Acer PD726 Quick Start Guide

Quick Start

LAN

AUDIO-OU T

RESET

ST

ATUS

WIRELE SS

Quick Start

INSTALLATION

1. Power Cord

2. VGA Cable

3. Composite Video Cable

4. USB Cable

5. 3 RCA Component Cable

6. S-Video Cable

7. Audio Cable Jack/RCA (Optional)

8. RS232 Cable (Optional)

9. DVI Cable (Optional)

10. HDMI Cable (Optional)

11. Lan Cable(RJ45 Port for 10/100M
Ethernet)(Optional)

12. Audio Cable Jack/Jack

with Wireless model

11

Internet

12

INTERFACE CONNECTOR

English

DVI

RGB

5

12

2

DVD Player,
Settop Box,

HDTV receiver

9

10

USB

4

6

7

S-Video Output

3

RS232

8

1

Video Output

Connecting to a Computer

1. Ensure the projector and your com­puter are turned off.

2. Connect one end of the VGA cable
to the “VGA In” connector on the
projector; connect the other end
to the VGA connector on the com­puter and tighten the screws.

3. Connect one end of the power cord
into the AC power socket on the
projector; connect the other end to

an electrical outlet.

Powering On the Projector

1. Open the lens cap.

2. Turn on the projector first and then
the computer.

3. Adjust the position, focus and zoom.

4. Run you presentation.

Powering Off the Projector

1. Press the power button twice.

2. Do not remote AC power cord from
outlet until the projector fan shut
down.

Quick Start

WIRELESS PROJECTION

To perform wireless projection, you have to install Acer eProjection Management

English

software utility to your PC. There is a Wireless Presentation Gateway (WPG) mod
ule integrated into the projector and the software is stored on the WPG. Please
follow the steps below to download and install the software.

To download the software, you must remove LAN cable from your PC
and ensure that your browser is set to open up a website.

-

1. Switch on your notebook, and activate the
wireless LAN.

2. Scan for available WLAN APs using your
preferred WLAN manager.

3. Select the AP labeled “AcerWirelessGate­way-” from the list of available APs. Con-

nect to this AP.

4. If you receive any security warnings, select
“Connect Anyway”.

5. Once the connection is established, open

your Internet browser. If the default Inter­net browser is set to a blank screen, just
enter the URL for any website. You will
automatically be taken to the Acer WPG
welcome page, where you will be able to
download the driver.

6. Click on the link to download and
install the driver. If you receive any se­curity warnings, click “OK” to proceed
with the installation procedure. Dur­ing the driver installation, your screen
may flicker.

7. Once the installation is complete, the
Acer WPG software will open.

8. Once you’re connected, the PC screen
will be projected and the WPG’s power
LED will turn green.