ACT ACTPRO PRODUCT RANGE User Manual

Wiring for Entry/Exit Readers

ACTPro Product Range

1030/1040/1050/1060

ACT1050 Pin and Proximity

Reader (Entry)

ACT1030 Proximity

Reader (Exit)

Wire both readers in parallel but leave
the SENSE line on the Exit reader unconnected.

For Wiegand readers .
Wire both readers in parallel but connect D0
line of the exit reader into the SENSE line on
the controller,leave the SENSE line on the
Exit reader unconnected.

Wiring for Clock and Data / Wiegand Reader

White
Green

2 31

5 64

8 97

0

Controller

Sense
Clock
Data
+5v
0v
Red Led
Grn Led

Card/Prox Reader

Blue
Red
Black
Brown
Yellow
Orange

The standard wiring colours for
ACTPro Proximity and Pin readers
is shown above. Readers
should be a maximum of 30m
from the controller when powered

Sense
Clock / Data1
Data / Data 0
+5v
0v
Red Led
Grn Led
(Buzzer Ctrl)

from +5V and a maximum of 100m
when powered from +12V.

The above diagram is valid only
for clock-and-data type readers.

The +5V reader supply on ACT controllers is normally rated
at 100mA. Typically this is sufficient to power 2 ACT readers.
Note however that readers from other manufacturers may need
to be powered separately if their current requirements exceed
this or if they require 12V.

OMRON

02X X-1

AC TP ro R E V 1.3

00X XX X

0V

Red L ED

Grn L ED

Buzz Ctrl

Rear view of ACTPro 1040/1050/1060
connected to the ACT2000/1000/DS100

B AT C H:

P RO DUC T :

S ER IA L NUM BER:

0 1 2 3 4 5 6 7 8 9

1A 125VAC

1A 30VDC

OMRON

5A 30VDC
5A 250VAC

5-12V dc

Data / D0

Clock / D1

Sense

Internal buzzer is
activated by applying
0V to Buzz Ctrl

U nit 8 T allaght B usines s Centre, W hites tow n, T allaght, Dublin 24, Ireland.
Telephone: [phone]. T elefax : 353 1 462 2587. E -mail: sa les @ a cces scontrol. ie W eb: ww w.a cces scontrol. ie