Abocom WCP5102 User Manual

802.11b/g MIMO

Wireless LAN PCI Card

Caution

This Quick Installation is meant to help you install the product quickly and
easily. For detailed instructions on installation, configuration, and further
setup options please consult the User Manual.

STEP

Quick Install

11

1

2

3

STEP

22

1

2

Hardware Installation

Make sure the computer is turned off. Remove the
expansion slot cover from the computer.

Carefully slide the Wireless PCI Card into the PCI slot.
Push evenly and slowly and ensure it is properly seated,
you may have to use the mounting screw to have the card
screwed securely in place.

After the device has been installed to your computer, turn
on your computer. Windows will automatically detect the
new hardware.

Software Installation

Exit all Windows programs. Insert the CD-ROM into the
CD-ROM drive of your computer. If the CD-ROM is not
launched automatically, go to your CD-ROM drive (e.g.
drive D) and double-click on Setup.exe

When the main screen appears, click Driver &
Utility installation to continue.

There are two modes for you to choose in this screen,

5

either choose WiFi mode or Performance mode (Tx
Burst mode). This mode selection screen is set for the
default mode shown in the utility screen. You can still
change its mode later in the utility screen. Click Next to
continue.

Click Continue Anyway to proceed with the Installation.

6

When the following screen appears, click Finish to

7

complete the software installation.

When the License Agreement screen appears, please

3

read the contents and then click Yes to continue.

Select the check box to choose a configuration Tool

4

from the listed two choices.
Wireless Configuration Tool: Choose to use our
configuration Utility.
Microsoft Zero Configuration Utility (ZCU).
Click Next to continue.

STEP

Installation Verification

33

To verify if the device exists
in your computer and is
enabled, go to Start

System (Hardware)
Device Manager. Expand

the Network Adapter
category. If the 802.11b/g

MIMO Wireless LAN PCI
Card is listed here, it means

that your device is properly
installed and enabled.

STEP

Utility Configuration

44

All settings are categorized into SIX tabs, including Profile Tab,

Link Status Tab, Site Survey Tab, Statistics Tab, Advanced Tab
and About Tab

Statistics Tab

The Statistics screen displays the statistics on your current network
settings.

Profile Tab

The Profile screen enables you to create, edit, delete, activate,
de-activate and raise/lower priorities of the profiles, which
are used by the station to connect to WLAN networks.

Link Status Tab

The Link Status screen displays the Link Quality, Signal
Strength and some other current linking information.

ARM914

Advanced Tab

The Advanced screen lets you configure the advanced wireless
settings including wireless security settings.

Site Survey Tab

The Site Survey screen displays a list of infrastructure and ad-hoc
networks available for connection.

AboutTab

The About screen displays the basic version information about the

Config Version, Driver Version, EEPROM Version and Firmware

Version.

M73-APO11-230