Manufacturer name, address
Acer Italy s.r.l,
Via Lepetit, 40, 20020 Lainate (MI) Italy
Product model number P6500, P6600
Standby mode power consumption 0.49 Watt
Off mode power consumption Not applicable
Networked standby mode power
consumption
Power consumption of the product in
networked standby if all wired network
ports are connected and all wireless
network ports are activated
For products with an display or light
source, the total content of mercury is
The default time after which the power
management function, or similar function,
has switched the equipment into standby
mode
The default time after which the power
management function, or similar function,
has switched the equipment into off mode
The default time after which the power
management function, or similar function,
has switched the equipment into another
condition which does not exceed the
applicable power consumption
requirements for off mode and/or standby
mode when the equipment is connected
to the mains power source.
The default time after which the power
management function, or similar function,
has switched the equipment into
networked standby mode
Technical justification that the
requirements set out in points 2(c) and/or
2(d) and/or 3(b), are inappropriate for the
intended use of equipment
Measurement methodology for standby
mode
According to IEC 62301:2011 and EN 50564:2011
Measurement methodology for off mode Not Applicable
Technical Documentation of (EC) No 1275/2008
Measurement methodology for networked
standby mode
According to IEC 62301 and EN 50564
Description of how standby mode was
selected or programmed
1. Plug in power cord, but no input source.
2. Will show the status by LED indicator. (LED will
show in steady RED color)
Description of how off mode was selected
or programmed
Sequence of steps for achieving a stable
condition with respect to power demand
Allow the Test Unit to warm up
(Power On) for a minimum of 20 minutes
Sequence of events leading to the
condition where the equipment
automatically changes to standby mode
1. To disable the network setting in OSD .
2. While system is on and with no singal after 15min,
will automatically switch to standby mode, or
3. While Security is on and no entering password,
system will automatically switch to standby mode.
Sequence of events leading to the
condition where the equipment
automatically changes to off mode
Sequence of events leading to the
condition where the equipment
automatically changes to networked
standby mode
1. To enable the network setting in OSD .
2. While system is on and with no singal after 15min,
will automatically switch to standby mode, or
3. While Security is on and no entering password,
system will automatically switch to standby mode.
Notes regarding the operation of the
equipment
Setting projector by OSD definition
Guidance on how to activate and
deactivate wireless network ports
Test parameter for ambient temperature 25 ℃
Test parameter for test voltage 230 V
Test parameter for frequency 50 Hz
Test parameter for total harmonic
distortion of the electricity supply system