Acu-Rite 75075, 75075W, 75075W1 User Manual
Instruction Manual
Weather Forecaster
models 75075/75075W/75075W1
CONTENTS
Unpacking Instructions ........... 2
Package Contents .................. 2
Product Registration ............... 2
Features & Benets: Sensor ..... 2
Features & Benets: Display .... 3
Setup .................................... 4
Sensor Setup ......................... 4
Display Setup ........................ 5
Intelli-Time® Clock .................. 6
Set the Time & Date ............... 6
Measurement Units ................ 6
Placement Guidelines ............. 7
Using the Forecaster............... 8
Troubleshooting ..................... 9
Care & Maintenance .............10
Specications ........................10
FCC Information ...................10
Customer Support ................. 11
Warranty..............................11
Questions? Contact Customer Support at
(877) 221-1252 or visit www.AcuRite.com.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
Congratulations on your new AcuRite product. To ensure the best
possible product performance, please read this manual in its entirety
and retain it for future reference.
Unpacking Instructions
Remove the protective lm that is applied to the LCD screen prior to using this
product. Locate the tab and peel off to remove.
Package Contents
1. Display unit
2. Outdoor sensor
3. Instruction Manual
PRODUCT MUST BE REGISTERED
IMPORTANT
PRODUCT REGISTRATION
Register online
to receive 1 year
warranty protection
www.AcuRite.com
TO RECEIVE WARRANTY SERVICE
Register a Product
►
Features & Benets
1
2
3
4
OUTDOOR SENSOR
1. Integrated Hanger
For easy placement.
5
2. Wireless Signal Indicator
Flashes when data is being sent to the
display unit.
3. Battery Compartment
4. A-B-C Switch
ID code that must match display’s A-B-C
switch to ensure units synchronize.
5. Battery Compartment Cover
2
Features & Benets
1
1516 14 13
2
3
4
DISPLAY UNIT
1. Learning Mode Icon
Disappears after weather forecast
self-calibration is complete.
2. 12 to 24 Hour Weather Forecast
Self-Calibrating Forecasting pulls data
from the outdoor sensor to generate your
personal forecast.
3. Current Barometric Pressure
4. Day of the Week
5. Display Unit Low Battery Indicator
6. Selected Time Zone
7. Intelli-time® Clock
Pre-programmed to the correct date
and time.
8 . Current Indoor Temperature
Arrow icon indicates the direction the
temperature is trending.
9. Date
12
11
10
8
5 6
77 9
10. Indoor Low Temperature Record
Lowest temperature recorded since
midnight.
11. Indoor High Temperature Record
Highest temperature recorded since
midnight.
12. Outdoor Sensor Signal Strength
13. Outdoor Low Temperature Record
Lowest temperature recorded since
midnight.
14. Outdoor High Temperature Record
Highest temperature recorded since
midnight.
15. Current Outdoor Temperature
Arrow icon indicates the direction the
temperature is trending.
16. Sensor Low Battery Indicator
BACK OF DISPLAY UNIT
17-19: ▲, ▼ & SET Buttons
For setup preferences.
20. RESET Button
Full reset to factory defaults.
21. A-B-C Switch
ID code that must match the
sensor’s A-B-C switch to ensure
units synchronize.
22. Battery Compartment
23. Battery Compartment Cover (not shown)
17
18
19
3
20 21 22
SETUP
Sensor Setup
Set the A-B-C Switch
1
The A-B-C switch is located inside
the battery compartment. It can
be set to A, B or C. However,
you must select the same letter
choices for both the sensor and
the display unit in order for the
units to synchronize.
Install or Replace Batteries
2
AcuRite recommends high quality
alkaline or lithium batteries for
the best product performance.
Heavy duty or rechargeable
batteries are not recommended.
The sensor requires lithium
batteries in low temperature
conditions. Cold temperatures
can cause alkaline batteries
to function improperly. Use
lithium batteries in the sensor for
temperatures below -4ºF / -20ºC.
1. Slide off the battery
compartment cover. Take
note of the A-B-C switch
setting inside the battery
compartment .
2. Insert 2 x AA batteries into
the battery compartment, as
shown. Follow the polarity
(+/-) diagram in the battery
compartment.
3. Replace the battery cover.
A-B-C Switch
1
set to match
display unit
A B C
Install Batteries
2
2 AA batteries
4
Loading...