
Product Description
The L02-01-0107 wall mounted temperature sensor uses a 10K Ohm (Type
III) Thermistor. The 10K Ohm Type III Ther-mistor will provide a predictable output over a specifi ed tem-perature range to meet the required input
value.
The L02-01-0107 should be used in applications where an adjustable setpoint and “After Hours” normally-open override.
Thermistors offer high accuracy and interchangeability over a wide temperature range.
The thermistors higher resistance relative to Platinum RTD’s, creates a
larger signal with the same measuring current, ne-gating most lead wire
resistance problems and eliminating the need for signal conditioners.
This unit is offered in a wall mount confi guration with Setpoint and Override.
The setpoint is a linear 10K slide potentiometer that is Direct Acting, with
a 55 to 85 indication sticker. The override option shorts the thermistor for
tenant override.
L02-01-0107
Wall Mounted Temp. Sensor
w/ Setpoint and Override
Technical Data
Sensor Output • 10K Ohms @ 77oF(25oC) Type III
Temperature Range • -40 to 302oF (-40 to 150oC)
Interchangeability • +/- 0.2oC (0 to 70oC)
Sensor Stability • +/- 0.13oC
Operating Humidity • 0 to 90% RH non-condensing
Setpoint Range • 0 to 10K Ohms +/- 10%
Dissipation Constant • 3 mW / oC
Lynxspring, Inc. 877-649-59698900 State Line Road, Suite 220, Leawood, KS 66206
Please contact Lynxspring for more information about this product
NiagaraAX is a registered trademark of Tridium, Inc.
version: January 3, 2005

Device Detail
L02-01-0107
Wall Mounted Temp. Sensor
w/ Setpoint and Override
Ordering Information
Model # Description
L02-01-0107 Wall Mounted Temperature Sensor with Setpoint and Override
Please contact Lynxspring for more information about this product
Lynxspring, Inc. 877-649-59698900 State Line Road, Suite 220, Leawood, KS 66206
NiagaraAX is a registered trademark of Tridium, Inc.
version: January 3, 2005