ACTiSYS ACT-IR210L User Manual
The Wireless Connectivity Expert
48511 Warm Springs Blvd., Suite 206, Fremont, CA 94539
Tel: (510) 490-8024 Fax: (510) 623-7268
Web: http://www.actisys.com
, E-mail: irda-info@actisys.com
ACT-IR210L
IrDA Motherboard Adapter
User’s Manual
Feb. 14, 2006
Version 1.5.1
Copyright 2003-2006 ACTiSYS Corporation
All Rights Reserved
The Wireless Connectivity Expert
IR210L IrDA Motherboard Adaptor
User’s Manual
FCC & VCCI Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1)This device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
WARNING-FCC Regulations state that any unauthorized changes or modifications to this
equipment not expressly approved by the manufacturer could void the user authority to
operate this equipment
NOTE: This equipment has been tested and found to comply with the limits for Class B
digital device, pursuant to Part 15 of the FCC Rules. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-Increase the separation between the equipment and receiver.
-Reorient or relocate the receiving antenna.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for helps.
This equipment is in the 2
residential area there to) and conforms to the standards set by the Voluntary Control Council
For Interference by Data Processing Equipment and Electronic Office Machines aimed at
preventing radio interference in such residential area.
When used near a radio or TV receiver, it may become the cause of radio interference. Read
the instructions for correct handling.
NOTE: Must be used with shielded cable only.
FOR YOU RECORDS
For your assistance in reporting this product in case of loss or theft, please record the model
and serial number which are located on the bottom of the case. Please retain this
information.
nd
Class category (information equipment to be used in a
Model Number Serial Number
Date of Purchase Place of Purchase
All indicated copyrights and trademarks in the following pages are copyrights and
trademarks of their
Respective corporations.
Copyright 2003-2006 ACTiSYS Corp.
Page 2 of 14 Feb. 14, 2006
Ver. 1.5.1
The Wireless Connectivity Expert
IR210L IrDA Motherboard Adaptor
User’s Manual
TABLE OF CONTENT
REVISION HISTORY...................................................................................4
1) INTRODUCTION ..........................................................................................5
2) PARTS CHECK LIST ...................................................................................5
3) SYSTEM REQUIREMENTS........................................................................5
4) BIOS SETUP...................................................................................................5
5) WINDOWS 98/ME/2000/XP INSTALLATION GUIDE ...........................5
6) WINDOWS 98 UNINSTALLATION GUIDE ............................................6
7) WINDOWS ME UNINSTALLATION GUIDE ..........................................7
8) WINDOWS 2000 UNISTALLATION GUIDE ...........................................8
9) WINDOWS XP UNINSTALLATION GUIDE ...........................................9
10) TROUBLE SHOOTING..............................................................................11
11) SPECIFICATIONS ......................................................................................12
12) WARRANTY INFOMATION ....................................................................13
13) CONTACT INFORMATION .....................................................................14
Copyright 2003-2006 ACTiSYS Corp.
Page 3 of 14 Feb. 14, 2006
Ver. 1.5.1
The Wireless Connectivity Expert
IR210L IrDA Motherboard Adaptor
REVISION HISTORY
Revision History
Revision Date Comment
1.5.1 2/14/2006 Reformat the document
User’s Manual
Copyright 2003-2006 ACTiSYS Corp.
Page 4 of 14 Feb. 14, 2006
Ver. 1.5.1
The Wireless Connectivity Expert
IR210L IrDA Motherboard Adaptor
User’s Manual
1) INTRODUCTION
This document provides instructions to install the ACT IR210L IR Dongle along with Windows
98/ME/2000/XP device driver. It is assumed that the user is familiar with the basic operation of
Window 98/ME/2000/XP.
2) PARTS CHECK LIST
When you unpack the package, the following items should be found.
1. ACT-IR210L Adapter
2. 5 pins Motherboard Connector
3. User’s Guide
4. 5 pins to 6 pins changer
3) SYSTEM REQUIREMENTS
To use ACT-IR210L, your computer MUST meet the following requirements.
1. Window 98/ME/2000/XP.
2. Built in infrared I/O controller or super I/O chip on the motherboard with infrared connector
available and documented in the user’s manual.
4) BIOS SETUP
You MUST setup BIOS FIRST. It assumed that your IR Dongle would be installed to serial Com
port 2 before install the device driver.
1. Choose PNP & PCI from
BIOS SETUP
PNP OS Installed: NO
Resource Controlled by: Manual
2. Choose Integrated Peripherals from BIOS SETUP
Onboard UART2 Serial Port 2 : 2F8H/IRQ3
Onboard IR function: SIR, HPSIR or IrDA or 3/16 baud
RXD,TXD Active: Hi,Lo
IR Transmission delay: Disable
IR FUNCTION DUPLEX: HALF
IR Use Pins: IR-RX2,TX2
5) WINDOWS 98/ME/2000/XP INSTALLATION GUIDE
Copyright 2003-2006 ACTiSYS Corp.
Page 5 of 14 Feb. 14, 2006
Ver. 1.5.1
Loading...