ACTiSYS ACT-IR220Li, ACT-IR220LN User Manual
921 Corporate Way, CA 94539, USA
Tel: +1-510-490-8024 Fax: +1-510-623-7268
Web: http://www.actisys.com E-mail: irda-info@actisys.com
ACT-IR220Li / ACT-IR220LN
®
IrDA
Serial Port Adapter
User’s Manual
April 22, 2008
Version 1.3.1.1
© Copyright 1999-2008 ACTiSYS Corporation
All Rights Reserved
ACT-IR220Li&220LN
The Wireless Connectivity Expert
FCC & VCCI COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
WARNING-FCC Regulations state that any unauthorized changes or modifications to this
equipment not expressly approved by the manufacturer could void the user authority to
operate this equipment
NOTE: This equipment has been tested and found to comply with the limits for Class B digital
device, pursuant to Part 15 of the FCC Rules. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
User’s Manual
-Increase the separation between the equipment and receiver.
-Reorient or relocate the receiving antenna.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for helps.
This equipment is in the 2
area there to) and conforms to the standards set by the Voluntary Control Council For
Interference by Data Processing Equipment and Electronic Office Machines aimed at
preventing radio interference in such residential area.
When used near a radio or TV receiver, it may become the cause of radio interference. Read
the instructions for correct handling.
NOTE: Must be used with shielded cable only.
FOR YOU RECORDS
For your assistance in reporting this product in case of loss or theft, please record the model
and serial number, which are located on the bottom of the case. Please retain this
information.
Model Number: Serial Number:
nd
Class category (information equipment to be used in a residential
Date of Purchase: Place of Purchase:
z All indicated copyrights and trademarks in this document are copyrights and
trademarks of their respective corporations.
© Copyright 1999-2008 ACTiSYS Corp Page 2
of 10 Apr. 22,2008
Version 1.3.1.1
The Wireless Connectivity Expert
TABLE OF CONTENTS
ACT-IR220Li&220LN
User’s Manual
FCC & VCCI COMPLIANCE STATEMENT....................................................... 2
REVISION HISTORY............................................................................................ 4
1. PRODUCT INTRODUCTION ............................................................................... 5
1.1. ACT-IR220LN.......................................................................................................................5
1.2. ACT-IR220Li......................................................................................................................... 5
2. CONNECTOR PIN DEFINITION.......................................................................... 5
3. BAUD RATE SELECTION.................................................................................... 6
3.1. ACT-IR220Li - Level Mode..................................................................................................6
3.2. ACT-IR220LN – Preset (Hardware Jumper Setting) ............................................................ 6
4. TRANSMISSION CHARACTERISTICS.............................................................. 6
5. SPECIFICATIONS ................................................................................................. 7
6. MATERIAL COMPOSITION................................................................................ 7
7. REGULATORY SPECIFICATIONS ..................................................................... 8
7.1 Radiated and Conducted EMC .............................................................................................. 8
7.2 Susceptibility Compliance.....................................................................................................8
8. WARRANTY INFORMATION............................................................................. 9
9. CONTACT INFORMATION ............................................................................... 10
© Copyright 1999-2008 ACTiSYS Corp Page 3
of 10 Apr. 22,2008
Version 1.3.1.1
Loading...