ADTRAN ATLAS 800 Series Quick Start Guide

For more detailed documentation, visit us online at www.adtran.com

QUAD T1/PRI MODULE P/N 1200185L3

NSTALLATION INSTRUCTIONS

1. Remove the cover plate from the appropriate option slot in the ATLAS 800 series rear panel.

2. Slide the Quad T1/PRI Module into the option slot until the module is firmly positioned against the front of the chassis.

3. Secure the thumbscrews at both edges of the module. Tighten with a screwdriver.

4. Connect the cables to the associated device(s).

5. Complete installation of remaining modules and Base Unit as specified in the Installation chapter of the ATLAS 800 series System Manual.

ETWORK CONNECTION PINOUT

Pin Name Description

1 R1 RXDATA Receive data from the network ring 2 T1 RXDATA Receive data from the network tip 3Unused n/a 4 R TXDATA Send data towards the network ring 5 T TXDATA Send data towards the network tip 6, 7, 8 Unused n/a

PECIFICATIONS

Line Rate 1.544 Mbps, ± 75 bps Capacity T1: 1-24 DS0s

PRI: 23 B+D

Line Codes AMI (alternate mark inversion) or B8ZS (bipolar

return to zero)

Framing D4 or ESF Tests Self-test, line loopback, payload loopback Connectors RJ-48C (eight-position, modular jack) Terminating Impedance 100 ohms ± 5%

QUAD T1/PRI MODULE P/N 1200185L3

ENU TREE

Part Number

Info Serial Number Slt T1/PRI Menus Board Revision Type PLL Status LOS Menu Module Alarms Alarm Status Prt Red

Modules Alarm Alarms Yellow

Test Rx Level Blue State Online Prt DS0 Alarm Rev Offline DS0 Status CLR

DS0 Alarms ES

Sig Status BES

Performance Curr, SEFS Port Name

15Min, and 24Hr LOFC Frame

Configuration Pulse Density Prt

Test Activity Remote LB

Test Clr

shortcut

SES Prt

CSS Code UAS Tx Yel LCV Tx PRM PCV LBO LES LB Accept

Loc LB

Pattern QRSS/RLB Results

Inj