ADT Security Services D9412, D7412 User Manual

Security

System

Owner’s Manual

Supplement

Introduction

This reference supplements the Security System Owner’s Manual (71-06633-000) with the Function List features for
the D9412/D7412. The instructions for the commands listed in this reference are intended to replace those instructions
in the Security System Owner’s Manual. Please refer to the Owner’s Manual for the operation of your new security
system and its other basic Function List features.

NOTE: This supplement should be placed inside the Security System Owner’s Manual.

Access Level Control ............................................................... 3

Door Control Command 46 ...................................................... 5

Cycle Door ........................................................................... 5

Unlock Door ......................................................................... 6

Secure Door........................................................................ 6

Delete User Command 53 ........................................................ 7

Add/Change User Command 56 .............................................. 9

33267D 12/97

ACCESS LEVEL CONTROL

Description

Use this function to manually enable/disable access authority levels assigned to users. This function can be used to
temporarily disable a user’s access level instead of deleting and adding the user.

q

q

I have this feature.

I do not have this feature.

Using Access Level Control

1.Ensure the display shows idle disarmed text.

2.Press the MENU key to enter the Function List, then press NEXT repeatedly until you reach the CHANGE
LEVEL CTL? prompt. Press ENT.

3. ACCESS LEVEL CTL is displayed to remind you that you are affecting the authority levels of cards/tokens and
not passcodes. Press ENT.

4.ENTER LEVEL: is displayed. Enter the access authority level number and press ENT.

5.If the access level is currently disabled, LEVEL # ENABLE? is displayed. If the access level is currently
enabled, LEVEL # DISABLE? is displayed. Press ENT to accept the choice. ENTER LEVEL: is displayed
again. When you are finished, press ESC.

D9412/D7412 Owner’s Manual Supplement

Page 3

33267D 12/97