“When You Need More Than Staples.”
Toll Free: 800-658-8788
Fax: 801-927-3037 info@abcoffice.com
IDEAL CUTTERS
Model 4810 (18-3/4”)
Model 4810-11 (18-3/4”)
Model 5210 (20-1/2”)
1
Safety Rules
∙Ensure that at no time more than one person is working at the machine.
∙Leave the key for the safety lock with the person responsible for the cutting machine.
∙Power operated cutting machines must be operated only by trained and reliable personnel. Part of the training is to become familiar with the operating instructions.
∙The operating instructions must be accessible at any time and must be strictly observed.
∙Do not reach into cutting area while the knife is in operation.
∙Change knife and cutting stick only with the main switch in “off” position. For other maintenance and repair, which requires removal of machine covers, always disconnect the plug.
∙Defects in or damage to cutting machines, which affect the safety, must be repaired immediately. Until such faults have been eliminated, the cutting machine must be put out of operation.
∙Annual routine inspection by specially trained service technicians are recommended for all safety devices, particularly the electrical control measures in the cutting machine. Records should be kept of these safety inspections.
∙Transportation of knives is only allowing specially designed wooden cases supplied by your local distributor. When inserting knife into the wooden case, ensure that the sharp edge lies flush with that side of the case into which the holes for the securing screws have been drilled.
∙IMPORTANT – The safety rules must be strictly observed. Please make sure that you are familiar with the operation of the paper cutter.
Installation
2
The entire machine is dispatched in one package, but the stand (#7) and the hand wheel (#19) for the paper clamp have been dismounted from the machine.
The tool box contains:
-a set of tools for service and maintenance,
-the mounting hardware for the stand,
-the back gauge crank (#3) with a mounting screw,
-two keys for the safety lock.
∙Place machine (#1) on stand (#2).
∙Insert securing bolts for the stand into provided holes and secure with nuts.
∙Place paper tray (#8) into the stand (#7).
∙Mount the hand wheel for the paper clamp (#19) and the crank for the back gauge (#3). Secure these parts with provided screws.
∙Connect power cord with plug to a normal single phase AC socket. The machine is now ready to be operated.
Performance
All paper qualities and light cardboard can be cut using the full cutting height and cutting length of the machine.
|
4810 |
5210 |
|
4810-11 |
|
Cutting Length |
475 mm |
520 mm |
|
(18-3/4”) |
(20-1/2”) |
Cutting Height |
80 mm |
80 mm |
|
(3-1/8”) |
(3-1/8”) |
Table depth |
460 mm |
520 mm |
|
(18-1/8”) |
(20-1/2”) |
Narrow cut |
30 mm |
35 mm |
|
(1-3/16”) |
(1-3/8”) |
Features and Operation
∙Main Switch (#11)
3
Loading...