Federal Communication Commission Interference
Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment o and on, the user is encouraged
to try to correct the interference by one of the following
measures:
tReorient or relocate the receiving antenna.
tIncrease the separation between the equipment and
receiver.
tConnect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
tConsult the dealer or an experienced radio/TV
technician for help.
FCC Caution: Any changes or modications not expressly
approved by the party
responsible for compliance could void the user’s
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
minimum distance 20 cm between the radiator & your
body.
FCC Statement
Image Layout
Fisheye Len, Glass type
View Angle: H 165/ V90 degrees
F=2.0
Video Compression
H.264/Motion JPEG ( MJPEG)
Resolution: 720 p (25 fps), 360 p (15 fps)
Audio Compression
2-way audio
Built-in omni directional microphone
Built-in 2 Watts speaker
Siren 85 db @ 3 m
Ethernet
IEEE 802.3 10/100 BASE-T
RJ-45 Connector
WiFi
802.11 b/g/n @2.4GHz (2412~2462MHz Ch1~Ch11)
MIMO 2X2
WPS
ZigBee
IEEE 802.15.4 ZigBee @ 2.4GHz (2405~2475MHz)
Coordinator
HA 1.2 or later version
AES 128 bits encryption
Built-in Sensors
PIR Sensor (5 m detection range)
Temperature Sensor
Humidity Sensor
I/O Port
Top push button with Multicolor status RGB LED
SDHC slot
RJ-45 connector
3 buttons inside: RESET, WPS, and Sensor pairing
DC Jack
Power
AC Input: 100~240 VAC @ 50~60 Hz
DC Output: 5 V/2 A
Cable 3M length
Mechanical
Size: 76.5 (D) * 132.5 (H) mm
Weight: 220 g
Temperature
Operating: 0°C ~ 45°C (32°F ~ 113°F)
Storage: -10°C to 50°C (14°F to 122°F)
Humidity
5% to 85% Non-Condensing
Technical Specication