ABUS AZ4130 Service Manual

Terxon MX 8-Zone Wired Extension

Art. no. AZ4130

4-wire bus connection

•
Enables individual identification of detectors (advisable in areas where safety and security are important)

•
Allows clustering in logical areas

•
Minimises cabling work

•

Page 1 of 1

The Terxon MX 8-zone Wired Extension is an extension module for the Terxon MX. Using this module, you can
extend your alarm system by up to 8 wired alarm zones. The 8 zones of the wired expansion are connected to
the motherboard of the Terxon MX via 4-wire bus cables. You can connect up to 3 expansion modules (wireless or
wired) to your existing alarm center. The Terxon MX can thus be expanded to up to 32 zones. The additional
alarm zones are freely programmable and tampering-protected. The type of wiring – NC or DEOL – is left up to
you, but it must be the same for all zones. Via a jumper on the circuit board, you can assign the zones of the
expansion module (9 to 16, 17 to 24 and 25 to 32).

Technical Data:

Dimensions (WxHxD) 128x183x35 mm
Connections 4-wire bus
Number of wired zones 8
Width 128 mm
Housing material ABS
Height 183 mm

Power consumption 30 W
Net weight 0,33 kg
Tamper monitoring Yes
DC voltage supply 12 V
Power consumption 30 mA
Certifications REQ

Length 35 mm

Powered by TCPDF (www.tcpdf.org)

Technical alterations reserved. Misprints and errors excepted. Copyright. © ABUS 01/2020