bowl as shown in
the drawing.
Do not try to speed up defrosting by using anything other
than hot water, since this may damage the freezer. After
defrosting, clean the inside of the freezer.
HHOOWW TTOO CCLLEEAANN YYOOUURR FFRREEEEZZEERR IINNSSIIDDEE
Remove the plug from the mains socket, and remove all
loose accessories before cleaning the freezer.
The best time to clean your freezer is after defrosting and
before the electricity supply is connected again.
Use a damp cloth to clean your freezer. Use hot water,
and a mild, non-aromatic cleaning agent.
After cleaning the freezer, clean the basket/baskets
before replacing them.
EEXXTTEERRNNAALL CCLLEEAANNIINNGG
Wash the outer cabinet with warm soapy water. Do NOT
use abrasive products.
WWHHEENN NNOOTT IINN UUSSEE
Disconnect the appliance from the electricity supply.
Remove all goods from the freezer.
Clean the freezer as described above.
Leave the lid slightly open.
MAINTENANCE
IMPORTANT
Never use a knife or any other sharp implement to
remove frost.
IMPORTANT
Never use strong cleaning agents, scouring
powder or strongly aromatic cleaning agents to
clean your freezer inside, since this will damage
the inside and leave a strong smell.
IMPORTANT
Remember to replace the plug in the drip water
drain.
Printed by Xerox Hungary Ltd.
Loading...